Thin Film
layer of material ranging < a nanometer to > a micrometer in thickness.
See Also: Film, Ellipsometers
-
product
Dew Point Analyzer
CI-IN36
Shanghai ChangAi Electronic Science & Technology Co.,Ltd
CI-IN36 adopts the sensor that is made of thin polymer film, which can test the dew point with good stability. It will not influenced by condensed water and most compounds. This analyzer has received automatic zero point calibration and gain return patents with wide measure range, high accuracy, good stability and high performance cost ratio. - See more at: http://en.ci-ele.com/470baa2f-f4d7-af3b-c88b-b26356a1660d/8e93bc9f-4658-e0c4-2205-0be00b504269.shtml#sthash.KzPqj2sw.dpuf
-
product
Inductor Coils
SemiGen's Inductor Coils are manufactured using our thin film process on quartz substrates. The precision photolithography and non-chemical etching process provides clean edges to assure uniformity from coil to coil. By using quartz and applying a polyimide coating we produce a device that eliminates the need for conformal coating or staking. Inductors can be epoxied down with nonconductive epoxy and the wire bonded for connection.
-
product
1550/1310~1490nm Wavelength Division Multiplexer
PON-WDM-1543
Hangzhou Huatai Optic Tech. Co., Ltd.
PON-WDM-1543 WDM is based on mature thin film filtering tech, with wide bandwidth, flatness, low insertion loss and high isolation. It is mainly applied to FTTx PON network to achieve the combination and separation of the 1550nm (CATV) and 1310/1490nm (data).
-
product
C-Band Red/Blue-Band Pass MWDM
WD1515/R, WD1515/B
Hangzhou Huatai Optic Tech. Co., Ltd.
WD1515/R, WD1515/B is based on mature thin film filtering tech, with wide bandwidth, flatness, low insertion loss and high isolation. It is mainly applied to the combination and separation of C-Band, Red-Band (1547~1563nm) and Blue-Band (1528~1543nm).
-
product
Customized Ellipsometers
~0.1 nm thickness difference can be seen by IE-1000.Thickness distribution of thin film can be imaged.Thickness and optical images of semiconductor device, display, and bio samples.IE-1000 can show the images which can not be seen by conventional microscope.Defect of semiconductor and display can be seen directly.Easy and fast operation.
-
product
Thick Film Divider
GBR-391
GBR-391 series high-voltage resistive dividers are made in a thick film technology on ceramic substrates (Al2O3 - 96%) with leads for through-hole mounting. Dividers are characterized by very high maximum voltage, and standard voltage division.
-
product
Film Thickness Probe
FTPadv
The SE 500adv combines ellipsometry and reflectometry to eliminate the ambiguity of measuring layer thickness of transparent films. It extends the measureable thickness to 25 µm. Therefore the SE 500adv extends the capability of the standard laser ellipsometer SE 400adv especially for analyzing thicker films of dielectrics, organic materials, photoresists, silicon, and polysilicon.
-
product
Wet Film & Powder Thickness
When applying a liquid coating, by measuring the uncured film thickness, it is possible to determine the eventual dry film thickness. Applying too much coating wastes time and materials. It can also affect the performance and finish of the product. Too much wet film can cause the coating to crack as it cures; too little coating increases the risk that the substrate will not be sufficiently protected, leading to rust spots.
-
product
Pressure Indicating Film
Prescale
Prescale film is used to measure contact pressures. The film structure consists of micro-encapsulated color forming and developing material. When pressure is applied to the film, a red color impression is formed in varying density according to the amount of pressure and pressure distribution.
-
product
Thick Film Bleeder
GBR-351
GBR-351 series resistors are made in a thick film technology, on ceramic substrates (Al2O3 - 965). High voltage resistors have an application as bleeders, which have a task to unload electric charge after disconnection of supply voltage.
-
product
Thick Film Heating Elements
GBR-200
GBR-200 series high voltage resistors are made in a thick film technology on ceramic substrates (Al2O3 96%). Those elements are used in high voltage applications requiring high stability and resistance.
-
product
Thick Film Chip Resistors
Panasonic Industrial Devices Sales Company of America
An AEC-Q200 Compliant SeriesPanasonic components specified as AEC-Q200 Compliant are consistently designed into automotive systems. However, today’s Design Engineers are specifying AEC-Q200 components to meet the high-quality standards of devices beyond automotive applications.
-
product
Aluminum Film Index Tester
DRK120
Shandong Drick Instruments Co., Ltd.
DRK120 aluminum film thickness tester is new instruments as the development of new packaging material. It is used to test aluminum coating in the barrier film, which is around 35NM thickness. This aluminum coating improves the barrier property a lot, because common gas and aromatic gas couldn’t dissolve in metal. The aluminum coating could protect packing material and avoid light. So thickness test and control of aluminum film is very important, the thickness of aluminum will affect the barrier property of film a lot.
-
product
Uncured Powder Film Comb
155
This enables the application system to be set up and fine tuned prior to the curing process. In turn, this will reduce the amount of scrap and over-spray.Place the comb into the powder and slide the comb along the surface. The measurement points (or teeth) are pointed and allow the powder to flow around them.
-
product
Film Shrink Tester
The Hanatek FST Film Shrink Tester is used to measure the effect of temperature on plastic films. The application of heat causes certain plastic films to rapidly contract; this effect can be used to seal and pack many items from food to consumer goods. The shrink effect is due to internal forces locked into the film during manufacture being released by heating, it is also known as linear thermal shrink or free shrink. The amount of shrinkage is dependent on the film type, thickness and sealing temperature. Testing the percentage shrink of a film ensures that it is suitable for a particular packaging application and establishes the correct temperature for that application.
-
product
Coil Coating Wet Film Wheels
Elcometer 3230
The outer wheels are knurled to allow measurements to be taken on slippery coatings or on fast moving substrates.
-
product
Film and Paper Thickness Gauges
Economical, Accurate, Easy-to-Operate, our line of off-line paper / film thickness gauges are manufactured to meet TAPPI specifications for paper or ASTM specifications for film.
-
product
Plastic Wet Film Combs
154
Metric and Imperial values are on the same comb, 50 to 800μm on one side, 2 to 32mils on the other.
-
product
Film Impact Tester
DRK136A
Shandong Drick Instruments Co., Ltd.
DRK136A Film Impact Tester is applicable in the precise impact resistance test of plastic films, sheets, laminated films, rubber and other nonmetal material.
-
product
U Series & Thin Edgewise Panel Meter
ST-90E
Standard Electric Works Co., Ltd
● Movement : Taut Band suspension type.● Accuracy : ± 2.5%● Mounting : Horizontal or Vertical● Pointer : Tube (Red)● Full Scale Deflection : 60˚● Measuring Range : F.S. 1mA DC. Customer’s specs are available
-
product
Air-bath Film Heat Shrinkability Tester
DRK166
Shandong Drick Instruments Co., Ltd.
DRK166Air-bath film heat shrinkage performance tester, according to ISO14616 air heating principle test method to test the shrinkage performance of heat shrinkable films of different materials, to study the relationship between heat shrinkage force and cold shrinkage force of heat shrinkable films of different materials, and to determine the direction of the test when shrinking.
-
product
Film Capacitors
Panasonic Industrial Devices Sales Company of America
Low ESR. Low Dissipation Factors. No Shock Noise. Panasonic Surface Mount Film Capacitors offer stable capacitance and temperature characteristics, tight tolerances, low ESR, low dissipation factors, no shock noise, no piezoelectric effect and no audible noise. Surface Mount Film Capacitor applications include DC blocking and filtering, PLL, audio, DC/DC converter and back lighting.
-
product
CAT5-5E Ethernet cable, thin profile 2m
151733-02
8-Pin Male Ethernet to 8-Pin Male Ethernet, CAT-5E Ethernet Cable - The 8M-8M Ethernet Cable connects devices to network hubs or switches. The cable has straight-through wiring and is available in different lengths and thin profile options.
-
product
Current Sensing Resistors, Thick Film Type
Panasonic Industrial Devices Sales Company of America
An AEC-Q200 Compliant SeriesPanasonic components specified as AEC-Q200 Compliant are consistently designed into automotive systems. However, today’s Design Engineers are specifying AEC-Q200 components to meet the high-quality standards of devices beyond automotive applications.
-
product
Wet Film Combs (Stainless Steel)
Elcometer 115
Four separate thickness ranges are available up to a maximum of 1,250μm or 50mils and are manufactured to an accuracy of ±5% of marked value or ±3µm (0.12mil), whichever is greater.
-
product
CAT-5E Ethernet, Thin Profile, 0.3M
151733-0R3
8-Pin Male Ethernet to 8-Pin Male Ethernet, CAT-5E Ethernet Cable - The 8M-8M Ethernet Cable connects devices to network hubs or switches. The cable has straight-through wiring and is available in different lengths and thin profile options.
-
product
Thick Film Bleeder
GBR-350
GBR-350 series resistors are made in a thick film technology, on ceramic substrates (Al2O3 - 96%). High voltage resistors have an application as bleeders, which have a task to unload electric charge after disconnection of supply voltage.
-
product
MFFT (Minimum Film Forming Temperature)
An instrument for measuring the MFFT point of a latex or emulsion
-
product
CAT-5E Ethernet, Thin Profile, 1M
151733-01
8-Pin Male Ethernet to 8-Pin Male Ethernet, CAT-5E Ethernet Cable - The 8M-8M Ethernet Cable connects devices to network hubs or switches. The cable has straight-through wiring and is available in different lengths and thin profile options.
-
product
Measuring And Inspection Systems For Extrusion, Injection Molding & Calendering Of Plastics And Films
Measuring and inspection systems from Micro-Epsilon are used in the plastics processing industry in order to ensure efficient production.





























