PCB Piezotronics, Inc.

Product

High Sensitivity Pressure Sensors

-

PCB Piezotronics, Inc.

PCB Piezotronics, Inc.

High sensitivity ICP® pressure sensors are for low pressure measurements requiring excellent resolution and small size. They are used to measure small dynamic hydraulic and pneumatic pressures such as turbulence, noise, sound, and pulsations, especially in adverse environments. They are capable of measuring high-intensity sound pressures from 111 to 210 dB at any static pressure level from full vacuum to 1,000 psi (6,895 kPa).

Product

Miniature Triaxial Accelerometers

-

PCB Piezotronics, Inc.

PCB Piezotronics, Inc.

Miniature triaxial accelerometers are available in a variety of sensitivities to suit specific application requirements. These small and lightweight units have a high frequency response and minimize mass loading on test structures. They are ideal for installation in space restricted locations

Product

General Purpose Single Axis Accelerometers

-

PCB Piezotronics, Inc.

PCB Piezotronics, Inc.

Motion of a rigid body can be characterized within six degrees of freedom. Providing mechanical excitation to simulate this motion as may be encountered in the real world can entail a variety of test machines. There are various pound/force vibration shakers for structural testing. Regardless of the apparatus, the goal is always to ensure that the product under test can adequately perform, and reliably survive, in the environment in which it will be deployed, or to which it will be exposed during transport. PCB® accelerometers provide the measurement signals needed to control the vibratory input and to analyze the product’s reaction to such testing.

Product

Miniature Piezoelectric Accelerometers

-

PCB Piezotronics, Inc.

PCB Piezotronics, Inc.

Structured with highly sensitive piezoceramic sens­ing elements, miniature Ceramic Shear ICP® Accelerometers have an excellent signal-to-noise ratio, high measurement resolution, and are ideal for conducting low-level vibration measurements. Due to their inherent higher sensitivity, a ceramic ICP® accelerometer can be assembled with a smaller mass than comparable quartz units, resulting in a sensor that is lighter in weight, has a higher frequency response, and has a lower noise floor. To further reduce the mass of the sensors, all ceramic shear accelerometers are housed in either tough, lightweight, laser-welded, hermetically sealed, titanium or aluminum housings. By minimizing the mass of the sensor, mass loading effects are reduced, which maximizes the accuracy of the data obtained.

Product

Cable Test Box

-

PCB Piezotronics, Inc.

PCB Piezotronics, Inc.

Cables are a critical part of any sensor measurement system and damaged cables cause frequent delays during test setup. PCB has developed a relatively simple device to test cables on a channel by channel basis for BNC, 10-32, and 5-44 coaxial connectors. Simply connect both ends of the cable and faults will be indicated for shield failure, conductor failure, or short circuit shield to conductor. Power is provided by a single, replaceable 9 volt battery.

Product

S-Type Load Cells

-

PCB Piezotronics, Inc.

PCB Piezotronics, Inc.

S-Type load cells are low-cost and high performance side mounted load cells suitable for a number of weighing and general force measurement applications. They come with a 6-foot strain relieved integral cable with pigtail leads that are stripped and tinned for electrical interface.

Product

PROBE MICROPHONE ICP

377B26

-

PCB Piezotronics, Inc.

377B26 - PCB Piezotronics, Inc.

Open Circuit Sensitivity (at 250 Hz)Frequency Range (+2.2/-4.9 dB)2 to 20000 HzLower Limiting Frequency (-3 dB)Inherent Noise<45 dB(A) re 20 Pa Dynamic Range(3% Distortion Limit)EnvironmentalTemperature Range (Operating)-40 to +158 F-40 to +70 C[5]

Product

Conformal Ballistic Pressure Sensor

Model: 117B67

-

PCB Piezotronics, Inc.

Model: 117B67 - PCB Piezotronics, Inc.

Conformal ballistics pressure sensor, 22 WMRF, 22 WRF, 22 WRF WITH 0.50" Centerline, 17 RF Mag, 17 HMRConformal ballistics pressure sensor for 17 HMR, 17 Magnum RF, 17 RF Magnum, 22 WMRF, 22 WRF, and 22 WRF with 0.50" centerline caliber cartridges.

Product

3-Component Quartz Force Rings

260 Series

-

PCB Piezotronics, Inc.

260 Series - PCB Piezotronics, Inc.

Three-component quartz force ring sensors are capable of simultaneously measuring dynamic force in three orthogonal directions (X, Y, and Z). They contain three sets of quartz plates that are stacked in a preloaded arrangement. Each set responds to the vector component of an applied force acting along its sensitive axis. 3-component ring force sensors must be statically preloaded for optimum performance. Preloading provides the sensing elements with the compressive loading required to allow the proper transmission of shear forces. Versions are available with ranges up to 10k lb (45k N) in the z-axis (perpendicular to the top surface), and up to 4000 lb (18k N) in the x-and y (shear) axes. Both ICP® and charge output styles are available.

Product

Accelerometers

353B15

-

PCB Piezotronics, Inc.

353B15 - PCB Piezotronics, Inc.

Sensitivity: (10 %);10 mV/g 1.02 mV/(m/s) Measurement Range:500 g pk 4905 m/s pk Frequency Range:(5 %)1 to 10000 Hz1 to 10000 Hz Frequency Range:(10 %)0.7 to 18000 Hz 0.7 to 18000 Hz Frequency Range: (3 dB)0.35 to 30000 Hz0.35 to 30000 Hz Resonant Frequency:70 kHz,70 kHz Broadband Resolution (1)0.005 g rms0.05 m/s rmsNon-Linearity:1 %1 % Transverse Sensitivity:5 %5 %

Product

Accelerometers

356A02

-

PCB Piezotronics, Inc.

356A02 - PCB Piezotronics, Inc.

Sensitivity (10 %)10 mV/g1.02 mV/(m/s) Measurement Range:500 g pk4900 m/s pk Frequency Range: (5 %)1 to 5000 Hz1 to 5000 Hz Frequency Range: (10 %)0.5 to 6000 Hz0.5 to 6000 Hz Resonant Frequency:25 kHz 25 kHz Broadband Resolution (1)0.0005 grms 0.005 m/s rms Non-Linearity: (400 g, 3920 m/s)1 % 1 % Non-Linearity (500 g, 4900 m/s)2 % 2 % Transverse Sensitivity:5 % 5 %.

Product

Miniature Electrodynamic Shakers

-

PCB Piezotronics, Inc.

PCB Piezotronics, Inc.

Miniature electrodynamic shakers are small, portable units designed to simplify your vibration testing needs. From the SmartShaker™ with an integrated amplifier, to an Inertial Shaker System for testing in hard-to-reach areas, mini shakers offer flexibility when testing. Miniature shaker systems range from 2 lbf (9 N) to 7 lbf (31 N) sine peak force excitation.

Product

Conformal Ballistic Pressure Sensor

Model: 117B44

-

PCB Piezotronics, Inc.

Model: 117B44 - PCB Piezotronics, Inc.

Conformal ballistics pressure sensor, 243 Win, 260 Rem, 30-07, 308 Win (7.62 x 51 NATO), 338 Federal, 358 Win, 375 JDJ, 38-40 Winc, 44 S & W Special, 444 Marlin, 7.5 x 54Conformal ballistics pressure sensor for 243 Winchester, 260 Remington, 30-07, 308 Winchester (7.62 x 51), 338 Federal, 358 Winchester, 375 JDJ, 38-40 Winchester, 44 Smith & Wesson Special, 444 Marlin, 7.5 x 54 MAS, and 7 mm -08 Remington caliber cartridges.

Product

Low Noise Prepolarized Microphone

378A04

-

PCB Piezotronics, Inc.

378A04 - PCB Piezotronics, Inc.

The 378A04 is a matched system that is comprised of a high sensitivity microphone and a low noise preamplifier that contains a built-in filter that enables the free-field response to remain flat over a wide frequency range. The system requires a minimum of 4 mA and measures to 6.5 dBA (5.5 dBA typical) within a cost efficient, prepolarized (0V) design. PCB's model 378A04, the industry's first prepolarized low noise microphone and preamplifier system allows you to measure extremely low amplitudes. In the past this was only possible with externally polarized solutions. With a typical noise floor of 5.5dBA, this microphone system delivers all of the benefits commonly associated with prepolarized systems.

Product

Acoustics

-

PCB Piezotronics, Inc.

PCB Piezotronics, Inc.

When it comes to selecting a microphone for product tests—whether for sound power, sound quality, or noise source location—there's no need to compromise to sacrifice quality or performance for affordability.