Filter Results By:
Products
Applications
Manufacturers
MW
Electomagnetic waves with wavelengths longer than those of infrared light. Frequencies range from 1 GHz to 300 GHz.
See Also: Microwave, RF, Millimeter Wave
-
product
Plug-On Transmitter
DPR
This unique plug-on transmitter design will ideally match any microphone or line level source via a standard XLR connector. The DPR can tune in 100 kHz or 25 kHz steps across the UHF television band from 470.100 to 607.950 MHz, with a selectable output power of 25 or 50 mW. The purely digital architecture utilizes AES 256-CTR encryption for high level security applications.
-
product
S-band Klystron 2.45 GHz / 5 MW
Insight Product Co. 's S-band, 2.45 GHz, klystron provides up to 5.0 MW of output pulse power.
-
product
Reduced Voltage Motor Starting Panels by Reactors
A method to limit motor starting current is a series reactor. Iron core or air core reactors can be used for starting purposes. If an air core is used for the series reactor then a very efficient and reliable soft starter can be designed which is more suitable for high MW ratings of synchronous/induction motors at MV levels. The reactors are designed with taps.
-
product
Wideband Transmitter
SMWB
To meet the demands for a variety of RF environments and applications, the “WB” series SM transmitters offer selectable output power of 25, 50 and 100 mW (25 and 50 mW for export versions). With higher power output, the operating range is improved, or, a more secure link can be relied upon for high RF noise environments. Battery life is unchanged with the different RF power selections.
-
product
Belt-Pack Transmitter
SMV
To meet the demand for both extended operating range and extended battery life, the "V" series SM transmitters offer selectable output power (See specific model data sheets for details). A third selection at 50 mW is provided for some theatrical applications where the system design specifies lower transmitter power.
-
product
Average Reading Directional RF Wattmeter
81000-A
The Model 81000-A Wattmeter ... now you can measure RF Power in 50-Ohm coaxial cable and transmission lines, and accept plug-in elements in the range of 100 mW to 10 kW full scale, and from 0.45 to 2300 MHz.
-
product
Laser
BDS-SMY Series
*Pulse Width Down to 50 ps*Repetition Rate 50 MHz (20 MHz Available on Request)*Free Beam or Fiber Output*CW-Equivalent Power 0.3 mW to 0.5 mW*All Electronics Integrated*No External Driver Unit*Simple +12 V Supply*40 mm x 70 mm x 120 mm
-
product
Amplifiers
We have designed and manufactured amplifiers using all major semiconductor materials, LDMOS, GaN, GaAs, and InP, to produce narrow, wideband, and pulse, receive and transmit amplifiers from 1 MHz to 220 GHz and power levels from mW to over 10 kW.
-
product
VDI - Erickson Power Meters
The VDI Erickson PM5 Power Meter is a calibrated calorimeter-style power meter for 75 GHz to > 3 THz applications. It offers power measurement ranges from 1 W up to 200 mW. The PM5 is the de facto standard for > 100 GHz power measurement.
-
product
Thin Film Lithium Tantalate (TFLT™) Pyroelectric Detectors
For room temperature measurement of THz sources, from nW to mW.
-
product
Laser
BDS-MM Series
*Pulse Width Down to 60 ps*Repetition Rate 20 MHz / 50 MHz*Free Beam or Fiber Output*Optical Power Up to 40 mW*All Electronics Integrated*No External Driver Unit*Simple +12 V Supply*40 mm x 70 mm x 120 mm
-
product
Panel Mount Wattmeters
The Coaxial Dynamics series of Panel Mount Wattmeters are designed to measure RF power in 50-Ohm coaxial cable and transmission lines, and accept plug-in elements in the range of 100 mW to 10 kW full scale, and from 0.45 to 2300 MHz
-
product
W-band Transmitter (94 GHz, 50 MW Output Power)
W-band Transmitter (94 GHz, 50 MW Output Power)
-
product
RF Frontends
Becker Nachrichtentechnik GmbH
Software-Defined Radio (SDR) is an attractive approach for mobile communication architectures in the development and evaluation phase for a rapid prototyping on a flexible platform. SDRs support a wide frequency range. However, for practical use in the field the HF properties are insufficient. The transmit power is limited to a 2-digit mW value. Dedicated filters are required for an effective suppression of out-of-band signals and to improve the noise figure of the receiver chain. Extending SDRs with application-specific RF-frontends achieves optimal RF performance in the field.
-
product
Manpack MW Antenna
TGR-50 class
The TGR-50 class of rapidly deployable AM antennas is designed for easy transport and erection by limited personnel. No tower climbing or sophisticated lifting equipment are required for installation by a crew of three or four persons. Weight and packaging, according to model, typically permits transport by bearers, light vehicle, small boat, or helicopter. Disassembly and relocation is similarly convenient.
-
product
Belt-Pack Transmitter
SMQV
To meet the demand for both extended operating range and extended battery life, the "V" series SM transmitters offer selectable output power (See specific model data sheets for details). A third selection at 50 mW is provided for some theatrical applications where the system design specifies lower transmitter power.
-
product
Compact Fiber Seeders
LightWire FPS Series
LightWire FPS series fiber lasers are dedicated for seeding solid state Nd:YAG amplifiers. Compact, cost efficient FPS series models deliver sub‑10 ps pulses at 1064 nm wavelength with the average output power up to 200 mW and pulse energy up to 50 nJ.
-
product
Amplifiers
We have designed and manufactured amplifiers using all major semiconductor materials, LDMOS, GaN, GaAs, and InP, to produce narrow, wideband, and pulse, receive and transmit amplifiers from 1 MHz to 220 GHz and power levels from mW to over 10 kW.
-
product
CW IMPATT DIODES FROM 30 TO 140 GHz
Insight Product Company offers IMPATT diodes with CW power up to 400 mW and operational frequency range up to 140 GHz. Silicon p+-p-n-n+ IMPATT diodes are designed to be used in the millimeter wave oscillators and amplifiers. They are fabricated in the metal-ruby packages with hard-lead carrier (diameter 3.0 mm, 1.5 mm).
-
product
S-band Klystron 3 GHz/3MW
Insight Product Co. 's S-band, 3 GHz, klystron provides up to 3.0 MW of output pulse power.
-
product
Extreme Low Power Detector Laser Power Meters
11XLP12
11XLP12 extreme low power detector is best suitable for low power im both the µW and mW regimes with very low thermal drift. Featuring broadband flat spectral response, minimal thermal drift and a noise equivalent power as low as 1 µW the 11XLP12 is ideally suited for measuring any pulsed or CW low power laser.
-
product
AccuDyne™ AC Dynamometer Systems
SAKOR Technologies offers the AccuDyne™ series of AC motoring dynamometers. These 4-quadrant dynos offer full motoring as well as loading capabilities. AccuDyne dynamometers can be used for testing active components such as engines and electric motors as well as passive components such as transmissions, generators and alternators. AccuDyne dynamometers are available in models from 5 kW through 3 MW. SAKOR Technologies configures each AccuDyne system to meet customer-specific requirements.
-
product
Optical Power Meter
RA3209
Radiasun International Group Ltd.
Portable optical power meter is an accurate and durable handheld meter designed for the installation, operation and maintenance of optical fibre network. Portable optical power meter is a compact device with backlight switch and auto power on-off ability. Besides, portable optical power meter provides ultra-wide measurement range, high accuracy, user self-calibration function and universal port. In addition, portable optical power meter displays linear indicators (mW) and non-linear indicators (dBm) in one screen at the same time.
-
product
Terahertz (THz) Lasers From 0.89 To 2.52 THz
Insight Product Company offers terahertz lasers at frequencies from 0.89 to 2.52 THz. Output power is from 1 mW to 15 mW. Diameter of the output wave beam is ~ 40 mm. Typical sizes is 1.2x0.3x0.4 m. Transformer from quasi-optical output to the standard wave guides can be provided. The energy pumping is provided either by DC discharge or HF discharge.
-
product
Generators From 30 To 110 GHz
MHP Series
Insight Product Company offers powerful mm-wave sources with CW power up to 400 mW and central frequency up to 110 GHz.
-
product
SP3T RF Pin Diode Switches To 18 GHz
Pulsar Microwave manufactures 3-way absorptive and reflective switches for use in 50-ohm systems. These SP3T switches operate from 100 MHz to 18 GHz and handle 200 mW input power. VSWR performance is often 1.6:1 or better with 100 ns switching time. Minimum isolation of 60 dB is specified for most units. Absorptive and reflective switches require +5V and -5V power supply to function. Control logic is from 0 to +5 volts. All voltage and ground connections are made by feed thru and turret terminals, respectively.
-
product
S-band Klystron 2.856 GHz / 6 MW
Insight Product Co. 's S-band, 2.856 GHz, klystron provides up to 6.0 MW of output pulse power, and has two regimes of operation.
-
product
MOCVD Systems
TurboDisk Family
A rapidly developing technology with multiple proof-of-concept scale installations (1 MW or less), with many more larger-scale projects gaining momentum worldwide within regions with high direct normal irradiance (DNI). As/P MOCVD is proving to be the technology of choice in building the critical compound semiconductor layers for CPV devices. Veeco, supplying best-in-class MOCVD equipment, provides the critical enabling As/P MOCVD technology to reduce the production costs of triple junction solar cells and provides manufacturers with the ability to easily ramp production in a modular system with unmatched reliability and throughput at the lowest cost.
-
product
Miniature Fluxgate Magnetometer
WFG-110
The Model WFG-120 System is a complete 3 axis fluxgate magnetometer packaged in a rectangular/parallelpiped package of dimensions 0.75\" x 0.75\" x 2.75\". The package corners are rounded to enable the unit to fit inside a 1.0\" diameter cylinder. The system operates from one of two optional input voltages: regulated ±5 VDC or unregulated ±7 to ±12VDC and consumes a total power of 200 mW.
-
product
SP16T RF Pin Diode Switches To 10 GHz
Pulsar Microwave's 16-way switches cover 500 MHz to 10 GHz in single pole, 16-throw configuration. Maximum input power is 200 mW and switching time is 100 ns. SMA female connectors are standard. A 15-pin D-SUB male connector makes the internal connections to the power, ground and logic circuitry. Switching control is TTL with the option of line drivers and decoders.
