Product

Multiple Gas Transformer DGA

MINITRANS

-

GE Vernova

MINITRANS - GE Vernova

Based on the same core technology as the highly successful TRANSFIX the MINITRANS is a lower cost alternative, monitoring three key gases: Hydrogen, Acetylene and Carbon Monoxide (in ppm) plus moisture in oil (%RH & ppm). The measurement of these gases allows the user to detect a wide range of developing faults including arcing.

Product

Conformance Calibration Standard Test Card for UPC/EAN Symbol Verifiers

AI-CCS-UPC/EAN-E Rev S

-

Applied Image, Inc.

AI-CCS-UPC/EAN-E Rev S - Applied Image, Inc.

For those who prefer a traditional vertical format calibration test card, APPLIED IMAGE offers our new Conformance Calibration Standard Enhanced for UPC/EAN Bar Code Symbol Verifiers. The new standard complies with both the ANSI X3.182 and ISO 15416 standards and is ideal for testing of verifiers, scanners, and other UPC bar reading equipment as well as a tool for training new operators to assure proper “methodology' in the use of verifiers.

Product

Transformer Winding Resistance Meters

TWA Advanced Series

-

Amperis sl

TWA Advanced Series - Amperis sl

The TWA advanced series instruments are designed for six-winding resistance measurement and simultaneous three phase on-load tap changer analysis of both the primary and the secondary transformer windings. This is performed with a one singlestep cable setup, with test currents of up to 40A. Each transformer configuration has a special measurement algorithm which is optimized for the fast stabilization of test results. The TWA instruments generate a true DC ripple-free current. Both the injection of the current and the discharge of energy from the magnetic circuit are automatically regulated.

Product

Standard - 6.00 (170.00) - 14.00 (397.00) Feed Through Probe

P2447-1W

-

ECT

P2447-1W - ECT

Current Rating (Amps): 20Average DC Resistance lower than (mOhm): 10Test Center (mil): 225Test Center (mm): 5.72Full Travel (mil): 300Full Travel (mm): 7.62Recommended Travel (mil): 200Recommended Travel (mm): 5.08Overall Length (mil): 1,145Overall Length (mm): 29.08

Product

Solid State Active Synchro Control transformer and Solid State Resolver Control Transformer

-

Computer Conversions Corporation

Computer Conversions Corporation

The SCT Series are low cost, miniature, solid state control transformers designed for military and industrial control applications. They will directly replace conventional electromechanical control transformers & thus provide digital control to existing analog servo systems. They simultaneously accept a 3 wire synchro input (0) and a digital angle input (0), and provide an ouput which is the sine of the difference between these two input angles (A sin wt sin (0-0) ("wt" is the synchro excitation frequency).

Product

Transformer Performance Tester

6691

-

Kingrun Instrument Co., Ltd.

6691 - Kingrun Instrument Co., Ltd.

applying ±90V voltage on the winding of the transformer demagnetized and get the voltage value on the terminal and the current value in the winding to draw the hysteresis characteristic curve. This method can be used for linear quantitative analysis of residual magnetism in transformers, and fast demagnetization can be achieved by tracking hysteresis curves. The analyzer can measure magnetism residual rate before and after demagnetization.

Product

Transformer Resistance Testing

-

Weshine Electric Manufacturing Co., Ltd

Weshine Electric Manufacturing Co., Ltd

Transformer insulation resistance deterioration is one of the most common causes of transformer failure: a failing transformer is a costly replacement in an electrical system with the potential for a long downtime. If you fail to maintain your transformer with regular insulation resistance testing (as can be carried out by the WESHINE Transformer Ohmmeter (VS-3110 series) of transformer test equipment) then it’s likely to fail before reaching its maximum operating life.

Product

Standard Voltage 37 Pin D-Type Connector Blocks

-

Pickering Interfaces Inc.

Pickering Interfaces Inc.

The connector blocks and breakouts below are not compatible with Pickering products, however, are offered for developing a connection solution for use with other products.

Product

NTSC Standard Pattern Generator

PG315N

-

MicroImage Video Systems

PG315N - MicroImage Video Systems

The MicroImage PG315 pattern generator is designed for simple size and geometry reference applications. The PG315 will overlay one of five standard patterns including a centered cross line, a centered cross hair, a centered target style symbol, a dot grid (cross dot) array, a hatch grid (crosshatch) array.

Product

Standard Gain Horns

-

Marki Microwave

Marki Microwave

Standard gain horns can be used to experimentally determine the gain of other antennas by using the substitution method. The standard gain horn and the antenna under test are alternately connected to a well matched detector system in order to compare their relative power levels. The power level difference is then added to the appropriate level of the calibration curve to determine the absolute gain of the antenna under test.View more Standard Gain Horn Antennas

Product

1 Channel, MIL-STD-1553, Dual Redundant, Transformer Coupled, Assisted Mode Capable (AMC)

FTA

-

North Atlantic Industries

FTA - North Atlantic Industries

MIL-STD-1553 is a military standard published by the United States Department of Defense that defines the mechanical, electrical, and functional characteristics of a serial data bus. It was originally designed for use with military avionics, but has also become commonly used in spacecraft On-Board-Data-Handling (OBDH) subsystems, both military and civil. It features a dual, redundant, balanced-line, physical layer; a (differential) network interface; time division multiplexing; half-duplex command/response protocol; and up to 31 remote terminals (devices).

Product

Transformer Testing Equipment

-

Embuilt Technologies

Embuilt Technologies

Offering you a complete choice of products which include Automatic Transformer Turns Ratio Instruments (ATRI- 3), Automatic Transformer Turns Ratio Instrument (ATRI-201), VTRI-2000 ( Transformer turns ratio instrument ), Current Transformer Test Set (CTC-1), Potential Transformer Tester ( PT Tester ) and Current Transformer Tester ( CT Tester ).

Product

Incremental > Standard Encoders - Shaft

-

SCANCON

SCANCON

Incremental > Standard Encoders - Shaft

Product

Standard Class AAA Solar Simulator

TriSOL TSS

-

OAI

TriSOL TSS - OAI

Essential for testing virtually any material or product that is exposed to sunlight for long or short periods of time, OAI’s low-cost, Standard Solar Simulators deliver highly collimated, uniform light. Depending on configuration, output on these Solar Simulators is rated at 350W -5,000W.These Class AAA Solar Simulators feature OAI’s Advanced Uniform Beam Optics and are available with a choice of air mass filters to reproduce a wide range of solar spectra. For added flexibility, OAI’s proven lens and collimating mirror technology allows for a variety of exposure area sizes. A Class AAA Solar Simulator is an essential tool for manufacturing as well as R&D; it is indispensable in test labs, industry, and in universities. OAI Standard Solar Simulators are used in photobiology, biomedical, solar cell testing, cosmetic testing, and paints & coatings analysis. Based on 35+ years of proven UV light technology, OAI Solar Simulator Systems deliver repeatable, reliable, constant output, and measurement uniformity.

Product

DC Immune Current Transformer

DCT 108

-

SHANGHAI POWOO INDUSTRY CO., LTD

DCT 108 - SHANGHAI POWOO INDUSTRY CO., LTD

- Accurate DC measurement; comply to IEC 1036 and IEC 62053; - suitable for a wide range of current (from 1.5A to 100A); - linear output current, high precision; - compact, delicate appearance.

Product

FTIR – Fourier Transform Infrared

-

Gasmet Technologies Oy

Gasmet Technologies Oy

FTIR stands for Fourier Transform Infrared spectroscopy. It is a powerful gas measurement technology for simultaneous measurements of multiple gases. The ability to detect and measure almost any gas, combined with the robustness and reliability of the technology, makes FTIR ideal for a wide variety of applications.

Product

Standard In-door Forward Optical Receiver

ONR-8636

-

Hangzhou Huatai Optic Tech. Co., Ltd.

ONR-8636 - Hangzhou Huatai Optic Tech. Co., Ltd.

ONR-8636 with standard configuration is a type of high index and universal in-door forward optical receiver. It adopts Philip optical receiving module. End-grade adopts power-doubling module. Optical connectors and RF connector can be installed at the front panel or back panel.

Product

Transformer Winding Resistance Meters

RMO TD Series

-

Amperis sl

RMO TD Series - Amperis sl

The RMO-TD Series On-Load Tap & Winding Resistance Analyzer is designed for the measurement of winding resistance of inductive elements, and for tap changer analysis. The RMO-TD series is based on the latest technology, using the most advanced switching technology available today. The RMO-TD series is accurate (0.1%), powerful (up to 60 A) and lightweight. It generates true, ripple-free DC current with automatic metering control and a discharge circuit.