Filter Results By:
Products
Applications
Manufacturers
Personal Computer
Checking personal computers and using a pc as host to perform test.
-
product
Hardware and Software System
GeoRad
The "GeoRad" hardware and software system (hereinafter called HSS) is intended to measure ambient dose equivalent rate (DER) of gamma radiation and to pick up geographical coordinates and current time from navigation satellites, to display geo-referenced measurement results on the monitor of personal computer (PC), as well as to archive the information.
-
product
Indoor Air Quality Meter CO, CO2, Temp, RH%
AQM4
UEi Test & Measurement Instruments
Four measurements in one instrument; carbon monoxide (CO), carbon dioxide (CO2), temperature and relative humidity. Use calculated 8 hour Time Weighted Average (TWA) and 15 minute short term exposure limits of CO2 for compliance testing and CO measurements for safety testing. Record, recall or download all readings to personal computer for later analysis or record keeping.
-
product
Antenna Training and Measuring System
The complete Antenna Training and Measuring System includes a set of 1 GHz antennas, a set of 10 GHz antennas, an RF Generator, a receiving system, and the Data Acquisition and Management Software for Antennas (LVDAM-ANT), a user-friendly software operating under the Microsoft® Windows™ environment. The receiving system consists of a rotating Antenna Positioner linked to a Data Acquisition Interface connected to the USB port of a personal computer.
-
product
Personal Computer Aided Antenna Design
PCAAD 7.0
Antenna Design Associates, Inc.
PCAAD 7.0 is a Windowscompatible antenna analysis, modeling, and design software package. It contains more than 50 routines treating wire antennas, aperture antennas, microstrip antennas, arrays, transmission lines and waveguides, and more. These routines are integrated into a menudriven, userfriendly system allowing you to quickly evaluate the performance of a wide variety of antenna types. PCAAD 7.0 includes a 120-page printed user manual which describes the use of the software, provides examples for each of the routines, and lists technical references.
-
product
Voltage Datalogger
S5011
Data logger is designed for record of voltage. Values are stored to a non volatile electronic memory. Data transfer to the personal computer for further analysis is performed via USB, RS232, GSM or Ethernet interface by means of a proper adapter.
-
product
Flying Probe Electrical Testers
Gardien has been present in the PCB industry since the advent of the personal computer. In our beginning Mania, the company that pioneered some of the first electrical grid testers used by PCB fabricators. We still produce class leading equipment to this day, such as our line of Gardien Flying Probe Testers and our Acceler8 Scanning System.
-
product
Torque Tester
WDISR-IPS series
Built-in battery type DIS-IPS series successor. Ideal for managing automated and semi-automatic tools. For management of various torque tools A small detection part fits measurement of various points. Interlocking with a personal computer or PLC, the torque measurement can be managed at a higher level.
-
product
Energy Saving Data Collecting Servers
Mitsubishi Electric Automation, Inc
Leave your data management on the Web to EcoWebServerIII.Using intranet through general personal computer with EcoWebServerIII, EcoWebServerIII achieves wide range of "Visualizing Energy Management" system and support your energy saving activity.
-
product
Logger
S7021
Data logger is designed for record of pulses and two-state events. Values are stored to a non volatile electronic memory. Data transfer to the personal computer for further analysis is performed via USB, RS232, GSM or Ethernet interface by means of a proper communication adapter.
-
product
LV Iron Core Harmonic Filters
Nonlinear loads such as power electronics based equipment and electric furnaces are sources of harmonic currents leading to harmonic distortion, which is one of the most important parameters for defining the power quality. Most of the commercial loads such as personal computers, photocopy machines, power supplies, and compact fluorescent lamps; and industrial loads such as AC and DC motor drives inject harmonic currents into the network that they are connected to.
-
product
Light Source
UVF-205S
By use of the light guide with the quartz sensor fiber, feed-back control and monitoring of UV irradiation intensity is possible. Also setting of UV intensity and meaurement by personal computer is possible
-
product
Thermometer
S0841
Thermometer is designed for record of temperature. Values are stored to a non volatile electronic memory. Data transfer to the personal computer for further analysis is performed via USB, RS232, GSM or Ethernet interface by means of a proper adapter.
-
product
Basic 3U VPX-to-PCI Express (PCIe/PCI-e) Adapter
8065
The Technobox, Inc. P/N 8065 is a 3U VPX-to-PCI Express (PCIe) adapter that provides a convenient and cost-effective means for developing 3U VPX boards in a personal computer environment. It can also be used for production testing of 3U VPX boards. The adapter is a half-length PCIe card with the VPX card under test mounted close to the PCIe edge fingers to minimize signal lengths. When seated in a PC motherboard, the VPX card primary side faces upward to allow convenient access to components.
-
product
Data Collection
Data collection is the heart and soul of weather monitoring and prediction. Weather station data collection can use either wired or wireless systems, and Davis Instruments has a range of transmitters, receivers, and data access options to help you transmit data to your personal system or larger groups. You can upload data only to your Vantage Pro2 or Vantage Vue console, or you can choose to also upload to WeatherLink.com where your data can be accessed on your phone or computer.
-
product
Micro Dyne System
With over 50 years' experience in dynamometer design and torque measurement, Magtrol has revolutionized the industry. Magtrol's NEW Micro Dyne, capable of measuring extremely low torques (2.0 mNm can be resolved to 0.0004 mNm), is DESIGNED EXCLUSIVELY for testing miniature and micro motors.For the utmost convenience, the Micro Dyne is packaged as a COMPLETE MOTOR TESTING SYSTEM. Everything that is needed to accurately and efficiently test miniature motors and micro motors is included with the purchase of a Magtrol Micro Dyne. The only component that needs to be supplied by the customer is a laptop or desktop personal computer and a motor power supply.
-
product
Vector Network Analyzer
R42XXE
The R42XXE Vector Network Analyzers are designed for measuring of S-parameters, VSWR and impedance of waveguide networks in the full frequency ranges of standard waveguides between 33 and 170 GHz. Frequency accuracy is ±0.2%. The measurement range of reflection factor modulus is from 0 to 1. The measurement range of reflection factor phase is from 0 to ±180° for 0.1< |Гx|<1 with accuracy ±7.5 o in 18-75 GHz frequency range and ±9.6° in 75-170 GHz frequency range. The measurement range of transmission factor phase is from 0 to ±180 o with accuracy ±(5+0.1 |Ax|) o for Ax >-50 dB in frequency range to 75 GHz, for Ax >-30 dB - to 170 GHz. Data can be displayed in the rectangular, Smith or polar diagrams. VNA requires Personal Computer with USB interface.
-
product
Power Supply Units
converts mains AC to low-voltage regulated DC power for the internal components of a computer. Modern personal computers universally use switched-mode power supplies.
-
product
Noise & Vibration Analyzers
The NVA instrument is generally composed of a personal computer equipped with one or more data acquisition board, a conditioning interface and / or to the transmitters power and finally a series of libraries of application software dedicated to the type of measurement to be made. the type of personal computer can be either a desktop, notebook or portable and depending on the particular requirements, you can use the PXI architectures.
-
product
Computer Assisted Microhardness System
C.A.M.S.
Newage Testing Instruments, Inc.
The C.A.M.S. concept starts with a Newage microhardness tester (or competitive microhardness tester), such as our MT91 Series or MS-ZH Series with video camera, combined with our software, personal computer and any required accessories, such as a motorized X-Y-Z axis positioning table.
-
product
Handheld Gaussmeter
HGM09
Data storage on a personal computer via keystroke. The HGM09s is easy to use and has a good price/performance ratio. The handheld gaussmeter HGM09s is used to measure magnetic DC and AC fields. The measurands are flux density in Tesla or Gauss and the field strength in Amps per meter.
-
product
Electromechanical Relay Assembly Control
The system is based on two miniature industrial cameras from the Basler ace series, positioned at 90 ° to each other.According to the signal from the optical sensor for the presence of an object, two images are simultaneously captured in the frontal and lateral planes.The images are sent to a personal computer via the Gigabit Ethernet interface, where they are processed.The speed of the system is about 20 items per second.
-
product
Specialized PXI
PXI is an abbreviation for PCI eXtensions for Instrumentation. It is based on the PCI architecture, a commonly-used standard in personal computers, with an industrial connector. A second connector adds instrumentation-specific signals to the backplane, like clock and trigger signals.
-
product
Thermometer Hygrometer Data Logger
S3120E
Data logger is designed for record of temperature and humidity. Values are stored to a non volatile electronic memory. Data transfer to the personal computer for further analysis is performed via USB, RS232, GSM or Ethernet interface by means of a proper communication adapter.
-
product
Rebar Corrosion Rate Determination System
Gecor 6
Measures the rate of corrosion and other parameters of rebars. The Gecor 6 utilizes the polarization resistance technique to establish the corrosion rate. This is a quantitative measure of the amount of steel oxidizing at the time of measurement. Up to 100 readings can be stored in memory for later uploading to a Personal Computer.
-
product
Scalar Network Analyzer
R24XE
The R24XE Scalar Network Analyzers provide both manual and automated VSWR, insertion and return losses measurements in five waveguide bands from 33 to 225 GHz. The system consists of the G44XE sweep generator, waveguide reflectometer, network analyzer and personal computer.
-
product
Geiger Counter
USB-RAD121
The USB-RAD121 is a radiation detector that runs completely off your computer's USB port. The device features a classic geiger counter click and light pulse for every count registered, while radiation levels are displayed on the computer. The simple RadGraph software interface displays and graphs readings over time, and even allows the readings to be streamed to a personal webpage.
-
product
Digital output version optical fast DO sensor
RINKO II / II D
Rinko II is a digital output version with a fast-response optical DO sensor. The instrument can be easily integrated on platforms, because it works with communications by RS-232C or RS-485 and an external power (12 to 24V DC).Rinko IID has not only a temperature sensor but also a depth sensor. Their models can monitor DO in real time, if you have a personal computer and an external power.
-
product
High-Accuracy Infrared Thermometers [Stationary type]
IT-480 series
IT-480 series are compact, stationary type infrared thermometers with industry-leading* accuracy, which enables measurement without damaging the object.These infrared thermometers are suitable for industrial applications such as temperature control of various product lines, devices and plants.Also, by connecting USB to a personal computer (PC) equipped with Windows®, IT-480 series can be widely used for laboratory and R&D.IT-480 Data Acquisition Software is required to connect PC to IT-480 series. This software can be downloaded free of cost.
-
product
Data Logger
S7841
Four-channel data logger is designed for record of two-state events. Values are stored to a non volatile electronic memory. Data transfer to the personal computer for further analysis is performed via USB, RS232, GSM or Ethernet interface by means of a proper communication adapter.
-
product
Wafer/Chip/Package Semi-automated ESD Tester
400SW
Tokyo Electronics Trading Co., Ltd.
Semi-automated ESD tester featuring Ecdm 400E, Universal ESD Simulator. Used with a manual wafer probing system or a die manipulator, wafer or die level semi-auto ESD test can be done, as well as packaged device test. Damage is detected by V-I curve or leakage current change detection. Stress level and measurement points are programmed by personal computor via GP-IB. Once test terminals are selected, ESD endurance is automatically measured.
