Product

MIL-STD-1553 Test & Simulation Interface for VME

VME-1553

-

Avionics Interface Technologies

VME-1553 - Avionics Interface Technologies

Dual redundant, single, dual, or quad stream configurationsTransformer & Direct Bus Coupling - Concurrent Bus Controller, 31 Remote Terminals, & Bus Monitor operation - Full error injection and detection - Multi-level trigger for capture and filtering - IRIG-B time code encoder/decoder - Ten high voltage (up to 30V) programmable DIO lines - Real-Time recording and physical bus replay - ANSI Application interface supporting C, C++, C#, and .NET development - Device driver support: Windows, Linux, & VxWorks (others on request) - Designed for extended temperature operations - 64-bit VME Interface (VME master & slave capability) - Front Panel and Rear I/O (P2) Available

Product

DC Programmable Electronic Load

ELCH300

-

Aplab Limited

ELCH300 - Aplab Limited

- VFD display- High resolution 0.1mA/1mV- Voltage range 0V to 500V- Working mode CV/CC/CW/CR/OV/OC/- OP/OT protection- Communication: USB/RS232/GPIB

Product

Programmable 70W Electronic Load

MightyWatt R3

-

kaktus circuits

MightyWatt R3 - kaktus circuits

The All-New MightyWatt revision 3 turns your Arduino Uno R3 or Arduino Zero (M0/M0 Pro) into an electronic load capable of dissipating 70 Watts in a very small form factor. Ideal for testing power supplies, batteries, solar cells, fuel cells or power amplifiers. MightyWatt R3 has a research-grade electronics and is aimed not only at hobbyists but also at professionals.

Product

Automatic Oil Insulation Test Kit

-

Sivananda Electronics

Sivananda Electronics

The test kit is fully automatic and has the facility forAuto/Manual selections. The operator simply needs thesample in the test vessel & selects the required test. Testingcan be done as per many international ( IEC & Europeanstandards ) which are programmed into the instrumentmemory . Stand time, Stir times & Rate of rise of appliedvoltage can be selected in Custom Mode also , one setof such selected mode can also be stored in the memory. In addition to the above set can also perform withstand test(proof) tests. In this test the set allows the set voltage to pre-set value & hold for one minute to see if breakdown occurs. The backlit LCD is used for user friendly operationsduring the test process. It also display fault condition messages such as open ground and cover open . All the user selected programmes are chosen through(4x3) key pad.The test results can be printed along with with test type, date, time, breakdown test voltage, averages and deviations. Voltage value can be measured & printed with a resolution of 0.1kV. In reprint option it is possible to have number of printouts for the last test. For each test the readings are recorded and stored in memory.

Product

Arbitrary Waveform Generators

Proteus Series

-

Tabor Electronics Ltd.

Proteus Series - Tabor Electronics Ltd.

The new Proteus Arbitrary Waveform Generator is ideal for applications in Quantum Computing, Electronic Warfare, Radar, and next generation communications such as 5G, 6G, Ultrawide Bandwidth (UWB), and WiFi (802.11) 6 and 7. Built on the latest RF DAC and RF ADC technology, the series has sample rates up to 9GS/s and multiple Nyquist zone frequency range capability in excess of 10GHz. It’s an innovative task oriented programming environment, and user programmable FPGA. When used in combination with its optional RF Digitizer it gives you the ability to change waveforms in real-time - ideal for improving the coherence time of a Qubit, characterizing an RF amplifier, or responding to an EW threat.

Product

Programmable Electronic DC Loads

-

ET System Electronic GmbH

ET System Electronic GmbH

Programmable Electronic DC Loads.

Product

DC Bench Power

-

AMETEK Programmable Power, Inc.

AMETEK Programmable Power, Inc.

From benchtop supplies to rack mounted industrial power subsystems, AMETEK Programmable Power is the design and manufacturing leader of precision, programmable power supplies. The voltage range for the AMETEK DC bench supplies is 7V to 600V and the current range is 0A to 1,000A producing a power output of 0W to 840W. Select from the models above to find the right fit for your application.

Product

Isolated Programmable Multifunction Counter Board

APCI-1710-24V

-

TEAM SOLUTIONS, INC.

APCI-1710-24V - TEAM SOLUTIONS, INC.

Wide application possibilities through free combination4 modules with numerous functions quickly and easily programmableEach of the 4 modules is programmed with a function. The 4 modules can either be programmed with the same function or freely be combined with 4 different functions.

Product

3-Ch 200 MHz A/D with DDC & 2-Ch 800 MHz D/A with DUC, Kintex UltraScale - 3UVPX

Model 54821

-

Mercury

Model 54821 - Mercury

- Jade Xilinx Kintex UltraScale FPGA Products and Navigator Design Suite Software Video- Jade Xilinx Kintex UltraScale FPGA Family Brochure- Exceptional dynamic range/analog signal integrity- Xilinx® Kintex® UltraScale" FPGA- Compatible with several VITA standards including: VITA 66.5, VITA 67.2 and VITA 67.3C- Three 200 MHz 16-bit A/Ds- Three multiband DDCs (digital downconverters)- One DUC (digital upconverter)- Two 800 MHz 16-bit D/As- 5 GB of 2400 DDR4 SDRAM- Programmable frequency synthesizedsample clock generator- Sample clock synchronization to an external system reference- Powerful DMA controllers for moving data- PCI Express (Gen. 1, 2 & 3) interface up to x8- Multi-channel synchronization with clock/sync bus- Optional clock/sync generator for multi-board systems- Optional gigabit serial links for custom FPGA I/O- Optional LVDS port and gigabit serial links for custom FPGA I/O- Ruggedized and conduction-cooled versions available- Synchronize up to eight modules with Model 7893 System Synchronization and Distribution Amplifier - PCIe

Product

DC Electronic Load

Model - KM-mPD-501

-

Kusam Electrical Industries Limited

Model - KM-mPD-501 - Kusam Electrical Industries Limited

KM-mPD-501 DC electronic load mainly focuses on the testing of power circuit on PCB. KM-mPD-501 offers a solution for function test of Switch step up, Stepdown, Regulators and Driver IC . Engineer puts components, such as CPU, DSP, FPGA; etc on a PCB after the power circuit has been tested. It’s not complete to use a meter to measure the voltage. KM-mPD-501 offers engineer OVP, OCP and OPP functions that help engineer know the value of overload current . On the other hand, engineer can use a programmable DC power supply (mPP series) to offer external power and connect PCB’s output to KM-mPD-501. Then engineer can easily get output watt, figure out the efficiency of power circuit and check if inductances, capacitances and resistances perfectly work with the power circuit. KM-mPD-501 not only offers loading emulation of current but also provides OVP and OPP. User can use these functions to test solar power battery, rechargeable battery and motor driver. In school laboratory, KM-mPD-501 helps students do experiment on power circuit, linear circuit and driver circuit.

Product

Low Power Programmable AC Source with Transients

61500 Series

-

Chroma Systems Solutions, Inc.

61500 Series - Chroma Systems Solutions, Inc.

Power:500VA (61501)1500VA (61503)2000VA (61504)4000VA (61505)Voltage range: 0-150V/0-300V/AutoCompact size and weight attributable to advance PWM technologyAC+DC output mode for voltage DC offset simulationProgrammable slew rate setting for changing voltage and frequencyLow output impedance for testing IEC 61000-3-2 (61505)Programmable output impedance for testing IEC 61000-3-3LIST, PULSE, STEP mode function for testing power line disturbance (PLD) simulation capabilityIEC 61000-4-11 voltage dips, short and variation simulationHarmonics, inter-harmonics waveform synthesizer for testing IEC 61000-4-13Programmable voltage, current limitComprehensive measurement capability, including current harmonicsHigh output current crest factor, ideal for inrush current testingTurn on, turn off phase angle controlTTL signal which indicates output transientAnalog programmable interface3 units combined to 3-phase power outputEasy-use software for operation and IEC regulation testOptional GPIB and RS-232C interface

Product

Switching Amplifiers

-

ifm efector, inc.

ifm efector, inc.

*One- or two-channel design*Small design requiring only very little space*Programmable output function*Relay or transistor outputs*Easy mounting on DIN rail

Product

Photosynthesis System

LCpro-SD

-

Opti-Sciences, Inc.

LCpro-SD - Opti-Sciences, Inc.

The LCpro-SD offers laboratory grade experimental performance in a truly portable device. Featuring ADC's highly accurate miniaturized infrared gas analyzer, the LCpro-SD is, at 4.5kg or 10lbs., less than half the weight and half the size of conventional systems offering full environmental control. Ideal for A/Ci curves, and A/Q curves, measuring step sequences are full programmable.

Product

Programmable Power Supplies

GENESYS+™ Rack DC Power Systems

-

TDK-Lambda Corp.

GENESYS+™ Rack DC Power Systems - TDK-Lambda Corp.

The GENESYS+™ High Power Programmable Rack DC Power System platform provides advanced features in a light-weight portable high power density profile with a comprehensive set of built-in user-friendly interfaces that include a multi-functional front panel, LAN (LXI 1.5), USB (2.0), RS-232/RS-485 and Isolated Analog (5V/10V) along with several optional digital communication interfaces (IEEE, EtherCAT or Modbus-TCP).

Product

Programmable DC Power Supply

SPD3303X / SPD3303X-E Series

-

SIGLENT Technologies

SPD3303X / SPD3303X-E Series - SIGLENT Technologies

Siglent’s SPD3000X Series Programmable Linear DC Power Supply has a 4.3 inch TFT-LCD display, supports Remote Programming and has a Real Time Wave Display. The ‘3000X family has three isolated outputs; two adjustable channels and one selectable channel from 2.5v, 3.3V, and 5V. It also has output short and overload protection and can be used in production and development.

Product

Power Supply Support

-

Renesas Electronics Corp.

Renesas Electronics Corp.

Renesas offers a complete portfolio of system supervisory solutions ranging from single to quintuple (five) voltage monitors. In addition, the system management ICs are voltage monitors with small amounts of I2C or SPI software programmable EEPROM memory. Renesas single-chip sequencing solutions sequence up to four different voltages while providing other useful features such as voltage monitoring, fault protection, and reset assertion.

Product

Programmable MEMS Tilt Switch

SQ-PTS

-

SignalQuest

SQ-PTS - SignalQuest

The tilt sensor module provides a digital level output if pre-programmed angle thresholds are exceeded.  The two standard digital outputs can be configured at the factory as two different angle thresholds.  In addition 4 additional input/output lines can be factory configured for a variety of functions on a semi-custom basis, greatly simplifying designs that require accurate, reliable angle detection. 

Product

Electronic Toy Tester

-

Aveno Technology CO., LTD.

Aveno Technology CO., LTD.

Programmable ultra high resistance tester is used to test the high resistance of different kinds of material.

Product

Programmer VP-798

-

TOMSAD

TOMSAD

*Usb programmer for working with 42215 devices. Base is regular updated.*Software according with  XP ~ 10

Product

Low Power FPGA Featuring Hardened MIPI D-PHY, LVDS, SLVS, SubLVDS, & Open LDI Bridging

CrossLink

-

Lattice Semiconductor

CrossLink - Lattice Semiconductor

*Two 4-lane MIPI D-PHY transceivers at 6 Gbps per PHY*15 programmable source synchronous I/O pairs for camera and display interfacing*Available in amazingly small 2.46 mm x 2.46 mm WLCSP packages and BGA packages with 0.4 mm, 0.5 mm and 0.65 mm pitch