Product

Clamp-On Multimeter Series

-

Brymen Technology Corporation

Brymen Technology Corporation

An electrical test tool that combines a basic digital multimeter with a current sensor. Clamps measure current. Probes measure voltage.

Product

Signal Conditioners

-

Datexel

Datexel

Datexel has a large range of Signal Conditioners. We manufacture Thermocouple Transmitters, that are either Head Mounted, Din Rail and we even have an OEM version that can fit inside an enclosure smaller than 1" x 1/4". These Temperature Transmitters are PC programmable or DIP Switch programmable. Some are isolated and accept input from various sensors such as RTD's, Thermocouples Voltages, Current, Resistance and Potentiometers. They have current outputs and we even have Temperature converters that have voltage outputs.

Product

Multifunction Substation Test Set

STS 4000

-

Doble Engineering

STS 4000 - Doble Engineering

STS 4000 is a multifunction substation maintenance & commissioning test system for current, voltage and power transformers, designed to perform primary tests requested in substations commissioning. It allows to perform accurate tests on CTs, VTs, PTs and ground grid.

Product

Electronic Ballast Analyzer

WT3000

-

Lisun Electronics Inc.

WT3000 - Lisun Electronics Inc.

• It has 8 windows to display each parameter of input and output characteristics • Frequency response for testing input current up to 1MHz, suitable for precise testing of various kind of electronic ballast • WT3000 has expanding analysis for envelope wave. • Symmetry analysis for envelope wave’s crest factor of lamp current • Sampling at ultra-high speed, dynamic analysis single frequency curve, highest sampling frequency is up to 10MHz • Portable with built-in chip micro-processor, particular suitable for development and spot production • RS-232C standard interface can be connected to PC, English version software can run in WinXP or Win7

Product

Power Tester

PS-200

-

CoolMax Technology Inc.

PS-200 - CoolMax Technology Inc.

It is important to keep your graphic cards powered, but you want to make sure that your graphic cards aren’t overpowered. Not all power supply units have power surge protection, so your graphic cards may be vulnerable to damages from over voltage or over current. Protect your graphic cards now with the new PS-200.

Product

Analog Hipot & Insulation Tester

KT-5000Pi

-

Kast Eng Co. LTD.

KT-5000Pi - Kast Eng Co. LTD.

This is a Hipot(Puncture) Tester combined with Insulation Tester in a set.It tests 2 kinds of test continuously in sequence, and any of both hipot or insulation test can be set to test first in other by the selection switch.Hipot Tester has the leakage current meter, so the operator can check the leakage value while testing. And the preset procedure of the Insulation Tester is very easy. Both tester judge the product to be good or bad automatically in a short time.This tester has many I/O ports to connect extra test system. Price : 2,550 (USD)

Product

Earth Resistance & Resistivity Meter

MRU-21

-

Sonel S.A.

MRU-21 - Sonel S.A.

* earth resistance measurment with 3-pole method, * measurement of continuity of equipotential bondings and protective conductors with auto-zero function - with current 200mA, * resistance measurement using 2-pole method.

Product

DC to 100MHz

1394A

-

Ballentine Laboratories, Inc.

1394A - Ballentine Laboratories, Inc.

Nominal Heater Current: 5 mA rms,Max. Heater Current: 7.5 mA rmsCouple Output: 7 mV ± 12% at nominal heater current.Couple Resistance: 8 W ± 20%.Maximum DC Reversal Error: ± 0.04%Couple Output Voltage to Heater (ground): ± 50 V (dc + acpk-pk) max.

Product

General ELCB Testers

TEL1-x Series

-

Standard Electric Works Co., Ltd

TEL1-x Series - Standard Electric Works Co., Ltd

The TEL1 is the Basic Test Equipment an Electrician cannot do without. TEL1 is a Dual Function Test Instrument utilized to Verify Electrical Wiring Connections and the Functioning of Earth Leakage / Residual Current Detectors devices by forcing the ELCB/RCD to trip.

Product

Logger with Current Clamp0 to 200A AC

TV-4810

-

Gemini Data Loggers Ltd.

TV-4810 - Gemini Data Loggers Ltd.

As well as recording data the unit has a display that shows what the unit is currently reading. The unit has an IP65 case and features high reading resolution and accuracy, a large memory, a fast offload speed and a low battery monitor.

Product

DC Blocks

-

Pasternack Enterprises, Inc.

Pasternack Enterprises, Inc.

A coaxial RF DC block is from Pasternack and has an 50 Ohm impedance. Our 50 Ohm DC block is manufactured with a SMA input and SMA output. This SMA DC block is an inner direct current block type.

Product

Insulation & Earth Resistance Testers

-

KV Hipot Power Test Equipment Co.,Ltd

KV Hipot Power Test Equipment Co.,Ltd

resistance tester is used to measure the resistance of the earth is called Earth Resistance Tester. All the equipment of the system is grounded through the earth electrode. Unhindered earthing protects electrical equipment and personnel from the fault current.

Product

Capacitors - MNOS Series

-

Macom Technology Solutions Holdings Inc.

Macom Technology Solutions Holdings Inc.

MACOM’s MIS capacitors utilize a silicon nitride dielectric over a thermally grown silicon dioxide base. The resultant composite dielectric exhibits low leakage current and insertion loss with excellent long-term stability. The temperature coefficient of capacitance is typically +55 ppm / ºC and is ideally suited for high reliability applications.

Product

Current Measurements Of PWM Or Inverter, AC/DC 1～50A, Φ16mm

CTF-50DC-U24V

-

MULTI MEASURING INSTRUMENTS Co., Ltd.

CTF-50DC-U24V - MULTI MEASURING INSTRUMENTS Co., Ltd.

*AC/DC 1～50A*Current measurements for PWM or inverter

Product

Near Field Probes 30 MHz up to 3 GHz

RF2 set

-

Langer EMV-Technik GmbH

RF2 set - Langer EMV-Technik GmbH

The RF2 near field probe set consists of 4 passive near field probes for measurements in the development phase of the magnetic field in the range from 30 MHz to 3 GHz on electronic assemblies. The probe heads of the RF2 set allow the step by step localization of interference sources of the RF magnetic field on assemblies. From greater distances the electromagnetic interference can be detected by RF-R 400-1 and RF-R 50-1 probes. The RF-B 3-2 and RF-U 5-2 probes with their higher resolution can more precisely detect the interference sources. Field orientation and field distribution on an electronic assembly can be detected through a trained special use of the near field probe. The near field probes are small and handy. They have a sheath current attenuation and are electrically shielded. They can be connected to a spectrum analyzer or an oscilloscope with a 50 Ω input. They do not have an internal terminating resistance.

Product

Lithium Battery Equalization Tester

LIFG-NT

-

Fuzhou Fuguang Electronics Co., Ltd.

LIFG-NT - Fuzhou Fuguang Electronics Co., Ltd.

The LIFG-NT series adopts the latest charging maintenance test technology to detect and equalized charge the lithium battery. It is suitable for daily charging and maintenance of lithium battery packs. The wide voltage design can be applied to all current voltage levels of lithium battery tests.