Switches
enable on off function or change of direction.
See Also: Membrane Switch, Coaxial Switches, Crossbar, High Voltage Switching, Fiber Optic Switching, Microwave Switching, Optical Switch
-
Product
PXI 2 Amp Multiplexer, Dual 8-Channel, 4-Pole
40-635A-007
-
The 40-635A-007 is a dual 8-channel, 4-pole MUX and is part of a range of Multiplexer modules available in 9 standard density and 9 half density configurations, all using high quality electro-mechanical signal relays allowing each channel to switch current up to 2A and voltage up to 300VDC/250VAC. The module is suitable for signal routing in ATE and data acquisition systems. Connections are made via a front panel 78-way D-type connector.
-
Product
Vibration Measuring System
SmartVibro
-
There are many functions to express characteristics of vibration. However it is necessary for the conventional vibrometers that the same point is measured plural times switching objective functions one by one. SmartVibro which has a simultaneous measurement function can measure Acceleration, Velocity and Displacement simultaneously by just pressing the measurement start key one time. It can reduce the operating time and prevent miss-measurements. By switching the screen, VM-4424S・VM4424H can confirm Acceleration Envelope for bearing condition which enables small scars to be found easily.
-
Product
LXI Microwave Multiplexer, 50Ω 6-Channel 9-Bank 26.5GHz SMA
60-801-309
-
The 60-801-309 is a 6-channel, 9-bank RF multiplexer suitable for switching 50Ω signals up to 26.5GHz. It is part of Pickering Interfaces’ range of LXI Microwave Multiplexers which are available with bandwidths between 6GHz and 40GHz and support for 4, 8 12 or 16 banks of 4 or 6-channel multiplexers. It is ideal for constructing complex microwave switching systems for many applications. Connection is by high performance front panel mounted SMA or SMA-2.9 connectors.
-
Product
Full-function Top-class Self-heal Circle AGC Optical Receiver
HR9236, HR9253
-
Hangzhou Huatai Optic Tech. Co., Ltd.
Guangtai HR9236, HR9253 builds in two ways optical receiving. When one way is out of work, it will automatically switch into the other way that is heat backup circle design. This series products adopt full-function and top-class designation, so it is suitable for high-end subscribers.
-
Product
PXI 2-Slot BRIC Matrix, 92x8, 1-Pole (2 sub-cards)
40-560B-221-92X8
-
The 40-560B-221-92x8 is an ultra high density matrix module and is part of our range PXI BRIC matrices. They are available in 2, 4, 8 or 12-slot sizes to suit high performance PXI switching requirements and is constructed using instrumentation quality reed relays.
-
Product
LXI Microwave Multiplexer, 50Ω 4-Channel 6-Bank 40GHz SMA-2.9
60-802-406
-
The 60-802-406 is a 4-channel, 6-bank RF multiplexer suitable for switching 50Ω signals up to 40GHz. It is part of Pickering Interfaces’ range of LXI Microwave Multiplexers which are available with bandwidths between 6GHz and 40GHz and support for 4, 8 12 or 16 banks of 4 or 6-channel multiplexers. It is ideal for constructing complex microwave switching systems for many applications. Connection is by high performance front panel mounted SMA or SMA-2.9 connectors.
-
Product
Energy Saving Static Converter
-
The ENERGY SAVING static converter serves to generate a controlled squarewave single-phase alternate voltage (low frequency: 25 ÷ 125Hz) for industrial applications requiring high load power supplied by an external matching transformer. The power supply, sectioned by remote control switch and external fuses, is fed by a three-phase electric line via uncontrolled diode bridge and filtered by inductor and capacitor battery. The DC voltage thus obtained is converted into single-phase alternating voltage via “H”-shape bridge of semiconductors in order to control impressed frequency single-phase transformers.
-
Product
PXI/PXIe High Density 2A Multiplexer, 2-Bank, 32-Channel, 2-Pole
40-614D-011
-
The 40-614D-011 (PXI) and 42-614D-011 (PXIe) 2-bank, 32-channel, 2-pole multiplexers are part of the High Density 2A multiplexer module range available in 22 configurations (see 'Also in this Range' link above). All configurations use high quality electro-mechanical signal relays allowing each channel to switch current up to 2A and voltage up to 300VDC/250VAC.
-
Product
EZ-View Flow Meters
-
Hedland EZ-View flow meters provide a lower cost alternative to standard Hedland flow meters. Made from high-impact thermoplastics like polysulfone and Radel, these variable area meters (rotameters) contain a minimum number of moving parts, offering a reliable, trouble-free flow rate indicator. Fittings, available in brass, stainless steel and PVC, with NPT or BSP ports, allow the meter to be installed in a wide variety of applications. Meters can be used in oil and water processes, with the ability to add a flow switch, which can be used to trigger alarms.
-
Product
Optical Switches
-
Nanning Xionghua Photonics Technology
Optical Switches by Xionghua Photonics
-
Product
PXI/PXIe Solid State Attenuator, Hex, 6GHz, 50Ω, SMA
41-182B-006
-
The 41-182B-006 (PXI) and 43-182B-006 (PXIe) are programmable RF attenuator modules with 6 channels in 2 slots capable of inserting a signal loss of 0 to 31.75dB in 0.25dB steps. The attenuator uses solid state switches for a long service life and fast operation with minimum settling time and no signal bounce.
-
Product
LXI Scalable Switched Guard Matrix - 8x16 Plugin Module
65-290-002
-
The 65-290-002 is an 8x16 matrix plug-in module for use in Pickering's modular switching platform that provides a switched guard relay matrix solution with up to 1012 Ω channel to channel and channel-to-ground isolation.
-
Product
PXI/PXIe Microwave Relay, Dual SPDT, 40GHz, 50Ω, SMA-2.9, Internal Termination
40-781A-422
-
The 40-781A-422 (PXI) and 42-781A-422 (PXIe) are dual SPDT 40GHz microwave relay modules with internal terminations. The 40/42-781A range is available with one or two SPDT switches capable of switching frequencies up to 50GHz in 50Ω. They are available with either internal or external terminations and connections are via front panel mounted high quality SMA, SMA 2.9 or SMA 2.4 connectors.
-
Product
PXIe Microwave Signal Generator
LSX8081X
-
The LSX8081X is a 8GHz Single Channel PXIe Microwave Signal Generator that offers industry leading performance, in a modern modular 2 slot PXIe format that can be used on the desk, embeded in a system or or easily scaled up to multiple channels ATE systems. It features exceptionally fast switching speed, superior signal integrity and purity and all the necessary modulated signals for analog communication systems.
-
Product
19’’ Rackmount 1/10 Gigabit Ethernet Switch
IC-SR-BOXa
-
The IC-SR-BOXa is based on the Interface Concept ComEth4000e Layer 2/3 1/10 Gigabit Ethernet switch into a 19’’ rack mountable box. The IC-SR-BOXa is dedicated to industrial and military networking applications.
-
Product
PXI Breadboard Module, 1-Slot, 50-Pin D-Type
40-220A-501
-
The 40-220A series of breadboard modules allow the user to construct their own circuit in situations where a suitable PXI module is not available. For example when it is required to integrate a non-switching function into a PXI chassis. Typical applications include: Creating custom circuitry that can be housed in on a 3U board, or to build special one-off switching modules.
-
Product
Vibration & Tilt
-
Electro-Sensors offers Vibration Switch options to meet Explosion-Proof and Dust-Ignition Proof requirements. The VS1/VS2 (XP) options are certified for use in Class I - Group C, D; Class II - Group E, F, G; Class III. The VT420 Vibration Sensor is a Vibration monitor that outputs a 4-20 mA output signal to provide real time machinery performance data.
-
Product
Cable ID & PoE Tester
PK-170 INNOTESTER PRO
-
INNOTESTER PRO combines the functions of a smart cable tester, network tester, port identifier and organizer with the capability to identify up to 100 cables run at a time, and 8 Test + ID remotes allows one person to test 8 cables run up to 600 meters. Tone mode, transmits 2 powerful tones for tracing inactive and active network cables on a Switch or HUB. More effectively tracing at patch panel, termination blocks or hidden within bundles.
-
Product
LXI 50Ω Microwave Transfer Switch
60-808-010-009
-
These LXI (Ethernet-controlled) Microwave Transfer Switches are suitable for routing 50 Ω signals up to 50 GHz. With up to 16 switch banks, they are ideal for constructing complex microwave switching systems for many applications. Connection is by front panel mounted SMA. SMA 2.9 or SMA 2.4 connectors.
-
Product
Detector, Metal, Power, Stud
72-6792
-
*Electronically locates hidden cables gas and water pipes*Traces hidden ceiling joists and wall studs*Senses presence of mains power withut touching live wires*Locates breaks in circuits and cables*Identifies faulty plugs switches and sockets*Incorporates audio signal and indicator light
-
Product
Cable Assembly, 37-Pin D-Type, Male to Unterminated With Cut Ends, 2m, HV
A037DM5-C-HA200
-
The 37-Pin D-Type HV Cable assemblies are constructed from 7/0.2 (24AWG) Tinned Copper Wire with PTFE Type C insulation. The connector assembly can be secured to the mating part by a screwlock. The 37-Pin Female connector options of this product can be directly mated to a corresponding Pickering Interfaces switching product.
-
Product
PXI/PXIe RF Multiplexer, Single 4-Channel, Terminated, 3GHz, 50Ω, SMB
42-873A-001
-
The 40-873A-001 (PXI) and 42-873A-001 (PXIe) are 4 to 1 RF MUX with 1 bank in a single slot. Additionally, extra switching allows unused channels to be terminated into 50 Ohm, maintaining signal integrity. It has been designed to exhibit low insertion loss and VSWR through the use of modern RF relay technology at an affordable cost. Each MUX has been carefully designed to ensure excellent and repeatable RF characteristics to frequencies of 3GHz.
-
Product
XMC-PCIeStor, High Speed PCIe Quad M.2 SSD Adapter
9303
-
The 9303 is an air or conduction cooled, extended temperature XMC card with 4 M.2 SSD sites for multi-terabyte storage. Onboard Gen2 PCI Express (PCIe) switch connects one 4-lane upstream PCIe port to four 1-lane downstream ports.
-
Product
4 Digit Process Meter
CM1-PR
-
CM1-PR 4 Digits Process Meter has been designed in simple function and 4 digital 20.0mm LED displays with economic cost.They are can be programmed by tact switches that are hidden in backside of front bezel.They are also available option of 2 Relay outputs, 1 Analogue output or 1 RS485(Modbus RTU Mode) interface with versatile functions such as control, alarm, re-transmission or communication for a wide range of industrial applications.
-
Product
Precision Integrated Analog Front End, Controller, & PWM for Battery Test & Formation Systems
-
The AD8452 combines a precision analog front-end controller and switch mode power supply (SMPS), pulse-width modulator (PWM) driver into a single silicon platform for high volume battery testing and formation manufacturing. A precision instrumentation amplifier (in-amp) measures the battery charge/discharge current to better than ±0.1% accuracy, while an equally accurate difference amplifier measures the battery voltage. Internal laser trimmed resistor networks establish the in-amp and difference amplifier gains (66 V/V and 0.4 V/V, respectively), and stabilize the AD8452 performance across the rated operating temperature range.
-
Product
Connection Units
-
Leuze electronic GmbH + Co. KG
All peripheral devices – such as sensors, safety switches and cameras – require a connection to the fieldbus or a control unit. Depending on device type and area of application, our modular connection units offer variable interfaces that enable simple connection of the devices directly to the fieldbus and thus ensure simple integration of new devices in the system.
-
Product
LAN Switches
-
Featuring user-friendly efficient IP management, IPv4 and IPv6 hardware Layer 3 routing, PLANET LAN switches are designed for SMBs, system integrators and large enterprises when managing wide coverage networks. Apart from providing 10Gbps~100Gbps high performance managed switches, PLANET Ethernet switches, which come with unique Color LCD Touch Screens for efficient management purposes, are also designed with user-friendly fast installation and real-time monitoring.
-
Product
75 High Isolation LXI RF Multiplexer
-
Pickering's LXI high isolation RF multiplexers are suitable for switching 75 signals up to 1GHz - ideal for constructing complex microwave switching systems for many applications.
-
Product
D-Type Surge Generator
-
Shanghai Guantu Technology Co., Ltd.
Meet and exceed the new standards of IEC61000-4-5 and GB/T17626.5;Chinese and English switching, programmable operation, easy to use;7.0 color touch screen display, more convenient operation;Imported program-controlled high-voltage power supply with stable performance;Built-in ambient temperature and humidity display;The surge test mode is automatically switched in all gears, without manual operation;Built-in level parameters, positive and negative automatic switching, easy to operate;Built-in RS232 interface, convenient for product upgrades, optional measurement and control software for remote control.
-
Product
50Ω N-Type Cable Assembly, 18GHz, 0.25m
40-977-572-0.25m
-
Pickering Interfaces offer a range of RF cable assemblies to complement our extensive range of PXI, LXI, PCI, VXI and GPIB switching products. All cable assemblies are made from high quality materials and use best practice assembly methods to ensure the cabling matches the performance of the switching modules they support.
