-
Product
Communications ICs
-
Renesas' broad portfolio of communication ICs includes subscriber line interface circuits (SLICs), DSL line drivers, general purpose ringing SLICs, isolated PWM controllers, line card access switches, PABX short-loop SLICs, PLC line drivers, and serializer/deserializer (SerDes) ICs.
-
Product
HART Communicators
-
We offer HART communicators, combined in some of our process calibrators. When the HART communicator is built in the same device with the process calibrator, it can communicate seamlessly offering better user experience than separate calibrator and communicator. Plus you only need to carry one device. Thanks to the modularity, you can add the communicator later on, if needed.
-
Product
3U CompactPCI® RS-232/422/485 Serial Communication Card
MIC-3955
-
The MIC-3955 is a low power 4-port or 8-port RS232/RS422/RS485 serial board with 3U CPCI form factor and is based on the EXAR PCI controller. MIC-3955 is PICMG 2.0 Rev. 3.0 compatible. Rear board module are named MIC-3527XX. The MIC-3955 supports front IO or rear IO with 4-port and 8-port, and every channel is independent.
-
Product
CAN/LIN Communications Expansion Kit
OP-SB7GX
-
OP-SB7GX is the expansion kit which makes it possible to monitor, and simulate CAN and LIN communications. It enables monitoring of CAN and LIN data in any combination up to 2 channels at a time. Suitable for evaluation of mixed in-vehicle networks of CAN and LIN.
-
Product
CANBus Communication
PCM-CAN200-D
-
PCM-CAN200 can represent a CAN solution on a high quality PCI104/PC104+ hardware in industrial environment compliant with CAN 2.0A and CAN 2.0B specification. It has 2 independent CAN bus communication ports with 9-pin D-sub connector, and has the ability to cover a wide range of CAN applications.
-
Product
RTM Communication Board
MS 3636I
-
CPCI Rear IO Communication Board is a signal conditioning and interface board for CPCI Integrated Communication Card (MS3635i). This board has required signal conditioning and interface circuits for RS422. Two 96 Pin Euro Connectors are used to interface all IO’s.
-
Product
Aeronautical Communications
-
Aeronautical communications systems must be reliable and efficient. Morcom is a leading supplier of communications systems for civil and military users. From long-haul SELCAL radio HF-SSB systems, to ATC radios for VHF and UHF communications we have supplied several military and civilian aviation users around the world with very effective and state-of-the art solutions.
-
Product
MXI-Express Cable With Communication Levels Up To Gen 3 X8
788302-10
-
The MXI-Express Cable connects a host interface to a PXI or PXI Express chassis. You can also use it for data communication between multichassis systems. NI offers it in different MXI communication levels and lengths.
-
Product
NDI Navigation Markers – Detect OEM Instruments With Pinpoint Accuracy
-
Navigation markers are a key component of the Polaris® optical measurement solution. When attached to OEM instruments, navigation markers function as triangulation points for the instrument within the treatment space. This is due to the marker’s unique retro-reflective surface, which allows the Polaris optical tracker to ‘see’ it during tracking. The navigation marker and the Polaris optical tracker work together to localize, detect, and track OEM instruments with pinpoint accuracy.
-
Product
MXI-Express Cable with Communication Levels up to Gen 3 x8
779500-03
MXI Express
MXI-Express Cable, Gen 1 x1, Copper, 3m
-
Product
Dual-Port Isolated RS-422/485 Communications and Watchdog Card
WDG-2S
-
This multifunction card contains a watchdog timer, two RS422/485 serial communications ports, and an internal temperature monitor and computer voltage monitor. This is a full-length card that installs in "long" expansion slots of IBM PC/XT/AT and compatible computers. The following paragraphs describe functions provided.
-
Product
4 Serial Communication Channels, Programmable RS-232/422/485, Non-Isolated
SC6
-
Serial Communication Module SC6 provides up to 4 high-speed, programmable RS-232/422/485, individually non-isolated communication channels. Each channel is programmable for either RS-422/485 (differential, DF) or RS-232 (single ended, SE) hardware level interfaces. Individual channel non-isolated returns are available as part of the channel user interface signal set (for SE or SYS-GND reference).
-
Product
Miniature Multi Communication UV-NIR Spectrometer
VS70-MC
-
VS70-MC (Multi Communication) is a high performance compact fiber coupled spectrometer system covering wide spectral range of 200 to 910 nm.This OEM optical module is built around HORIBA’s type-IV Aberration-Corrected Flat-Field Holographic Ion-Etched concave grating and is specially designed to easily adapt to a large variety of detectors and electronic drivers. This system is fitted with an integrated order-sorting filter to eliminate higher orders.
-
Product
CPCI Or PXI Communication Interface Board
MS 1706
-
*Memory and IO Read Write Cycles*External Interrupts*32 bit Data Bus*30 bit Address Bus*Control Signals for external interface*Four RS232 PORTS with full handshake signals*Four RS232/RS422 PORTS without handshake signals*Driver interface for Windows2000/XP/VISTA and LINUX OS
-
Product
1 Channel, MIL-STD-1553/1760 Communications Interface
FTJ
-
Based on the MIL-STD-1553 signal and interface backbone, MIL-STD-1760 defines a standardized electrical interface to address additional aircraft weapons stores management and as such, includes some special requirements. The FTJ module meets the operational requirements within the general specifications of MIL-STD-1760 as applied to an integrated I/O function module, and include special designed holt transceivers to ensure signal parameter operation and integrity.
-
Product
Communication Jammers
-
Stratign provides state-of-the-art customizable, active/reactive jamming solutions to block communication systems on the frequency band from 20-6000 MHz, in the targeted areas. We also enable the creation of an Authorised/Unauthorised list of cellphone users.
-
Product
Optical Fibers Communications
-
1. Textbook includes the theoretical and practical details.2. Textbook includes the expected results for reference.3. Problem discussion attached together with answers for instructor.4. Only need oscilloscope and spectrum analyzer to obtain the measured results.
-
Product
Data Communication Solution
BACnet/IP
-
BACnet is a data communication protocol mainly used in the building automation and HVAC industry (Heating Ventilation and Air-Conditioning).
-
Product
Industrial Communication Gateway With TI Cortex A9, 2 X LAN & 4 COM
ECU-1251 V2
-
Cortex A9 600MHz processor with 2G RAM16GB eMMC system storage and 1 x Micro-SD Slot4 x RS-232/485 isolated serial ports2 x 10/100 Ethernet ports and 1x mPCIe for wireless communication expansionSupport web service for remotely on-line monitoringSupports SD cards and OTA firmware updatesEdgeLink IoT software for data acquisition and cloud communicationWide Operating temperature: -40 ~ 70°C
-
Product
RS-422/485 Serial Communication Card
PCI-COM-1S
-
The PCI-COM-1S is a single port asynchronous serial communications card that can be installed in any 3.3V or 5V PCI slot computer. The card meets the MD1 PCI Low Profile Specification and is just 4.7 inches long. For low profile systems please use P/N LPCI-COM-1S for the card to be shipped with a low profile bracket.
-
Product
Serial Communication Products
-
Many types of external computer equipment have a serial ports to communicate with host PCs. ACCES I/O has Communication Cards for all of the popular protocols you may find on this type of equipment (RS-232, RS-422 and RS-485), ranging from a single port to eight ports on a single card. There are also optically isolated versions of some of these cards to ensure effective data transmission on long communication lines, even in electrically noisy environments. Having optical isolation is like having data insurance.
-
Product
5G Radio Communication Tester
CMX500
-
The R&S CMX500 radio communication tester is the future-proof solution for 5G NR testing, featuring an intuitive and flexible web-based user interface, the R&S CMsquares. Supporting manual interactive operation as well as automatically sequence-controlled test protocols makes the R&S CMsquares an advantageous software solution, with unique modules for all signaling use cases. These range from R&D design stages up to end-to-end application testing, production and conformance tests. The introduction of a one-platform strategy for all 5G NR test equipment enables a unified test environment for signaling and non-signaling testing through all stages of 5G device production.
-
Product
MXI-Express Cable With Communication Levels Up To Gen 3 X8
788302-100
MXI Express
MXI-Express Cable, Gen 3 x4, Fiber Optic, 100m
-
Product
MXI-Express Cable with Communication Levels up to Gen 3 x8
782317-03
MXI Express
MXI-Express Cable, Gen 2 x8, Copper, 3m
-
Product
Industrial Communication Gateway With TI Cortex A8, 2 LAN, 2 COM, 4 DI & 4 DO
ECU-1251D
-
TI Cortex A8 600MHz CPU with DDR3L 256MB RAMOnboard IO - 4DI / 4DOSupport web service for remotely on-line monitoringFirmware update by SD card and online updateData logger on SD cardSupport dual SIM slots for communication redundantSupport MQTT Client for cloud communicationWide Operating temperature: -40 ~ 70°C
-
Product
Serial / USB Communications
-
Advantech offers serial / USB converters, isolators, repeaters, surge suppressors, data taps /splitter, USB hubs, and industrial communication cards.
-
Product
Communication Protocol Analyzer
LE-200PS
-
LE-200PS is a lightweight communication protocol analyzer has a Data Logger function to record data in the SD card for long hours. It is a high performance model, which covers all functions on LE-150P/150PS and supports multi protocols.
-
Product
Isolated Serial Communication Card
PCI-ICM-1S
-
The PCI-ICM-1S is a single port asynchronous optically isolated serial communication card that can be installed in any 3.3V or 5V PCI slot computer. Data lines are opto-isolated from the computer and from each other to assure communication even when large common mode voltages and noise are imposed.
-
Product
CANBus Communication
PISO-CAN400U-D
-
The CAN (Controller Area Network) is a serial communication protocol, and efficiently supports distributed real-time control with a very high level of security. It is an especially suit for networking "intelligent" devices as well as sensors and actuators within a system or sub-system. In CAN networks, there is no addressing of subscribers or stations in the conventional sense, but instead prioritized messages are transmitted. As standalone CAN controller, PISO-CAN400/CAN200 can represents an economic solution of an active CAN board. It has two or four independent CAN bus communication ports with 5-pin screw terminal connector or 9-pin D-sub connector, and has the ability to cover a wide range of CAN applications. Besides, PISO-CAN400/CAN200 uses the new CAN controller Phillips SJA1000T and transceiver 82C250/251, which provide bus arbitration, error detection with auto correction and re-transmission function. It can be installed in a 5V PCI slot and supported truly “Plug & play”.
-
Product
Communication Systems
-
Tactical networking radio system comprising of transmit/receive modules, converters, synthesizer, RF switching, power supplies, controllers and an antenna array. The radio automatically selects the best communications path to create a self-forming, self-healing network.
