Vehicle
a means of conveyance.
See Also: Conveyance, Transport, V2X, Truck, Electric Vehicle, Car, Automotive, Autonomous Vehicle, Autonomous Underwater Vehicle, J1939, Motor, Fuel, Payload, Cargo, NVH, Spacecraft
-
product
Radiation Microdosimeters
Teledyne e2v HiRel Microdosimeter is a compact hybrid microcircuit which directly measures total ionizing dose (TID) absorbed by an internal silicon test mass. The test mass simulates silicon die of integrated circuits on-board a host spacecraft in critical mission payloads and subsystems. By accurately measuring the energy absorbed from electrons, protons, and gamma rays, an estimate of the dose absorbed by other electronic devices on the same vehicle can be made. The Microdosimeter can operate from a wide range of input voltages. The accumulated dose is presented to three dc linear outputs and one pseudo-logarithmic output giving a dose resolution of 14 µrads and a measurement range up to 40 krads. These outputs are intended to be directly connected to most analog-to-digital converters (ADCs) or spacecraft housekeeping analog inputs (0-5 V range), which makes minimal demands on the host vehicle. The Microdosimeter incorporates a test function to allow electrical testing of the hybrid without the need for a radiation source.
-
product
Speedometer Test Bench
Maschinenbau Haldenwang GmbH & Co. KG.
Tachometer tester for cars and commercial vehicles.
-
product
Command Encoder/Exciter – 5 Watt
Kratos Defense & Security Solutions, Inc.
The 5W Command Encoder/Exciter was specifically designed for use with Unmanned Aerial Vehicles (UAVs), missile systems, and aerial target drones, and it is currently in operation supporting various mission requirements worldwide.
-
product
Automotive Testing
Unique E-Marking Service: Efficient, Flexible and Quality Kiwa Dare is a full compliant test house that perform tests and measurements for customers so that the E-Marking (type approval) can be obtained on vehicles or automotive products and components.
-
product
Wheel Running Tester up to 15000 kg axle load
MINC II EURO | VP 420005
Maschinenbau Haldenwang GmbH & Co. KG.
The test lane-compatible MINC II EURO guarantees a verification of the axle geometry in seconds when the test vehicle drives over (up to 15.0 t axle load) as well as a fully automatic evaluation of the deviation in m / km. The measured values are displayed either in analog form on a dial or by transmission to a PC screen (including graphic representation).
-
product
Scienlab Charging Discovery System (CDS) – High-Power Series
SL1047A
The Scienlab Charging Discovery System – High-Power Series from Keysight enables you to test charging interfaces of electric vehicles (EVs) and EV supply equipment (EVSE) during high-power charging up to 1,500 V DC and ±600 A DC. With the CDS can perform all necessary conformance and interoperability tests according to worldwide charging standards. Our new solution, which features the separate Scienlab Cooling Unit with interchangeable liquid-cooled charging adapters, also enables a high-power upgrade of the SL1040A Scienlab Charging Discovery System - Portable Series.
-
product
Ultra-Ruggedized Data Recorder for Interactive Vehicle Testing
SomatXR CX23-R
The ultra-ruggedized SomatXR CX22B-R data recorder is intended for use in harsh environments and reliably stores measured data in applications such as vehicle tests. The recorder records data from other SomatXR modules using an Ethernet connection. At the same time, FireWire allows its use as a gateway for direct data transmission to the PC. Both centralized and distributed measurement systems can thus be implemented.
-
product
Laser Sensors (Triangulation)
opto NCDT
optoNCDT sensors have set milestones for industrial laser displacement measurement. Whether for displacement, distance or thickness measurement, Micro-Epsilon laser sensors are considered one of the best in their class. These laser sensors are used e.g. in measurement and monitoring tasks in factory automation, electronics production, robotics and vehicle construction.
-
product
200-400 kHz Multibeam Echosounder
SeaBat T50-ASV
The SeaBat T50-ASV is built around the renowned SeaBat® T50 and maintains the incredible SeaBat® data quality in a smaller form factor. Now, optimized power requirements ensure extended and crucial mission time on battery-powered vehicles.
-
product
Security and Traffic Monitoring System
Information System Technologies Inc.
ISTI’s versatile sensor nodes can support multiple sensing types including acoustic, seismic, visible/IR, and scanning laser. Several eye-safe scanning lasers form a distributed wireless sensor network and can continuously and accurately track as well as monitor ground vehicles and personnel in a surveillance area. This system provides super-fine angular and range resolution to precisely locate moving targets. Among other key benefits are: day/night operational capability, continuous monitoring and surveillance without blind spots, 360 degrees field-of-view, large coverage area, multiple closely spaced target tracking, threat classification, and automatic alarm generation. The system can be used in applications such as traffic monitoring, intrusion detection, border control, airport runway collision and incursion avoidance, and perimeter security.
-
product
Heavy Duty Diesel Compression Tester
DCT1570
Compression tester and adapters to test many vehicles, trucks, heavy-duty equipment. Covers Cummins, VW, Volvo, Allis-Chalmers, Bedford, I.I.Case, John Deer, IH, Mack, Massey-Ferguson, Mitsu-Fuso, Scania, White Farm, Detroit Diesel, and more.
-
product
Cable Test Van
The desire for faster and more efficient cable fault location as well as cable testing and diagnostics demands the ergonomic installation of equipment into vehicles. To be able to satisfy the customer's particular requirements, each system is factory-fitted into a vehicle of their choice. The size of vehicle will dictate the equipment at the planning stage. Ergonomics, taking into account the customer's needs, is paramount.
-
-
product
Noise Reduction Water Leak Detector
DNR-18
With digital noise reduction that removes intermittent sounds like barking dogs and passing vehicles. DNR-18: the advanced digital CPU eliminates intermittent interfering noises, like passing vehicles, people talking, and pedestrian footsteps.
-
product
Temperature Test Chamber
Temperature Test Chamber is designed for testing the capability of heat-endurance, cold-endurance, dryness-endurance, and humidity-endurance, suitable for quality control of the industries of electron, electrical equipment, vehicle, metal, foodstuffs, chemistry, building materials, luggage, adhesion tape, printing, packaging, etc.
-
product
CTDs: Profiling
Profiling CTDs make continuous measurements as they travel through water. When lowered over the side of a ship or integrated with an autonomous vehicle, they map a vertical column of water's characteristics. Compared to moored CTDs, profiling CTDs account for dynamic errors introduced by moving through water and sample rapidly to generate a high-resolution dataset over a short period of time. Sea-Bird Scientific profiling CTDs are:*Designed to perform under unique dynamic conditions found on moving platforms.*Pumped and ducted for constant flow to match temperature and conductivity response.*Plumbed so measurements are made on the same sample of water with a predictable delay and predictable flow effects.*Built with a rugged design for shipboard and autonomous deployments.
-
product
Tester for Electromagnetic Clutches and Control Valves
MS121
MS121 is a professional tester, a multifunctional device which successfully combines two functions: testing of electromagnetic clutches and control valves of vehicle air conditioners. Thanks to the color 4.3" TFT display and convenient menu, the device is user-friendly and possesses high-accuracy measurements. Testing can be performed either separately on the compressor or directly on the car. The tester has a metal case and is resistant to the effects of lubricants. The original topology of the tester board increases its reliability, the color marking of the diagnostic contacts minimizes the possibility of incorrect connection.
-
product
Video and Radar-based Vehicle Presence Sensor
TrafiRadar
FLIR’s TrafiRadar vehicle presence sensor is a combination of a video sensor and radar. TrafiRadar is typically used for stop bar and advance vehicle presence detection, traffic adaptive systems, and dilemma-zone protection and thus improves traffic safety and efficiency at signalized intersections. TrafiRadar will warn traffic light controllers whenever a vehicle is present in the dilemma zone, either extending green or red lights to improve overall safety.
-
product
Material Compatibility Test System (MCTS)
Automotive squeaks occur when materials in contact rub against one another causing annoying noises from friction-induced stick-slips. Automotive itches are a special category of squeaks that can develop when rubber or plastic rubs against glass or paint. The MB Dynamics Material Compatibility Squeak & Itch Test System (MCTS) is designed and manufactured to subject contacting pairs of materials and actual vehicle parts to precisely controlled interference & motion under in-vehicle environmental conditions in order to acquire, monitor, analyze and report friction and acoustic characteristics with the objective to:
-
product
Steering Effort Sensor
CLSx
With the innovative CLSx steering effort sensor, the original steering wheel of your vehicle becomes a high-precision instrument that measures steering torque, angle, steering velocity and acceleration in x, y and z directions. Whether passenger car, truck or construction machinery, the ultra-slim sensor can be placed between the steering column and steering wheel in just a few simple steps. The functionality of the original steering wheel including airbag is completely preserved.
-
product
Opacimeter for the Measurement of Diesel Vehicles
MO / MAHA OPAZIMETER | VP 135043
Maschinenbau Haldenwang GmbH & Co. KG.
The MAHA Opacimeter is used for the measurement of diesel vehicles. The smoke opacity is tested and diagnosed in a time-saving and trouble-free manner in a partial flow procedure during free acceleration or under load of the engine. Rapid readiness for measurement and precise measurement results are the distinguishing features of the MAHA Opacimeter. Type-tested according to PTB requirements 18.09.
-
product
Vehicle Tracking System
Information System Technologies Inc.
ISTI has built a vehicle tracking system that overcomes the challenges with acoustic tracking and localization of small ground and airborne vehicles using low-cost wireless sensor nodes. The sensor-level sub-band feature extraction and streaming of the encoded data enables real-time direction of arrival (DoA) estimation and tracking even for large wireless sensor networks with limited bandwidth. Benefits include: accurate tracking of single or multiple closely spaced electric or gas driven small planes and UAVs, collaborative decision-making, target localization and classification, robustness to sensor node loss, flexibility and deployment ease. The interface gives users complete control over the entire sensor network, including the ability to monitor the azimuth and elevation angles to the targets in real-time.
-
product
Space Flight Components
A tec, Inc. specializes in the design, manufacture, and integration of complex test systems and quality critical components. Our production engineering expertise separates us from other manufacturing companies when both reliability and cost are important. Atec has the best in 5 to 9 Axis CNC machining, coordinate measuring machines (CMMs), 3D additive metal and plastic printers, 9-Axis capable waterjet, cryogenic liquid flow test benches and environmental test chambers. We can deliver to the tightest tolerances and most exacting requirements. We can advise our customers on electron beam welding, friction joining, electronic test, environmental test, acoustics, vibration and many other technologies that can reduce manufacturing and operating costs. We are currently manufacturing liquid rocket engine fuel and oxidizer valves for multiple launch vehicles and have participated in 158 consecutive launch successes. Atec manufactured and tested advanced lithium-ion battery adapter plates that manage power for the International Space Station. Atec is designing, manufacturing, and testing power flow modules that work to prevent system failure on the human crew capsule (CCTS) that will transport astronauts to/from the ISS. Atec was awarded NASA Agency-Level Small Business Subcontractor of the Year , SBA Region VI Subcontractor of the Year for our support to NASA and Boeing and we were named a DCMA Top 500 Supplier.
-
product
BOOSTERS (Starters)
Starters ( battery boosters ) FERVE are autonomous and portable multi - application: instant startup help, portable power sources and battery chargers. Allow to operate your vehicle anywhere, and provide energy in situations of lack of electricity. Also they incorporate the advantage of maintaining data electronic equipment in replacing the vehicle battery. For all types of lead-acid batteries.
-
product
SABRE Rugged Systems
The SABRE family from Diamond Systems offers an attractive combination of features, ruggedness, and economy. These systems feature full IP67 rating and MIL-STD-810G compatibility and are ideal for vehicle and other harsh environment applications. Standard configurations offer quick turn solutions based on proven designs, while the system architecture supports quick and low-cost customization with the addition of PC/104 and PCIe MiniCard I/O modules.
-
product
Sound Level Meter
AWA5636-0
Hangzhou Aihua Instruments Co., Ltd.
Complies with IEC 61672 Class 2 use in Industrial Noise Surveys ; machinery, vehicles, ships and etc
-
product
ATX Industrial Motherboard With LGA1150 Socket Intel® Xeon® E3-v3 Processor, Intel® C226, ECC DDR3, USB 3.0, SATA 3.0, Dual LANs, DisplayPort/DVI-I/HDMI And CFast™
IMB210
The IMB210 is an advanced ATX industrial motherboard based on the 4th Generation Intel® Xeon® E3/ Core™ i7/i5/ i3/ Pentium®/ Celeron® processors (codename: Haswell) in LGA1150 socket with Intel® C226 PCH. The optimized IMB210 is specially designed for workstations through better computing and visual performance ideally used in every major industry for tasks ranging from financial modeling to designing complex buildings and vehicles. With its built-in Intel® HD Graphics P4000, this industrial grade motherboard delivers great 3D visual performance with triple display capability through DisplayPort, HDMI and DVI-I ports demanded by professional-grade CAD and media/entertainment fields. In addition, the IMB210 supports Intel® Turbo Boost 2.0 technology, Intel® Hyper-Threading technology, Intel® HD Graphics with DX11 support, 3-D Tri-Gate transistors, 32 GB ECC DDR3 1600/1333 memory, and PCI Express 3.0 x16 slot. It also features Intel® Active Management Technology 9.0 (iAMT), Trusted Platform Module 1.2 (TPM), SATA RAID, as well as PCIe x4 expansion making it ideal for applications with added security features.
-
product
SparkFun GNSS-RTK Dead Reckoning Breakout
ZED-F9K (Qwiic)
The SparkFun ZED-F9K GNSS Breakout is a high precision, sensor fusion geospatial board with equally impressive configuration options and takes advantage of u-blox's Automotive Dead Reckoning (ADR) technology. The ZED-F9K module provides a highly accurate and continuous position by fusing a 3D IMU sensor, wheel ticks, a vehicle dynamics model, correction data, and GNSS measurements.
-
product
Stellar 32-bit Automotive MCUs
Mobility is becoming greener, safer, and more connected. It is reshaping the Automotive industry and redefining our in-vehicle lives. Electrified vehicles, self-driving cars and new services provide more safety, added security and enhanced user experience. However, we need to change the way the functions are designed and updated, and find ways to simplify systems that continue to increase in complexity.
-
product
Combination Emission Tester for the Measurement of Petrol- and Diesel-Powered Vehicles
MCT / MAHA COMBI TESTER | VP 135224
Maschinenbau Haldenwang GmbH & Co. KG.
The combination tester is designed for the measurement of petrol- and diesel-powered vehicles. In addition, low weight, compact design and short warm-up time ensure easy handling.
