Vibration Sensors
Sensors used for measuring, displaying and analyzing linear velocity, displacement and proximity, or else acceleration. They can be used on a stand-alone basis, or in conjunction with a data acquisition system. (sensors-transducers.globalspec.com)
See Also: Vibration Test
-
product
Environmental Vibration
The monitoring of environmental and ground vibration is required because vibration can cause both damage to local structures and distress to nearby residents. There are many sources of environmental vibration where monitoring is required, common sources are Civil Engineering Works, Quarrying and Blasting, Construction Sites and road works.
-
product
Stand-Alone Current Sensors
The Aanderaa Current Sensors are based on the backscatter acoustic Doppler principle.
-
product
Image Sensor Characterization Systems
Image Sensor QE and Spectral Responsivity Characterization
-
product
3D Sensor (Shiny Surfaces)
reflectCONTROL
reflectCONTROL is designed specifically to meet the high quality requirements that ensure high quality for shiny surfaces. The system based on deflectometry projects a striped pattern onto the measurement object. Defects on the surface cause deviations from the striped pattern which are recorded by cameras and evaluated by software.
-
product
Pressure Sensor
2450
The Signet 2450 Pressure Sensor has a one-piece injection-molded PVDF body and ceramic diaphragm for superior compatibility in corrosive liquids. Three pressure range versions allow for optimal resolution matched to your sensing needs. Solid state circuitry eliminates drift (no internal potentiometers.) Built-in temperature compensation provides outstanding accuracy over wide temperature ranges.
-
product
Oxygen Sensor
KS60001
Konstar Electric Industrial Co., Ltd
An oxygen sensor, also known as a lambda sensor, continually detects the oxygen content in the exhaust gases of an engine. The oxygen sensor output signal informs the vehicle's ECU (Electronic Control Unit) whether the AFR (Air-Fuel Ratio) is lean or rich. Based on this, the ECU adjusts the amount of fuel injected into the engine to achieve an optimal AFR.
-
product
Humidity Sensors
Senses, measures and reports the relative humidity in the air. It therefore measures both moisture and air temperature.
-
product
Vibrating Sample Magnetometer
VSM-5
This type measures on variations of temperature as well as yet normal room temperature under vacuum and in gas by the use of electromagnet.
-
product
General Purpose Pressure Sensors For High Frequency
PCB® Series 113B dynamic pressure sensors set the standard for extremely fast, micro-second response with a wide amplitude and frequency range. These characteristics allow them to excel in high-frequency applications, where minimum sensor diameter is required.
-
product
CAN Sensor/ Interface
Current
Reach Technologies’ CAN Current Sensors sense and digitize conductor current for collection via CAN. The module is ideal for conveniently adding current data to a distributed CAN network. The CAN Current Sensor is configurable via J1939 or CANopen stacks, and are available in Hall Effect and shunt variants.
-
product
Noise And Vibration Tester
In a miniaturized motor, even the slightest rumbling sound that occurs during rotation can be a cause for failure.
-
product
Sensors
YUEQING WINSTON ELECTRIC CO., LTD
Expansion sleeve is a keyless connection device, its principle and use is through the action of high strength tensile bolt, between the inner ring and shaft, between the outer ring and the hub of a huge holding force, in order to achieve the keyless connection between the parts and the shaft.
-
product
Vibrational Analysis
GEMINI-2
GEMINI-2 is the compact solution for HVSR, MASW and Vibrational Analysis: a single waterproof container with integrated high-performance 3D geophone and low resonance frequency (2Hz sensors, suitably coupled) and a powerful real 24-bit acquisition card with USB port for connection to an external PC.
-
product
Conductivity Sensors
Conductivity sensors measure the specific conductance of liquid processes. The specific conductance is directly related to the presence of ionic species and their concentration. Barben Analytical offers a full range of two electrode and four electrode contacting conductivity sensors for a variety of industrial measurement applications.
-
product
Line Scan Sensors
The CMOS line scan image sensor family from ams consists of 23 variants, offering a range of resolution and pixel size specifications. Resolution options range from 2kpixels up to 16kpixels and line rates extend up to 80,000 lines/s.
-
product
Instrument Grade Data Sensor
WISER 8000
TECAT Performance Systems, LLC
The TECAT WISER Model 8000 dual strain measurement and monitoring system is a wireless data acquisition system for measuring two external strain channels at high data rates up to 8kHz. The small, light, power-efficient, and non-invasive design enables strain measurements in a wide range of applications. With dual external sensor inputs two Micro-Measurements strain gauge bridges can be measured by a single system, for example to measure both thrust and torque loads simultaneously.The Model 8000 has a long range data transmission of >1,000 meters with up to +/- 0.025% FSR sensitivity for remote measurements. After initial setup using the WISER software interface, the system can be wired directly to your DAQ system, for seamless data collection.
-
product
Lightning Warning Sensors
Lightning warning sensors measure the local, atmospheric electric field at the earths’ surface and the fluctuations in field strength. By monitoring the field strength, the potential for cloud-to-ground (CG) lightning discharges can be detected, and advance warning can be made when conditions are becoming favorable for lightning.
-
product
Hall Sensor Board with I2C Interface
050-382
Version: +5V/15A +12V/15A -5V/15A -12V/15A The Hall-Sensor Board is the right accessory for your system in combination with the Elma SysMon. It's possible to measure up to 4 currents and to monitor them with the Elma SysMon 3 Gen.
-
product
Glare Sensors
The Glare sensor detects and distinguishes glare on even surfaces. It also provides maximum reliability and saves costs. Previously, gloss on object surfaces was a disruptive factor that regularly had engineers breaking into a sweat.Now, gloss properties are a distinguishing criterion for process control – regardless of color, transparency or pattern. And it will be engineers’ eyes that shine, not their brows. Equipped with intelligent Delta-S-Technology, Glare is a further milestone in customer-oriented sensor development. Once again, SICK is confirming its leading position in opto-electronic sensors for the detection of a range of objects.
-
product
Digital Pressure Sensor
PPX
30mm compact 2-screen/3-color display pressure sensor.It is a digital pressure sensor packed with ease of use and high functionality such as a dual screen display that allows you to check the (current value) and (set value) of pressure at the same time, a three-color display, a setting content copy function, and three mode settings.
-
product
Fiber Photodiode Power Sensors
These interfaces provide communication between an attached sensor and a PC or other external control unit. They are designed to be controlled via an external device or operated autonomously using the analog output; there are no controls or display screens.
-
product
OMNIR: On-Line Near Infrared Sensor
OMNIR is the future of near infrared moisture sensing technology. Coming from OMNI, meaning “all” and NIR, meaning “near infrared,” Finna Sensors has created an intelligent all-sensing solution that exceeds expectations. It not only delivers accurate data instantaneously and non-destructively, it also monitors its own health to perform its best during your crucial processing moments. By selectively harnessing light, to ensure increased uptime and greater profitability for your operation, the future of your manufacturing operation starts now.
-
product
Medical Oxygen Sensors
Teledyne Analytical Instruments
Medical Oxygen Sensors by Teledyne Analytical Instruments
-
product
Vibration Testing
Sanwood Environmental Chambers Co ., Ltd.
Sanwood , a 23 years of professional Vibration Test System for Automotive parts, vibration table, vibration machine, Electromagnetic vibration table, Vibration Test Chamber manufacturers
-
-
product
Piezoelectric Vibration Pickup
PU-8ALT6
*Upper outlet*Built-in amplifier*Use up to 150 ℃ enabled
-
product
Sensors
2D Fiber Probe
Smallest and most accurate probe for 2D evaluations world-wideMechanical fiber sensor with optical evaluation from image processorTransmitted light and self illumination modeLowest contact force of 1 µNSphere diameters down to 25 µmControl and evaluation software for fully automatic measurements
-
product
VibA(8) Hand-Arm And Whole-Body Vibration System
The all NEW VibA(8) from Castle Group Ltd takes Hand Arm & Whole Body Vibration measurement to a whole new level! Ultra-simple to use and dedicated to compliance with the Control of Vibration at Work Regulations 2005, the VibA(8) delivers the ultimate practical solution to quantifying the vibration level of tools on your site.
-
-
product
Housed Temperature Sensors
Exhaust Gas Temperature Sensors from Variohm are rich in pedigree for Motorsports success and with a strong reputation for high reliability and durability across a broad spectrum of applications for exhaust gas monitoring. The Exhaust Gas Temperature Sensors are based around a type K thermocouple in a robust design which has been well proven in Motorsport and similar demanding environments.
