Product

Mini MEMS Tunable Filter With VOA

-

Optoplex Corporation

Optoplex Corporation

The Optoplex mini tunable filter described is specifically designed for 100G tunable transceiver analog coherent optics (CFP2-ACO) application. The main purpose of this tunable filter is to suppress the noise to improve the sensitivity and OSNR performance.

Product

Programmable Encoders

-

Baumer Electric AG

Baumer Electric AG

Free programming of pulse number, output level, SSI absolute value settings or switching speed. For end users, wholesalers and system integrators. Wide and versatile application possibilities. Reduced inventory variation, downtime, maintenance and storage costs

Product

Tunable Edge Filters

-

Optoplex Corporation

Optoplex Corporation

Tunable edge filter is a customized product. It usually belongs to 2-port optical tunable filter product platform. Instead of using narrow bandpass filter in the 2-port tunable optical filter, the tunable edge filter utilizes a low-pass or long-pass interference filter. By changing the incident angle of the light beam, the cut-off wavelength will be tuned. Standard Tunable edge filters support C-band or L-band wavelength range.

Product

Programmable Insulation Resistance Tester

-

AllWin Instrument Science and Technology Co., Ltd.

AllWin Instrument Science and Technology Co., Ltd.

Electrical resistance testingLCD displayOutput Voltage: 1.0V~1000VThe insulation resistance range:100kohm to 100Gohm

Product

Programmable Multifrequency Clock Synthesizer - PMC

Model 7191

-

Mercury

Model 7191 - Mercury

- Simultaneous synthesis of up to up to 5 different clocks- Eight SMC clock outputs- Ideal for A/D and D/A converter clock sources- Typical phase noise: -105 dBc/Hz @ 1 kHz offset- All clocks are phase-locked to input reference signal- Input reference frequency of 5 or 100 MHz- Four programmable VCXOs with 32-bit tuning resolution- Output clocks of 1, 2, 4, 8, or 16 submultiples of VCXO base frequencies- Output clock frequencies between 50 and 700 MHz- Control and status via PCI bus interface

Product

High Power Programmable AC Source

61610

-

Chroma Systems Solutions, Inc.

61610 - Chroma Systems Solutions, Inc.

Power Rating:61511/61611: 12KVA61512/61612: 18KVAVoltage Range: 0-150V/0-300V / AutoConfigurations with input voltage of 220V or 480VFrequency: DC, 15Hz-1500HzSingle-phase or three-phase output selectableProgrammable slew rate setting for changing voltage and frequencyProgrammable voltage and current limitHigh output current crest factor, ideal for inrush current testingTurn on, turn off phase angle controlTTL signal which indicates output transientComprehensive measurement capability, including current harmonicsAnalog programmable interfacesRemote interface: GPIB, RS-232, USB and EthernetCapable of delivering power output up to 90KVA by implementing Master-slave parallel operation

Product

Programmable Selsyn Indicators

PSI

-

Computer Conversions Corporation

PSI - Computer Conversions Corporation

Computer Conversions Solid State Selsyn/Resolver Indicator digitizes the outputs of Selsyns, Synchros and Resolvers for position indication and control applications. The Selsyn Indicator is designed to replace failure prone mechanical selsyn torque receivers, counters, etc. The tracking converters high noise immunity and high speed tracking characteristics make it ideal for use in industrial envrionments.

Product

ICT Programmer

-

Fitech Ltd.

Fitech Ltd.

Compatible with a wide range of microcontrollers in electronic devices. Supports programming of single product or bulk PCBA boards. Enables quick replacement of the adapter or dedicated product inserts. Equipped with a high-performance, multi-channel industrial ISP programmer.

Product

Dual 10th Order Lowpass Filter

64-VBF

-

Viewpoint Systems, Inc

64-VBF - Viewpoint Systems, Inc

The 64-VBF 10th order Lowpass Filter is a dual channel filter with independent switch settable Cutoff Frequency (Fc). The filter has a linear phase DC accurate root raised cosine response. The unit’s differential inputs are built to withstand high DC over-voltages up to ±50 VDC and greater than ±100 V transients. Gain of the unit is 1 allowing for minimal insertion issues. The output can drive a high speed DAQ multiplexer with its fast settle and capacitive drive capability.

Product

High Resolution USB Programmable Digital Attenuator 200 to 6,000 MHz

LDA-906V Lab Brick®

-

Vaunix Technology Corporation

LDA-906V Lab Brick® - Vaunix Technology Corporation

The Lab Brick LDA series of Digital Attenuators bring affordability, functionality, reliability and simplicity to the microwave test bench. The LDA products range from 6 MHz to 20 GHz with input level tolerance to 2 Watts and step size as small as 0.1 dB. Lab Bricks use a native USB HID interface to avoid the difficulties inherent in using older serial or IEEE-488 interfaces implemented over USB. As a result, Lab Brick users can get to work faster without having to install kernel level drivers, and Lab Brick devices can be easily used on any system that supports USB HID devices, including low cost embedded computers using Linux or similar operating systems.

Product

User Programmable Logic

PCIe-Spartan-VI

-

Dynamic Engineering

PCIe-Spartan-VI - Dynamic Engineering

User Programmable logic - Spartan VI 100 with 40 differential and 12 TTL IO plus PLL(24). 16 DMA ports, to support 8 full duplex byte lanes between the Bus and User FPGAs. Additional GPB interface to support R/W operations to registers etc. Driver and reference SW package includes user defined R/W to User FPGA to support User Architecture without a new driver.

Product

Programmable Parametric Tester For Discrete Semiconductors

IST-8800

-

IST Information Scan Technology, Inc.

IST-8800 - IST Information Scan Technology, Inc.

The IST-8800 is a fully programmable, low cost tester that provides parameter measurements or parametric GO/NO GO test for transistors, diodes, MOS-FETs, Regulators, Triacs, Zeners, SCRs, and J-FETs. These devices can be tested up to 5 amps or 1200 volts with a measurement range down to the nano amp range. Only four universal test fixtures are required which can test the device across a wide range of packages.

Product

Filters, Collectors, Separators, Purifiers

-

Parker Hannifin Corp.

Parker Hannifin Corp.

Parker's filters, separators and purifiers come in a variety of options and media and are used to filter out air or fluid contaminants in an array of industrial and commercial applications.

Product

CCS Programmers & Debuggers

-

Custom Computer Services

Custom Computer Services

Fast & Easy-to-useComplete & Cost EffectiveUSB Connection to PCPower Target Board Through USBICD & ICSP™ Programmer/DebuggerDebug Support Covers all Targets

Product

Notch Filters

Power-Pole Notch Series

-

Pole/Zero

Power-Pole Notch Series - Pole/Zero

POWER-POLE® Notch Filters offer improved performance and power handling over our MINI and MAXI Notch Filters.

Product

Controllable, Programmable DC Source

LAB SMP

-

ET System Electronic GmbH

LAB SMP - ET System Electronic GmbH

*Easiest operation via the front panel*Indication via graphic display*Constant current, voltage, resistance, power operation and simulation of PV characteristics*Creation of any voltage and current curves via memory card or digital interface (sequential control)*Voltage and current rise time (U and I slope) adjustable*Umax and Imax can be set by the user in order to limit the output voltage or current

Product

Programmable DC Electronic Loads (conventional and regenerative)

-

Elektro-Automatik GmbH & Co.KG

Elektro-Automatik GmbH & Co.KG

Our programmable electronic loads are composed of an optimum mix of analogue- and digital technology (µ-controller/FPGA based). By combination of standardised electronic platforms out of a modular structure, we generate a large portfolio of electronic-load series, perfectly adapted in power, function, performance and cost to the numerous applications in industrial environment and R&D. EA programmable electronic loads are available in conventional technology (heat dissipating) and as “regenerative” loads. The latter allows, specifically under long-term testing condition (e.g. battery discharging) a full amortisation of its invested value by its energy-saving capability, similar as with Photovoltaic installations.

Product

Single Channel USB Programmable Band-Pass Filter

USBPBP-S1

-

Alligator Technologies

USBPBP-S1 - Alligator Technologies

The USBPBP-S1 stand alone USB controllable module provides a single channel of high and low-pass filtering and high-quality instrumentation amplifier for front-end signal conditioning compatible with all popular A/D converter devices. The USBPBP-S1 is powered with 9 to 12VDC so it can be connected to a battery voltage source or the supplied 115-220VAC adapter may be used for operation with wall power anywhere in the world. When programmed from the USB port, the USBPBP-S1 will remember all of the programmed properties between power cycles. Program once and operate as a stand- alone signal conditioner without having to reprogram for every use. This is perfect for turn-key applications. It's easy to connect the USBPBP-S1 into the data collection system. Input and output signals can be routed through BNC connection or using the detachable screw terminal connectors. Optional SMA type adapters are also available.