Product

3 Wire (Digital) Earth Resistance Tester

ST-1520

-

Standard Electric Works Co., Ltd

ST-1520 - Standard Electric Works Co., Ltd

● Capable of measuring earth resistance and earth voltage.● 2mA measuring current permits the testing of earth resistance without tripping earth leakage current breakers in the circuit under test.● Auto power off function.● The timer operates automatically for about three to five minutes when the "PUSH BUTTON SWITCH" and "TIMER ON BUTTON" are pressed together. This will keep test "ON" for the duration of the timer.● Timer for test function (count 3-5 minutes).● Battery operated.● Data hold function.● Small and light weight.● Calibration performed with supplied test leads.

Product

Gauge Type T Thermocouple Wire

W-TW-40P2

-

Physitemp Instruments

W-TW-40P2 - Physitemp Instruments

Most thermocouple wire used in the manufacture of sensors is "Special Limits" wire which, to meet NIST standards, must be accurate to 0.5°C in the range 0-50°C. This means that even with most sophisticated electronics, the best possible accuracy for the system is 0.5°C.

Product

1 Ft Harness, 78-Pin Male Connector On One End, Loose Wired (Numbered) Other End

GT97103

-

Marvin Test Solutions, Inc.

GT97103 - Marvin Test Solutions, Inc.

1' harness, 78-pin male D-sub connector on one end, loose wired (numbered) other end.

Product

Fault Finder for Electrical Wiring Open / Short Circuit

FF310

-

General Technologies Corp.

FF310 - General Technologies Corp.

42 V Ready: for use in the new generation of vehicles with mixed or single 42 Volt systems. Operates on DC voltages from 6 to 42 volts. Internally protected against power surges and overloads. 8" flexible probe allows reaching wires in congested places. Transmitter and Receiver LEDs show open or short circuit conditions.

Product

K-Type Thermocouples Wire, Fiberglass (32 deg F to 900 deg F) 1 m

745690-K001

-

NI

745690-K001 - NI

K-Type Thermocouple, 32°F to 900°F Temperature Sensor - The K-Type Thermocouple works with NI measurement devices and software to help you acquire temperature data within a measurement system. You can use LabVIEW or FlexLogger software and NI-DAQmx driver software to configure measurements and predefined scaling coefficients for the K-Type Thermocouple and acquire synchronized temperature data in units of degrees. The K-Type Thermocouple is available in various lengths and configurations including field-cuttable, ready-made sensors, and thermocouple wire extensions with a -20°F to 221°F temperature range.

Product

Vibrating Wire Peripherals

-

Campbell Scientific, Inc.

Campbell Scientific, Inc.

Many Campbell Scientific vibrating-wire peripherals enable dataloggers to read vibrating-wire sensors (also known as vibrating-wire or vibrating-strip transducers). These sensors measure strain, load, pressure, and water level, and they output a frequency signal generated by a vibrating filament. Campbell Scientific also offers vibrating-wire dataloggers that read the sensors directly.

Product

3 Wire (Analogue) Earth Resistance Tester

2105 ER

-

Standard Electric Works Co., Ltd

2105 ER - Standard Electric Works Co., Ltd

● Capable of measuring earth resistance and earth voltage.● 2mA measuring current permits the testing of earth resistance without tripping earth leakage current breakers in the circuit under test.● In addition to facilitating for precision measurement, test leads for simplified two-wire measuring system also are supplied as standard accessories.● Battery operated.● Battery life indicator. ● Calibration performed with supplied test leads.

Product

Probes With Lead Wires

-

Omega Engineering, Inc

Omega Engineering, Inc

Used when the probe is installed some distance from the logger, controller, or other data acquisition device. Available in a variety of lead wire types with stripped leads or connectors attached.

Product

Mating Coax Connector and 20 Coax Pins Crimped (both ends) to 5' wires

GX96405-60

-

Marvin Test Solutions, Inc.

GX96405-60 - Marvin Test Solutions, Inc.

Mating coax connector and 20 coax pins crimped (both ends) to 5 ft wires

Product

C/I Tracers

-

Greenlee Tools

Greenlee Tools

*Advanced bi-directional sensing technology*Superior sensitivity and functionality providing for accurate tracing and locating*Ergonomic receiver with information-rich full-color graphical LCD*Visuals and audible signal provide quick and easy to understand tracing feedback*Traces concealed wiring, locates junction boxes, and finds breakers for live or open circuits*Locates and identifies blown fuses*inds shorts and breaks in conductors

Product

IEC60695-11-2 Single Wire And Cable Vertical Burning Tester

CX-D12

-

Shenzhen Chuangxin Instruments Co., Ltd.

CX-D12 - Shenzhen Chuangxin Instruments Co., Ltd.

It’s strictly designed according to IEC60695-11-2, IEC60332-1, GB/T18380.11-2008, GB/T18380.12-2008 etc. Stainless steel screen with a sliding burner handle support for approaching or movingback the flame from the sample under test according to the CEI standards for test on cables.

Product

Vibrating Wire Dataloggers

-

Campbell Scientific, Inc.

Campbell Scientific, Inc.

Vibrating-wire dataloggers have the built-in capability to measure vibrating-wire sensors. These dataloggers use patented spectral analysis technology.

Product

Wire Crimp Pull Sensor

Model MR06-200

-

Mark-10 Corp.

Model MR06-200 - Mark-10 Corp.

The MR06-200 wire crimp pull sensor is a hand-operated solution for measuring wire crimp pull-off forces. The ergonomic handles and convenient tensioning mechanism make field measurements a breeze for applications up to 200 lbF (1,000 N). Squeeze the handles together to increase tension on the sample until a break occurs. The peak force is recorded by a Mark-10 indicator. A rotating turret with slots of multiple sizes accommodates a wide range of wire diameters, up to 0.25 in. (6.4 mm).

Product

K-Type Thermocouples Wire, Fiberglass (32deg F to 900deg F) 2 m

745690-K002

-

NI

745690-K002 - NI

K-Type Thermocouple, 32°F to 900°F Temperature Sensor - The K-Type Thermocouple works with NI measurement devices and software to help you acquire temperature data within a measurement system. You can use LabVIEW or FlexLogger software and NI-DAQmx driver software to configure measurements and predefined scaling coefficients for the K-Type Thermocouple and acquire synchronized temperature data in units of degrees. The K-Type Thermocouple is available in various lengths and configurations including field-cuttable, ready-made sensors, and thermocouple wire extensions with a -20°F to 221°F temperature range.

Product

Wire And Cable

-

Chengdu Mengsheng Electronics Co., Ltd.

Chengdu Mengsheng Electronics Co., Ltd.

We provide a variety of wire and cable products, including insulated wires, power cords, stranded wires, solid wires, wiring harnesses and connectors. Our products are widely used in security, medical, communications, instrumentation, medical, home appliances, auto parts, military, aerospace and other industries. Our products strictly comply with the product certification standards of countries and regions such as UL in the United States, VDE in Germany, CE in the European Union, and BS in the United Kingdom.

Product

Drawing Die And Wire Measurement

Wire Diameter And Roundness Measurement

-

Optik Elektronik Gerätetechnik GmbH

Wire Diameter And Roundness Measurement - Optik Elektronik Gerätetechnik GmbH

The DGMS is a measuring system for diameter and roundness of wires, drawing dies and enameling dies. The wire diameter is measured highly accurate by an image processing system. To measure the roundness, an additional special holder is necessary to rotate the wire for the diameter measurement in several azimuths. The accuracy of the measurement is ‹1micron.