-
product
Cable Continuity Tester, DVI-D Dual Link Mini, Network, 21.01 mm, 45.01 mm, 47.02 mm
72-9220
Quickly test DVI-D Dual Link cables No need to carry bulky, expensive cable testers to test only one or two cable types Mini cable tester fits easily in your pocket or tool box, and requires no external power Confirms conductor continuity with sequential LED's Save time and money by diagnosing connectivity issues All units are powered by a cross compatible 3xAA battery pack or USB cable (both included) Most units measure 2" x 2" x 1" or less!
-
product
1 Channel, MIL-STD-1553, Dual Redundant, Direct Coupled, Assisted Mode Capable (AMC)
FTD
MIL-STD-1553 is a military standard published by the United States Department of Defense that defines the mechanical, electrical, and functional characteristics of a serial data bus. It was originally designed for use with military avionics, but has also become commonly used in spacecraft On-Board-Data-Handling (OBDH) subsystems, both military and civil. It features a dual, redundant, balanced-line, physical layer; a (differential) network interface; time division multiplexing; half-duplex command/response protocol; and up to 31 remote terminals (devices).
-
product
Model Vector Network Analyzer
DZV-1
Digital Signal Technology, Inc.
DZV-1 is the vector network analyzer which can be measured the impedance and VSWR of the antenna, S Parameter of RF component and devices. It is small and low-priced. So, it is suitable for the production line, laboratory use, various testing applications, and the educational use. The communication between the DZV-1 unit and PC is done via USB, which is also used for power supply. The LOG-MAG characteristic, the phase-characteristic, the group delay frequency characteristics, the Smith chart, the polar coordinates, the SWR characteristic can be displayed on PC.
-
product
Virtual Network Infrastructure Validation
Cloud Peak
Network functions virtualization (NFV) is a key building block for 5G mobile networks, with network slicing or mobile edge computing (MEC) becoming possible. In the NFV architecture, various virtual network functions (VNF) run on a common NFV Infrastructure (NFVI) and are controlled by a common management and orchestration (MANO) layer.
-
product
Bias Network, 100 MHz to 12.4 GHz
11590B
The Keysight 11590B broadband high power bias networks can be used in a wide variety of biasing applications for test and measurement requirements in laboratory and production environments. Bias networks provide the means of supplying DC bias to the center conductor of the coax connector for your device while blocking the DC to the RF port.
-
product
WLAN Network Analyzer
NX-1
NX-1 is a high performance dual band wireless LAN network analyzer for SMB and Enterprise environments with 802.11a/b/g/n support. NX-1 provides an easy to understand simple menu that can be used even by those who are not familiar with specialized wireless LAN knowledge.
-
product
5uH Line Impedance Stabilisation Network LISN - CISPR 25
TBOH01
The TBOH01 5H LISN is a device required to setup conducted noise measurements of DC-powered devices. It is designed to be used for EMC pre-testing in the frequency range of 150kHz to 110 MHz.
-
product
2 Channels, MIL-STD-1553, Dual Redundant, Transformer Coupled, Assisted Mode Capable (AMC)
FTB
MIL-STD-1553 is a military standard published by the United States Department of Defense that defines the mechanical, electrical, and functional characteristics of a serial data bus. It was originally designed for use with military avionics, but has also become commonly used in spacecraft On-Board-Data-Handling (OBDH) subsystems, both military and civil. It features a dual, redundant, balanced-line, physical layer; a (differential) network interface; time division multiplexing; half-duplex command/response protocol; and up to 31 remote terminals (devices).
-
product
Isolated Controller Area Network (CAN)
ADI isolated controller area network (CAN) transceivers provide the differential physical layer interface between the data layer link, hardware protocol (for example, embedded in some of ADI's Blackfin® processors), and the physical wiring of the CAN bus. ADI's portfolio includes transceivers with integrated iCoupler® and isoPower® isolation, providing, fully isolated off-the-shelf CAN PHY's.
-
product
Wireless Network Penetration Testing
LGMS wireless network penetration testing uses automated and manual penetration techniques to locate and map authorized and unauthorized wireless access points, review corporate access point configuration and then discover weaknesses that could allow an attacker to penetrate those networks. Potential internal and external threats are documented, and a recommended action plan is developed to address any security risks.
-
product
Broadband Network Test
Whether testing via Voice Switch, DSLAM, OLT or external access device, Enghouse LoopCare comprehensively manages testing in mixed technology networks.
-
product
Cable Continuity Tester, HDMI 1.4 Mini, Network, 21.01 mm, 45.01 mm, 47.02 mm
72-9225
The 72-9225 is a Mini Cable Tester for HDMI 1.4 cable. Mini cable tester fits easily in your pocket or tool box.
-
product
Network Analyser And Diagnostics
Module Analyser
Module Analyser is a 5 in 1 easy to use CAN bus analyser with the following advantages:■ CAN and LIN monitoring via DBC/LDF/Fibex files ■ Automotive OBD ISO15765 Scan tool and UDS ISO14229■ J1939■ Integrated ODX/MDX editor■ Data acquisition and logging
-
product
Network Cable Testers
Companies expect their Ethernet twisted pair cabling to work flawlessly, but corners cut during design, installation and testing result in network downtime which translates to wasted resources and lost revenue. This can be avoided by cable installers that can install copper cabling systems and locate faults quickly.
-
product
Network Analyzer, Tester, RJ45/BNC, LED
72-9940
The 72-9940 is a RJ45 Cable Tester with LED meter display. The tester easily tests RJ45 and BNC network cables. It features remote testing which allows to test cables that are terminated at separate locations.
-
product
Wi-Fi Network Equipment Amplifiers
We offer discrete and integrated amplifier solutions for Wi-Fi network equipment. Our integrated Wi-Fi modules can include multiple power amplifiers, low noise amplifiers (LNAs), switch solutions, filters (band-edge, cellular coexistence, harmonic and out-of-band rejection), diplexers, power management and device matching.
-
product
Network Test LanCaster Pro ST
The NEW Lancaster Pro-ST is a low-cost wire map tester which tests and certifies structured cabling continuity to a TIA568A/B, USOC and ISDN standards. The new Lancaster Pro-ST displays on screen wiring configurations showing the length of all 4 pairs and length of pair to fault up to 150m (500ft).
-
product
PNA-X Microwave Network Analyzer
N5241A
Reach for unrivaled excellence in your measurements and designs Simplify your test stations by replacing racks and stacks of equipment Increase productivity with the most integrated and flexible single-connection microwave test engine Reduce test time with the worlds widest range of single-connection measurement applications Test linear and nonlinear device characterization more accurately with the world's best PNA-X Every spec verified, adjustments included Lock in support & peak performance from the start
-
product
Network Performance Testing
From homes and offices through to production plants: everyone is looking at network service providers and equipment manufacturers to ensure outstanding network performance for work and play. Yet, what is ‘outstanding’ network performance’ all about?
-
product
Control Networks
Modern facilities require up to date communications right down to plant level. Plant managers demand more information quicker than ever before. Process operators need full control facilities at all times of the day and night. Maintenance managers want information so that their services can be scheduled economically. To meet these requirements, design engineers include field communications networks to allow every piece of critical plant to be controlled and monitored by computer. These computers are assigned to management operations and maintenance tasks within their own network, exchanging data about the equipment and processes under their control.
-
product
1U Rackmount Network Appliance Platform With Intel® Xeon® Processor D-1527/ Pentium® Processor D1508 And 10 LANs
NA720
The NA720 is built on the server-class Intel® Xeon® D-1527 processor (codename: Broadwell-DE) and Pentium® processor D1508. The NA720 comes with two 10GbE SFP+ ports, eight Gigabit Ethernet ports and two expandable LAN modules supporting 1GbE/10GbE/Fiber/Copper/Bypass with a maximum of 26 LAN ports. Four DDR4-2400 MHz R-DIMM/U-DIMM sockets can provide system memory of up to 128GB and support both ECC and non-ECC memory types. For storage, it supports one mSATA and two 2.5” SATA hard disk drives. This high performance Intel® Broadwell-DE network appliance is an ideal solution for enterprise firewall, network bandwidth controller and UTM applications.
-
product
Network Protocol Analyzer
Wireshark
Wireshark is the world''s foremost network protocol analyzer. It lets you see what''s happening on your network at a microscopic level. It is the de facto (and often de jure) standard across many industries and educational institutions. Deep inspection of hundreds of protocols, with more being added all the time. Live capture and offline analysis. Standard three-pane packet browser. Multi-platform: Runs on Windows, Linux, macOS, Solaris, FreeBSD, NetBSD, and many others. Captured network data can be browsed via a GUI, or via the TTY-mode TShark utility.
-
product
804/1 Vector Network Analyzer Rack Mount Kit
This rack mount kit is for the Planar 804/1. It includes track slides and handles for the full size USB VNA.
-
product
Scalar Network Analyzers
An RF network analyzer used to measure amplitude properties like VSWR and Return loss of Device Under Test.
-
product
Vector Network Analyzer
Bode 100
With the multifunctional Bode 100 you get an exact picture of your electronic circuits and components in a frequency range from 1 Hz to 40 MHz. The Bode 100 is not only a state of the art Vector Network Analyzer, it also works as: Frequency Response Analyzer, Impedance Meter, Gain Phase Meter, Sine Wave Generator.
-
product
Network Analyzers
EPM07 Series
Dimensions:96X96 kVArh, Max, Min: available (available) RS-485: none (none) Digital Input:2 Pulse Output: available (available) CT-25: available (available) 110/230 VAC: none (none) 45-265 VAC/DC: available (available) Pcs. / Carton:
-
product
Digital OneWater Module for Collecting Live Data to Improve Wastewater Network Performance
Aqua DNA
Aqua DNA is an intelligent Digital OneWater solution that collects live data and improves wastewater network performance using smart sensors and AI-powered predictive analytics to reduce risk and make a positive societal and environmental impact.
-
product
1U Rackmount Network Appliance Platform With LGA1151 Socket Intel® Core™/Xeon® E-2100 Series Processor, Intel® C246/H310 And Up To 26 LANs
NA590
*LGA1151 socket 8th gen Intel® Core™/Xeon® E-2100 series processor (Coffee Lake)*Four DDR4-2666 U-DIMM for up to 64GB of memory*Max. up to twenty-six 10/100/1000 Mbps Ethernet ports*Two expandable LAN modules supporting 1GbE/10GbE/25GbE/40GbE/Fiber/Copper/Bypass*Supports 1U redundant power supply for optional*Supports IPMI/TPM for optional*Suitable for network security, cloud computing and data centers applications
-
product
Interactive Display Networking
Wireless interactive display that connects to the network and the display in a presentation or classroom environment
-
product
Device Networking
Offers complete control of how and when the application can discover, connect, disconnect, and get status from the USB device across the network.By integrating the SDK, you can create your own user interface and make it work seamlessly with your application.The SDK supports searching device servers on the network.Supports getting information and status from the USB device server.
