X Band
Radio band in the frequency range of 8.0 to 12.0 GHz and a wavelength 3.75 to 2.5 cm.
See Also: Radar
-
Product
Car-to-X Signal Strength Emulator
-
Qosmotec Software Solutions GmbH
QPER-C2X is a special adaptation of the signal strength emulator QPER, designed for mobile and Vehicular Ad-hoc Networks (MANet and VANet). Every radio devices in such an infrastructure-less network acts as a sender, receiver, and forwarder (router). Therefore, the ports of the QPER-C2X hardware are fully connected with each other by dynamically controllable attenuators. The system is fully designed for frequencies up to 6 GHz, since wireless communication for Intelligent Transport Systems (ITS) is based on the WLAN standard IEE 802.11p from 5.850 MHz to 5.925 MHz. The connected ITS stations can be either on-board units, as they are built into cars, or road side units that are used by road infrastructure (traffic lights, road work area delimiters, velocity signs). For tests in the lab, radio modules of such ITS stations are each kept in a shielding box that prevents any unwanted radiation over the air.
-
Product
Module Accessory Kit, Quantity 26 2-56 x .25" Button Head Screws Stainless Steel
510109374
Accessory Kit
Used with modules: 510104287.
-
Product
VHF Band 1.0 Watt Amplifier With RF Bypass
-
Teledyne RF & Microwave has developed a 35 to 350 MHz custom amplifier with 1 watt output power. The amplifier has 29 dB gain with 3 dB noise figure. The amplifier assembly has a RF switch so that the RF input can be connected directly to the output bypassing the amplifier. The amplifier goes into the "bypass" state when the DC bias is removed from the switch. This unit is one of a series of amplifiers that covers the 1 MHz to 2100 MHz with similar operation.
-
Product
Digital Roller Brake Tester for Cars and Vans up to 3.5 T Axle Load with 2 x 3 kW Drive Motors and Max. Track Width of 2,500mm
C_MBT C 3.5 W250 | VP 210153
-
Maschinenbau Haldenwang GmbH & Co. KG.
Digital roller brake tester for cars and vans up to 3.5 t axle load with 2 x 3 kW drive motors and a max. track width of 2,500 mm.Particularly suitable as stand-alone tester or as part of car reception and diagnostic test lanes for larger vehicles such as SUVs, off-roaders or vans.
-
Product
6.5" 640 X 480, VGA/DVI Interface, Ultra Slim Touch Open Frame Monitor
IDS-3106
-
6.5" 640 x 480 VGA panel with LED backlight for 20% power saving and environmental protection, 0~50° C wide operating temperature support, 4-wires resistive touchscreen solution.
-
Product
Industrial Communication Gateway With TI Cortex A9, 2 X LAN & 4 COM
ECU-1251 V2
-
Cortex A9 600MHz processor with 2G RAM16GB eMMC system storage and 1 x Micro-SD Slot4 x RS-232/485 isolated serial ports2 x 10/100 Ethernet ports and 1x mPCIe for wireless communication expansionSupport web service for remotely on-line monitoringSupports SD cards and OTA firmware updatesEdgeLink IoT software for data acquisition and cloud communicationWide Operating temperature: -40 ~ 70°C
-
Product
Module Accessory Kit, Quantity 26 2-56 x .19" Flat Head Phillips Screws 100 Degree
510109368
Accessory Kit
Used with modules: 510104287, 510104289 and 510108125.
-
Product
X, Y, Θ Position Calibration Plate For Machine Vision and Microscopy
nanoGPS OxyO Scale
-
nanoGPS OxyO® Scale is a position calibration plate for Machine Vision and Microscopy, available as OEM or stand-alone solution from HORIBA Scientific.nanoGPS OxyO® technology is based on taking a picture of a patented patterned substrate, and interpreting this picture into position (x, y) and orientation (θ). The nanoGPS OxyO® Encoder is also based on this technology.
-
Product
Chrome-Plated Phillips Head (No. 10-16 x 3/4) Screws
HW-1
-
HW-1: Package of 100 decorative, chrome-plated Phillips head (No. 10-16 x 3/4) screws with protective nylon washers.
-
Product
Low Noise Dual Band VCO
-
This custom oscillator subassembly consists of two low noise oscillators covering 1.5 to 2.5 GHz, a power combiner, a standard Teledyne RF & Microwave amplifier, and a lowpass microstrip filter. Teledyne RF & Microwave designed both oscillators for low phase noise and linear tuning. The output frequency bands are switched using standard TTL control.
-
Product
Module Accessory Kit, Quantity 26 2-56 x .25" Flat Head Phillips Screws Stainless Steel
510109373
Accessory Kit
Used with modules: 510104249, 510104267 and 510104289.
-
Product
Cable, 96-Pin 1.27mm Pitch Female, Spring Latches To 2 X 50-Pin, Female, Adaptor Lead, 2m
A096SFR-02F050Z5A200
Cable Assembly
The 96-Pin Pitch to 50-Pin Adaptor Lead is constructed from 7/36 (28AWG) Tinned Copper twisted pair wiring with Polyolefin insulation to minimise crosstalk. Metal Spring Latches are provided on the 96-Pin connector and strain relief is via latch clips for the 50-Pin connectors.
-
Product
24" Drawer with Writing Surface, Unshielded, 3.5"H x 30"D
DR-032430-S
-
Unshielded drawers with writing surface are constructed of 20 ga. CRS and are furnished with ball bearing chassis slides to provide smooth operation. Available for 19" and 24" rackmount in 20", 24" and 30" depths, with or without a keylock
-
Product
Ultra Compact PC-Based EtherCAT Controller With Intel Atom Processor, 64GB EMMC, 2 X LAN, 2 X USB And Slice IO Expansion
AMAX-357
Controller
Up to 32-axis EtherCAT PC-based motion controllerIntel® Atom® quad-core x6413E processor4 GB DDR4 onboard memory64GB eMMC on board storage2 x GbE LAN, 2 x USB, 1 x HDMI, 1 x EtherCATFull-size mPCIE/mSATA for flexible expansionBuilt-in TPM2.0 for hardware-based securitySupports PTP, linear and circle interpolation, Path tableSupports C/C++, VS.Net, LabVIEW programming languages
-
Product
2-In-1 Wi-Fi Tri-Band MIMO Antenna, Covering 2.4/5/6GHz Bands, Support Wi-Fi 6E/7
AIW-515
-
2-in-1 WiFi Tri-band MIMO antenna, covering 2.4GHz/5GHz/6GHz bandsSupport latest Wi-Fi6E/7PIFA antenna with omni-directional radiation patternMagnetic/Adhesive MountRP-SMA male connectorIP67 waterproof resistant for outdoor
-
Product
9U CTEL Backplanes with system Slot on left 9U8Slot, 3 x P47
103CTEL908-4146R5
-
Conforms to PICMG basic specification 2.0 R3.0, Versions conforming to PICMG H.110 Computer Telephony specifications, 8-layer and 12- layer controlled impedance stripline design.
-
Product
X, Y, Θ Absolute Position Encoder
nanoGPS OxyO Encoder
-
nanoGPS OxyO® Encoder is a X, Y, Θ absolute position encoder, available as OEM or stand-alone solution from HORIBA Scientific.nanoGPS OxyO® technology is based on taking a picture of a patented patterned substrate, and interpreting this picture into position (x, y) and orientation (θ).
-
Product
Digital Clamp Tester With 80mm X 74mm CT With Bluetooth40mmφCT, ACA
MCL-800DX
-
MULTI MEASURING INSTRUMENTS Co., Ltd.
Next-generation leakage current clamp meter with connection, via Bluetooth, to a smartphone which displays waveforms and data.
-
Product
PXI 5 x 4 to 1 RF Multiplexer 500MHz 50 Ohm Multiway Connector
40-755-005
Multiplexer Module
The 40-755-005 is a 50 Ohm high-density RF multiplexer (4 to 1) array available with 5 MUXs in a single PXI module. The 40-755 range is available with two connector options, an SMB connector that provides a frequency range of 1.8GHz and is available in single or dual PXI slots, or a multiway connector which limits the bandwidth to 1.3GHz but offers a high density solution occupying just one PXI slot. The RF switch design is identical in each case.
-
Product
LGA 1200 Intel® Xeon® W & 10th Gen. Core™ MicroATX Server Board with 4 x DDR4, 3 x PCIe, 6 x USB 3.2, 5 x SATA3, Quad/Dual LANs, and IPMI
ASMB-587
Server Board
- LGA 1200 Intel® Xeon® W and 10th Gen. Core™ i9/i7/i5/i3 processor with W480E chipset- DDR4 ECC/Non-ECC 2933/2666/2400 MHz UDIMM up to 128 GB- One PCIe x16 and 2 x PCIe x4 slots- Triple displays - DVI-D, VGA, and HDMI 2.0 ports- Five SATA 3 ports and six USB 3.2 ports- One M.2 22110/2280 (SATA / PCIe compatible)- 0 ~ 60 °C (32 ~ 140 °F) ambient operating temperature range
-
Product
19" Rackmount Drawer, Unshielded, 3.5"H x 24"D
DR-031924
-
Unshielded drawers are constructed of 20 ga. CRS and are furnished with ball bearing chassis slides to provide smooth operation. Available for 19" and 24" rackmount in 20", 24" and 30" depths, with or without a keylock
-
Product
PXI 100 x SPST Ruthenium Reed Relay Switching
40-140A-221
Relay
This range of high density reed relay switching modules are available in Normally Open (SPST & DPST) and changeover (SPDT) configurations. Connections are made via a front panel 200 pin female connector. General purpose reed relays are suitable for the construction of small switching networks, for slaving up to larger switches or for operating external devices (e.g. lamps, solenoids etc.).
-
Product
Octave Band Analyzer
-
Octave Band Analysis and AnalyzerOctave band analysis is an indispensable tool for sound measurement because it gives a close approximation of how the human ear responds. Dewesoft octave band analyzer meets all of the IEC and ANSI specifications for octave filters.
-
Product
21.5" Full HD, 1920 X 1080, VGA/DVI/HDMI Interface, Panel Mount Monitor
IDS-3221W
-
21.5" Full HD 1920 x 1080 LCD panel with LED backlight for 20% power saving and environmental protection. 0 ~ 45° C range operating temperature, 5-wire resistive, Pcap touchscreen or 3mm tempered protected glass.
-
Product
PXI 48 x SPDT Power Relay Module
45-157-001
Relay
The 45-157 SPDT Power Relay Module consists of 48 single pole changeover relays controlled by a PXI/CompactPCI interface. It is suitable for applications were conventional reed-relay based switching modules do not have sufficient voltage rating or current carrying capacity. All 48 contacts are electrically isolated from each other and are capable of switching resistive and inductive loads up to 2000VA at 240V AC.
-
Product
SIMRC - 8 x Reed Relay Module, SPST
1010-R-8-1-5/1D
Reed Relay
Our small format embedded switching (SIM relay) cards offer a choice of switching configurations using low cost industry standard SIM connectors. They free the designer from the detail of routing complex switching circuits, you may select from a wide range of cards using the built in RS-232 and I2C interfaces. These low-cost embedded switching cards are intended to be mounted on to a simple motherboard. They may be used to construct very high density switching networks. SIM based switching cards also allow for very simple in-field maintenance.
-
Product
24" Rackmount Drawer, Unshielded, 10.5"H x 24"D
-
Unshielded drawers with writing surface are constructed of 20 ga. CRS and are furnished with ball bearing chassis slides to provide smooth operation. Available for 19" and 24" rackmount in 20", 24" and 30" depths, with or without a keylock
-
Product
PCIe Card Carrier PCIe x 4
SA1-FUSION
-
The SA1-FUSION is a peripheral slot board for PICMG® CompactPCI® Serial systems and acts as a carrier for a low-profile PCI Express® card. The SA1-FUSION is provided with a PCIe x4 connector.
-
Product
Wide Band Filters (multi-octave)
NANO-ERF® Series
-
The NANO-POLE® Extended Range Series of tunable filters was developed to address applications needing an extremely small surface-mount package with low power consumption. Wide tuning range is accomplished with careful design to minimize size and power consumption.
-
Product
24" Rackmount Drawer, Unshielded, 5.25"H x 24"D
DR-052424-S
-
Unshielded drawers with writing surface are constructed of 20 ga. CRS and are furnished with ball bearing chassis slides to provide smooth operation. Available for 19" and 24" rackmount in 20", 24" and 30" depths, with or without a keylock
