Product

High Accuracy In-Situ Mass Flow Verifier

HA-MFV

-

MKS Instruments

HA-MFV - MKS Instruments

The HA-MFV, High Accuracy Mass Flow Verifier is designed for use on process tools to verify mass flow control flow rates in-situ. Available with EtherCAT® or DeviceNet™ communications and measurement accuracy of 1.0% of reading, the HA-MFV can verify MFC flow with the actual process gas significantly better than older rate-of-rise devices or process chamber rate-of rise methods.

Product

High Pressure Sensors

-

Honeywell Industrial Automation

Honeywell Industrial Automation

Honeywell Sensotec is among a handful of companies offering pressure sensors that can measure pressure up to 200,000 psi with superior accuracy and reliability. Foil based strain gauge technology enables our pressure sensors to withstand pressure that would destroy silicon based or micromachined pressure sensors.

Product

High Voltage Surge Current Monitors

HVSCM

-

Test Electronics

HVSCM - Test Electronics

Designed to be used with the Model HVST High Voltage Surge tester. The Surge Current Monitor allows simultaneously surge testing 20 units. The Surge Current Monitor monitors the current going through each unit under test at the time of the surge. If a unit under test breaks down or leaks, the Surge Current Monitor will identify the bad unit by lighting the corresponding LED. The most important features of the surge tester are its ability to test the entire winding insulation system. A high voltage surge generates turn to turn, coil to coil, and phase to phase voltage stress, as well as ground insulation stress. When used as a dielectric test, accurate voltage readings are essential. The HV Surge Tester monitors the voltage directly across the winding under test. In production testing we expect that most of the time the devices will pass. In the event that one should fail, the failed device would be removed and then all the parts would have ot undergo another surge test. Since most devices pass most of the time, simultaneous surge testing can be a real time saver.

Product

Raptor HV High Voltage Tester

-

EUROSMC, S.A.

EUROSMC, S.A.

The Raptor-HV, also called the high voltage slave, is an optional product that extends the Raptor’s applications to tests that require the use of a moderately high AC voltage.

Product

High density, ESA approved PCB connector

KMC Series

-

Smiths Interconnect

KMC Series - Smiths Interconnect

Smiths Interconnect's KMC series is an ESA qualified, high density board to board and board to wire interconnect available in multiple configurations from 26 to 162 positions

Product

64 Points High Density Terminal Module

HSL-TB64

-

ADLINK Technology Inc.

HSL-TB64 - ADLINK Technology Inc.

*Field I/O wiring connection for HSL I/O modules*Spring terminal for easy field wiring*Power and ground included for each signal channel*Interlocking design for rugged installation*Power LED indicator*DIN rail mounting

Product

High Voltage Power Sources

-

Electronic Test & Power Systems

Electronic Test & Power Systems

A comprehensive range of high voltage power sources are available from ETPS. Product families range from programmable high precision laboratory power supplies to HV Cassettes and PCB modules.

Product

High Speed Cable Production Tester

GRL-V-DI20

-

Granite River Labs Inc.

GRL-V-DI20 - Granite River Labs Inc.

GRL-V-DI20 provides a fast and easy way for anyone to test cables for manufacturing defects and signal integrity specification requirements. GRL-V-DI20 provides comprehensive test coverage in seconds at a fraction of the cost of similarly-capable bench test equipment.

Product

High Performance Data Acquisition

PMC-AD8

-

ALPHI Technology Corporation

PMC-AD8 - ALPHI Technology Corporation

The PMC-AD8 module provides a high performance dataacquisition subsystem. There are (8) eight 200 KSPSADC’s for maximum performance. The Local DSP can beused to simply move data samples to the PMCbus or canprovide processing functions such as limit checking, FFT’s,digital filtering, etc. Software can be downloaded to theDSP via the PMC interface. Instrumentation amplifiersprovide over-voltage protection and gain on a per channelbasis. The PMC-AD8 can also accept external scan andtrigger signals from a front panel connector.

Product

High Voltage

-

Mess- & Prüfsysteme GmbH

Mess- & Prüfsysteme GmbH

Accurate measurement of high voltages acc. to VDE 0432 und IEC 60060 in conjunction with a high voltage divider.For the measurement, the principle of capacitive or resistive divider is used, which can be selected in the peak voltage meter.

Product

High Speed Load Cell Test Interface

LCIC-4CH

-

Industrial Measurement Systems Ltd.

LCIC-4CH - Industrial Measurement Systems Ltd.

The latest stand-alone controller model: LCIC-4CH, was specially designed to fit portable wheel and axle scales for determining the weight of trucks or heavy vehicles either in static mode or in motion, with very high accuracy and very friendly to operate. The In-motion speeds up the weighing process and allows weighing a truck without the need to stop.In the last 16 years, our stand-alone High-Speed weighing-in-motion controller model: LCIC-WIM was sold all around the world and as for today, thousands are being in use when among our customers are some well known weighing manufacturers.Most of our customers around the world are scale manufacturers or integrators that were able to offer the market the most advanced WIM scale with very short time to market and minimum R&D expenses.

Product

High Spectral Rate and High Dynamic Range Miniature Spectrometers

VS70-HSR & VS70-HDR

-

HORIBA, Ltd.

VS70-HSR & VS70-HDR - HORIBA, Ltd.

VS70 is a high performance compact fiber coupled spectrometer system covering wide spectral range of 200 to 1050 nm. This OEM optical module is built around Horiba’stype-IV Aberration-Corrected Flat-Field Holographic Ion-Etched concave grating and is specially designed to easily adapt to a large variety of detectors and electronic drivers. This system is fitted with a custom variable order-sorting filter to eliminate higher orders.

Product

High Voltage Probe: Single-Ended

-

Tektronix, Inc.

Tektronix, Inc.

A high voltage single-ended probe is typically used for measuring ground referenced signals up to 40 kV. However, some single-ended probes are designed for oscilloscopes with isolated or floating inputs for measurements that are not ground referenced. Users should select probes with a low input capacitance specification (< 4 pF) to minimize the probe’s loading effect on the circuit because a probe with lower input capacitance will offer higher input impedance at higher frequencies.

Product

High Frequency Noise Simulator

SKS-H04GA

-

Shanghai Sanki Electronic Industries Co., Ltd.

SKS-H04GA - Shanghai Sanki Electronic Industries Co., Ltd.

The high-frequency noise simulation generator is an EMC test instrument that reproduces high-frequency noise with a fast rise time when the switch is turned on/off. Since the pulse rise time is less than 1ns and contains wide bandwidth noise, it is very suitable for reproducing malfunctions. The line noise entering the power line and the induced noise entering the communication line can be reproduced, and the performance evaluation of the malfunction and function degradation of electronic products can be performed.

Product

High Speed Comparators (<100ns Propagation Delay)

-

Analog Devices Inc.

Analog Devices Inc.

Analog Devices high speed comparators feature <100 ns propagation delay and are a versatile and easy to use solution for a range of applications. Owing to our proprietary CB and XFCB fabrication processes, our comparators such as the AD790 possess a fast response time with outstanding input voltage resolution.

Product

High Voltage SMU 2500 V

AXV7607

-

VX Instruments GmbH

AXV7607 - VX Instruments GmbH

Generate extremely short, fully regulated voltage pulses of up to 2500 V. Measure leakage currents up to the pA range.

Product

High Voltage Breakdown Test Sets

HT-Series

-

Becker & Hickl GmbH

HT-Series - Becker & Hickl GmbH

Dielectric Voltage Withstand Test or High Potential Test (HIPOT test) is a 100% production line test to verify the quality & electrical safety characteristics of products.

Product

InGaAs Camera with High Image Resolution

Cheetah Series

-

Xenics

Cheetah Series - Xenics

The Cheetah 640 series is based on a cooled, in-house developed InGaAs detector with a 640 x 512 pixel resolution. The Cheetah 640 camera with single-stage TE-cooled detector offers high frame rates of either 400 Hz, 800 Hz or 1700 Hz while the version with three-stage TE-cooled detector offers a frame rate of up to 110 Hz. The camera comes with a CameraLink interface.