Product

Multi-spectrum Infrared Flame Detector

975MR

-

Emerson Rosemount

975MR - Emerson Rosemount

The Rosemount 975MR multi-spectrum infrared flame detector is based on accurately analyzing the multi-spectral signals by utilizing three separate IR sensors. The 975MR detects fuel and gas fires at long distances. For example, this product will detect a 1 ft2 (0.1m2) gasoline pan fire at 215 ft (65 m) in less than 5 seconds. The 975MR also provides the highest immunity to false alarms and enhanced overall coverage range.

Product

Industrial Gas Detector

OLCT 60

-

Teledyne Gas & Flame Detection

OLCT 60 - Teledyne Gas & Flame Detection

The OLCT 60AD version allows the sensor to be installed remotely up to 15 meters (standard), allowing detection in inaccessible locations, or in Zone 0 in the case of the intrinsically safe (IS) version. The detector units are made of 316L stainless steel, and are rugged and resistant to corrosion. Pre-calibrated sensors can be disconnected by turning the head of the unit. These “smart” sensors can be calibrated outside hazardous areas.The OLCT 60 is equipped with non-intrusive access to a safe menu. In hazardous areas, calibration can be done with an operating mode in accordance with safety rules.

Product

HIGH VOLTAGE MEGOHMMETER

MI-15KVe

-

MEGABRAS srl

MI-15KVe - MEGABRAS srl

The MI-15KVe High-Voltage Megohmmeter is a truly portable device that allows the measurement of insulation resistances using test voltages up to 15 kV. It employs a state-of-the-art technology for the safe measurements of insulation resistances up to 3.000.000 MΩ with four test voltages: 1 kV - 5 kV - 10 kV and 15 kV.

Product

Toxic Gas Detector

SMC 5100-XX-IT

-

MSA

SMC 5100-XX-IT - MSA

The SMC 5100-XX-IT gas detector monitors toxic gases such as Hydrogen Sulfide, Carbon Monoxide, Nitrogen Dioxide, Ammonia, Oxygen Deficiency, and others. The detector requires calibration only every six months, cutting operating costs and time.

Product

Amplitude Detectors

-

ERAVANT

ERAVANT

Amplitude detection, which eliminates the carrier (or the subcarrier) at the Doppler filter output

Product

VLF Voltage Generators

-

Fivestar HV Testing Equipment Co., Ltd.

Fivestar HV Testing Equipment Co., Ltd.

VLF hipot is an AC output tester with an output frequency of 0.1 Hz or lower rather than 50/60 Hz. Although the frequency is very low, it is an alternating current with polarity reversals every half cycle.

Product

Partial Discharge Detector

APD-ANNUNCIATOR

-

Amperis sl

APD-ANNUNCIATOR - Amperis sl

The APD-ANNUNCIATOR is a remote partial discharge detection equipment inside any energized cabinet. The probe is installed in the unit under test, instantly reporting its status. This equipment gives a great benefit because it avoids long term damage to the switching equipment.

Product

High Voltage Power Source

PM2000

-

Applied Test Resources

PM2000 - Applied Test Resources

The PM2000 is a high voltage power source capable of supplying up to 2000 V and sourcing 10mA to a load. The high potential at 2 kV fulfills coverage for mostly all semiconductor devices where leakage and breakdown measurements are involved. The module has been incorporated with interlock feature to ensure safety.

Product

Voltage Indicators & Detectors

-

Bierer & Associates, Inc

Bierer & Associates, Inc

Digital Voltage Detector is designed for easily indicating AC voltage on Underground primary, Over head primary and Transmission conductors up to 999 kV. The large digital display can be seen and read at distances up to 50'. Unit is perfect for large system voltages from 4kV to 765kV Phase to Phase.

Product

High Power/Anti-Surge/High-Voltage Resistors

ERJ-P Series

-

Panasonic Industrial Devices Sales Company of America

ERJ-P Series - Panasonic Industrial Devices Sales Company of America

Panasonic’s ERJ-P Series High Power Resistors offer the ability to use smaller case sizes while still maintaining the same level of power or better in respect to conventional size Thick Film Resistors. The ERJ-P Series has a unique trimming pattern and high heat dissipation characteristics. These parts can be easily designed as replacements for existing Thick Film Resistors due to comparable technology and materials with use of better manufacturing processes. The ERJ-P Series has an operating temperature of -55°C to 155°C, with a smaller part, you have a higher solder-joint reliability. Less material means less solder which lowers risk for solder fracture due to thermal expansion or contraction. Panasonic High Power Resistors are AEC-Q200 Qualified.

Product

DC Voltage Generator

MON8P

-

Holding Informtest

MON8P - Holding Informtest

Mezzanine MON8P is designed to generate DC voltage in the range of ± 10 V through eight galvanically isolated channels from each other and from the case, which allows to reduce the level of interference and increase the safety of the device.

Product

Current, Voltage, Resistance

-

Mensor Corp.

Mensor Corp.

Solutions for the testing and calibration of current, voltage and resistance are used in industry (laboratories, production, workshops), in calibration service companies and in quality assurance. These instruments are portable and mobile and are particularly notable for their low measurement uncertainty and high scope of operation.

Product

Detector

LM-Si

-

Eddy Co.

LM-Si - Eddy Co.

Silicon Detector (Range: 400 - 1100 nm)

Product

RFI Detector Meter

MFJ-805

-

MFJ Enterprises, Inc.

MFJ-805 - MFJ Enterprises, Inc.

Use this ultra-sensitive pocket-sized RFI Detector to track down and eliminates RFI caused by radiating cables and wires. Usable from VLF to VHF. Gain adjustable over 50dB range.

Product

Air Tightness Detector

FQ

-

Fuzhou Fuguang Electronics Co., Ltd.

FQ - Fuzhou Fuguang Electronics Co., Ltd.

FQ series air tightness tester is the latest high-precision non-destructive testing equipment developed by Fuguang Electronics. The equipment mainly uses compressed air as the medium to apply a certain pressure to the inner cavity or surface of the product to be tested, and then uses a high-sensitivity sensor to detect changes in pressure to determine the tightness of the product to be tested.

Product

Radiation Detectors

-

PCE Instruments

PCE Instruments

A radiation detector is a device for measuring nuclear, electromagnetic or light radiation. A nuclear radiation detector identifies nuclear radiation by measuring the emission of ionizing radiation of alpha particles, beta particles and gamma rays. Also referred to as a geiger counter, a nuclear radiation detector consists of two main elements: the processing electronics and the geiger tube. The geiger tube is filled with low-pressure inert gas like helium, argon or neon. If radioactive radiation occurs, the inert gas is ionized. An anode within the geiger tube registers the quantity of ionized particles numerically correlating with the strength of the radioactive radiation. The radioactivity measurement is then displayed on the LCD screen of the geiger counter or nuclear radiation detector.

Product

Low Voltage Regulation

-

A. Eberle GmbH & Co. KG

A. Eberle GmbH & Co. KG

The low voltage regulation system LVRSys represents a cost effective alternative for grid expansion. The economic use is recommended in all low voltage grids where short-circuit power is sufficient, but have voltage maintenance problems.

Product

Phantom Surface/Web Metal Detector

-

Fortress Technology Inc.

Fortress Technology Inc.

Phantom Surface Web Metal Detection systems are designed to detect metallic fragments in wide, sheeted materials, continuous webs, and other thin products like textiles, paper, boards, food packaging, boxboard, poly films or products packaged on a roll/web.

Product

Portable Flaw Detector

EPOCH 6LT

-

Olympus Corp.

EPOCH 6LT - Olympus Corp.

Portable and easy to use, the EPOCH 6LT flaw detector is an ergonomic, rugged instrument that delivers user comfort and more uptime. Weighs just 1.95 pounds (890 g) with a grip-oriented weight distribution for one-handed operation with minimal wrist fatigue. Rotary knob and simple button design make it easy to use, even when wearing gloves. Engineered to IP65/67 and drop tested. Clear, bright screen for readable A-scans in any light. The EPOCH 6LT flaw detector’s workflow is simple and straightforward. Despite the instrument’s small size, it has the features and functions to meet the requirements of nearly any conventional ultrasonic inspection application.

Product

High Voltage Probes

-

North Star High Voltage

North Star High Voltage

High voltage measurements have a variety of different requirements, and our PVM series and VD series probes are designed for most of these requirements. The PVM probes are designed for wide bandwidth and ease of portability where a variety of measurements must be made. The VD series probes are designed for use at higher voltage ranges, and where physical stability is required.

Product

Wildfires  Detector

-

Raymetrics S.A.

Raymetrics S.A.

Three-dimensional coverage system for remote fire detection3D