Combiners
-
Product
Autoranging System DC Power Supply, 200 V, 210 A, 15000 W, 208 VAC
N8932A
DC Power Supply
The Keysight N8900 Series is a family of 5 kW, 10 kW, and 15 kW autoranging, single-output power supplies available in 14 different voltage, current, and power combinations and either 208 VAC or 400 VAC (28 total models).
-
Product
Quantum Accelerometer
-
A quantum accelerometer uses atom interferometry to measure accelerations along a horizontal axis. Quantum accelerometers are able to achieve a combination of sensitivity and stability by exploiting quantum interference. As such, they will be critical components of a quantum inertial navigation unit, which will offer satellite-free navigation with unparalleled long-term accuracy. A phase locked SolsTiS system underpins this setup and provides the extremely low phase noise required to make high sensitivity measurements and dynamic frequency tunability to address multiple atomic transitions.
-
Product
Intermittent Fault Detection & Isolation System
IFDIS
-
The IFDIS™ uses patented Intermittent Fault Detector technology that simultaneously and continuously monitors every circuit path within a Unit Under Test (UUT) - such as a Line Replaceable Unit (LRU) chassis' interconnects - for intermittent continuity failures that occur for as short as 50 nanoseconds. This state of the art technology is combined with an environmental chamber and vibration table, which simulate the UUT’s operational environment and cause intermittent faults to manifest, creating a system that is unsurpassed in intermittent fault detection.
-
Product
Scanning XPS/HAXPES Microprobe
PHI Quantes
-
The PHI Quantes is the only commercially available automated, high-throughput lab-based HAXPES spectrometer. It is a unique scanning X-ray photoelectron microprobe that combines a high energy (HAXPES) monochromatic X-ray source (Chromium Kα) with a conventional monochromatic soft X-ray source (Aluminum Kα). Both sources are high flux focused X-ray beams that can be scanned across the sample surface and can be used to define analysis points, areas, lines, and maps with 100% confidence.
-
Product
Rotman Lens Designer
-
Rotman Lens Designer (RLD) is a software tool for the design, synthesis, and analysis of Rotman Lenses and their variants. It is based on Geometrical Optics combined with the classical Rotman Lens design equations. It is intended for rapid development and analysis of Rotman Lenses given several physical and electrical input parameters. RLD generates the proper lens contours, transmission line geometry, absorptive port (dummy port) geometry, provides an approximate analysis of performance, and generates geometry files for import into Remcom's XFdtd® for further analysis and fabrication.
-
Product
Speed Sensors
-
*2 in 1: speed sensor and evaluation in one compact housing*Space-saving design*Inductive or magnetic sensor principle*Flexible combination of housings, connections and output signals
-
Product
Unclamped Inductive Load Tester
ITC55100C
-
The system has been designed around a very powerful micro-controller that gives it a timing resolution of 40ns, twenty times faster than the previous model. Its response time to the peak and zero current is improved ten times. Combined this gives greater accuracy for the charging and avalanche times and for the reported peak drain current.
-
Product
Getac Tablet
F110
-
The award-winning F110 is a true revolution in rugged tablet computing. The F110 combines class-leading performance, industry-leading security, a large 11.6” widescreen display and a thin and light design that redefines rugged mobility. Designed to be about the size of a typical piece of paper, the new F110 rugged tablet breaks new ground with its large 11.6” display, cutting-edge Intel® Core™ processor, amazing graphics and dual batteries. Instead of one single removable battery, we built the F110 to have two hot-swappable batteries for potentially infinite, uninterrupted battery life.
-
Product
8-bit Digitizers
ADC6000
-
Guzik AXIe ADC 6000 Series Digital Acquisition and Processing Modules combine high-speed waveform digitizer with built-in digital signal processing hardware, which enables mixed-domain signal capture and analysis with high-speed data transfer link to a computer. The ADC 6000 Modules come in a space-saving display-less 1U 19” AXIe modular form factor.
-
Product
CAD/CAM Software
C-LINK DTM
-
C-LINK DTM is the interface between CAD, test and repair, and combines these into one platform. Our CAD/CAM software has since its introduction in 1985 developed into the leading standard tool. C-LINK supports virtually every test system on the market.
-
Product
Sanitary Magnostrictive Level Transmitter
DM330S
-
The Drexelbrook DM330S is a sanitary magnetostrictive level transmitter providing Triclover fittings as standard mountings. It is authorized by 3A Sanitary Standards Council for level applications in the food and beverage industries.The DM330S takes field proven sensing technology and incorporates intrinsic safety with a field programmable zero and span.The two wire loop powered level transmitter is configurable with a 4-20 mA span and is not affected by changes in electrical characteristics.It uses proven machine tool positioning accuracy combined with a process compatible float to offer a liquid level, and interface measurement system for the process industry.
-
Product
Ultrasonic Optical Flaw Detector
MIV-X
-
Thanks to Shimadzu’s proprietary light imagining technique, which combines an ultrasonic oscillator with a stroboscope, defects near the surface of a material, including peeling of the bonding and adhesive surfaces of heterogeneous materials, as well as paint, thermal sprays, and coatings can be inspected easily and non-destructively.
-
Product
Standalone with Drop-In Test Systems
800 Series ATE
-
The Circuit Check 800 Series ATE provides the versatility of utilizing the economical drop-in fixturing present in the 600 Series or an integrated dedicated fixture, while simultaneously providing the increased test equipment capacity of the 1000 Series. This combination produces a cost effective full turnkey test solution.
-
Product
Analysis System
Trident (EDS-EBSD-WDS)
-
The Trident Analysis System combines the latest advances in Energy Dispersive Spectroscopy (EDS), Electron Backscatter Diffraction (EBSD), and Wavelength Dispersive Spectrometry (WDS) in a single analytical tool. With the Smart Features included in the easy to use EDAX analysis software, each technique can be optimized and used independently or they can be combined to provide seamless integration, resulting in comprehensive data collection that can then be shared between the different techniques.
-
Product
HydroRANGER Series
-
The HydroRANGER is an evolution of mapping technology. This Airborne Topo-Bathymetric (ATB) system provides dual purpose topographic and bathymetric measurements for full scene mapping of shoreline systems. Utilizing a visible green spectrum laser with an elliptical scan pattern and measurement rates up to 200 kHz, the HydroRANGER provides a combination of high spatial resolution and spatial accuracy.
-
Product
PCIe 16 Bit Arbitrary Waveform Generator - up to 40 MS/s on 4 Channels
M2P.6536-X4
Arbitrary Waveform Generator
The M2p.65xx series offers different versions of arbitrary waveform generators for PCI Express with a maximum output rate of 125 MS/s. These boards allow to generate freely definable waveforms on several channels synchronously. With one of the synchronization options the setup of synchronous multi channel systems is possible as well as the combination of arbitrary waveform generator with digitizers of the M2p product family. The 512 MSample on-board memory can be used as arbitrary waveform storage or as a FIFO buffer continuously stream data via the PCIe interface. Importantly, the high-resolution 16-bit DACs deliver four times the resolution than AWGs using older 14-bit technology.
-
Product
LiDAR Remote Sensing Payload Instrument
RESEPI™
-
Engineered for partners and resellers in the remote sensing industry, the Remote Sensing Payload Instrument, or RESEPI™, is a combined Dual Antenna GNSS-Aided Inertial Navigation System, datalogger, LiDAR, camera, and communications system that allows for the real-time and post-processed generation of point cloud solutions. The processing platform contains a WiFi interface, an embedded cellular modem to support RTCM corrections, data logging software, and gigabit ethernet. RESEPI™ can be used with commercially available LiDARs like Velodyne, Quanergy, Ouster, RIEGL, LIVOX, and Hesai. The device was built with the purpose of white labeling.
-
Product
4 Digit LCD Data Display
DDM 4
-
The DDM 4 is a low power 4 digit data display module with 12.5mm (0.5") digit height. Inputs are CMOS and TTL compatible. Using three inputs Clock, Data In and Load, it is possible to display 0 to 9 and A to F or any other combination of the segments. The display can be panel mounted using the bezel and window
-
Product
Smart Optimization
-
A reflow oven or wave solder machine is capable of literally billions of alternative setups. Each combination of zone temperatures and conveyor speed will produce a unique profile for a processed product. KIC's software makes an exhaustive analysis of all the setups and it recommends the very best oven/machine recipe within seconds.
-
Product
Squid Carrier Board™ Family PCI Express Gen 3 Carrier Board for six M.2 or NGSFF (NF1) PCIe SSD Modules
SKU-086-36
-
This Squid PCIe Carrier board can support up to six M.2 or NGSFF (NF1) PCIe SSD (solid state drive) modules, with M-key. Supported module dimensions are 2280 or 22110 in length, and a width of up to 32 mm. SSD modules of any capacity may be used, from any vendor, and in any combination.
-
Product
Data Logger with GSM/GPRS Module
HD33M-MB.2
-
GSM/GPRS data logger. RS485 MODBUS-RTU input, additional contact input for rain gauge. Great to combine with HD52.3D and HD51.3D series anemometers!
-
Product
Standard Normally Open
-
Is an optically coupled element that combines a GaAs infrared LED on the input side with anormally-open MOS FET on the output side to realize an excellent cost performance.The small, thin package and high sensitivity of this element makes it ideal for battery-driven mobile devices, and its small offset voltage at power-on and good linearity are also make it suitable for controlling micro analog signals.
-
Product
Covermeters & Half-Cell Meters
331
-
The Elcometer 331 is an all in one gauge that combines the rebar locator, concrete covermeter and half-cell measurement, making site visits quicker and more convenient.
-
Product
Trident Fiber-Optic Probes
Fiber-optic Probe
Our most popular and cost-efficient option for the test of multiple LEDs — testing three LEDs with a single Sensor. This method of testing LEDs scales up, so that testing 3, 30, 300 — or any number of LEDs — is far more cost-efficient than other methods. This is our most popular Fiber-optic Probe and can be combined with any of our Universal LightProbe Sensors.
-
Product
3GHz Four Channel Signal Generator 19" 1U Rack Module
LS3084R
Signal Generator
The LS3084R, 3GHz four channel RF Analog Signal Generator, offers industry leading performance, in a 1U, 19” space efficient, rack-mounted box. The LS3084R features four phase coherent channels, exceptionally fast switching speed, superior signal integrity and purity and all the necessary modulated signals for analog communication systems. The LS3084R was designed to offer excellent performance and abilities combined with an affordable price tag, needed from the R&D benches to the production lines.
-
Product
Combined Illumincance and Irradiance Probe
LP471P-A
-
Combined probe for measuring ILLUMINANCE (lux), with standard photopic response, and IRRADIANCE (μW/cm²) in the UVA spectral range (315…400 nm, with peak at 360 nm).
-
Product
PRO+ 2-in-1 pH and Temperature Meter
MW102-FOOD
-
The Milwaukee MW102 PRO+ Food pH meter has won fans around the world with its reliable, fast and simple operation as well as its toughness and accuracy. The MW102 Food pH meter combines the power of the MW102 meter with the specialist capabilities of the MA920B/1 Direct Measurement Food Grade pH Probe.
-
Product
Laser Rangefinder Binoculars
LRB 3000 PRO
-
Medium range laser rangefinder binoculars LRB 3000PRO and LRB 4000CI incorporate the latest achievements in optronics, laser technology and electronics in their design. These binoculars combine uncompromised optics with advanced data processing algorithms. Both models instantly measure distance and speed using the highly accurate time-of-flight delay method.
-
Product
Industrial pH Meter (Four-Wire Analyzer)
HP-200-K
-
One-touch calibration function Realizes gentle measurement by combination with lead-free ORP electrode
-
Product
ATE
QT 200 NXG
-
Qmax Test Technologies Pvt. Ltd.
QT 200 Nxg a Highly sophisticated ATE, is now available as a desktop unit with the cost, flexibility, and performance demanded by a large number of users in research, design, manufacturing, and repair & maintenance industry. It is a combinational-mixed signal board tester for PCBAs designed to cater the needs of PCB test and repair depots, keeping in mind the changing PCB technology and challenges in testing them offline with the combination of all such complex test methodologies in a single test hardware platform with simple to use graphical user interface software.
