Cable Fault Finders
Use time domain reflectometry to locate signal loss or a Murray loop bridge.
-
Product
160 Pin Female DIN to QuadraPaddle Flying Lead Cable, 60", 024070
VFL103124-060
-
Vendor Flying Lead (VFL) Cable, 160 Pin Female DIN to QuadraPaddle Leads, 24AWG Twisted Pair, 80 T/P's(1:2) 160 connection points, M2.5 x .45 fastener, CONN: 024070 WIRE: VPC, for PXI-2737, PXIe-2738 families, VPC Contact 610138216 - QP RCV (22AWG-28AWG) (5 AMP/25 mΩ MAX), 20" length.
-
Product
Cable Assembly, 50-Pin D-Type, Male To Unterminated With Ferrules, 0.5m HV, 45º Exit Away From Pin 1
40-972-050-0.5m-MUHV
-
50-Pin D-Type HV Cable assemblies are constructed from 7/0.2 (24 AWG) Tinned Copper Wire with PTFE Type C insulation. The connector assembly can be secured to the mating part by a screwlock.
-
Product
20-Pin GMCT Cable, Female to Unterminated, Cut Ends, 16A, 0.5m
A020GFR-C-1B050
-
The 16A 20-Pin GMCT cable assembly is constructed from 19/0.41 (14AWG) Copper Wire with PFA 500V insulation. Screwlocks are provided to secure the connector to associated product. The unterminated connections are coded to match the connector pin designation and include crimped on ferrules to ensure the wire strands cannot break when they are terminated.
-
Product
Cable Assembly, 104-Pin D-Type, Female to Unterminated, Ferrules, 2A, 2m
40-972-104-2m-FU
-
This 2m long female to untermiated 104-Pin D-type Cable Assembly is suited for direct connection to various products using the 104-Pin connector. It is constructed from high-flexibilty, high-specification fully screened cable and has unterminated ends with ferrules.
-
Product
20-Pin GMCT Cable, Male to Unterminated, Cut Ends, 10A, 1m
A020GMR-C-0C100
-
The 20-Pin GMCT cable assembly is constructed from 19/0.254 (18AWG) Tinned Copper Wire with PFA insulation. Screwlocks are provided to secure the connector to associated product. The unterminated connections are coded to match the connector pin designation. Users may need to make their own cable strain relief arrangements when using this product and should ensure appropriate electrical safety precautions are observed.
-
Product
Low Noise Triaxial Cable
PX0102A
-
The Keysight PX0102A is suitable for low current measurement down to the sub-fA level. It supports the Keysight M9601A.
-
Product
Cable Assembly, Receiver, 20", Mini Power, 19 Pin to 4 Banana Plugs
540067010108
-
Cable Assembly, Receiver, 20", Mini Power, 19 Pin to 4 Banana Plugs.
-
Product
75 Ohm MCX to MCX Cable Assembly
40-977-761-0.5m
-
Pickering Interfaces offer a range of RF cable assemblies to complement our extensive range of PXI, LXI, PCI, VXI and GPIB switching products. All cable assemblies are made from high quality materials and use best practice assembly methods to ensure the cabling matches the performance of the switching modules they support.
-
Product
3-Pin Power D-Type Cable, Female to Unterminated, Cut Ends, 2m
40-972-403-2m-FU
-
The 3-Pin Power D-Type cable assembly is constructed from 50/0.26mm2 (14 AWG) Tinned Copper Wire with PVC insulation. Screwlocks are provided to secure the connectors to their associated products.
-
Product
Cable Assembly, 78-Pin D-Type, Male to Unterminated With Ferrules, 0.5m
40-972-078-0.5m-MU
-
A 78-Pin D-Type to Unterminated cable assembly constructed from 7/0.15 (26AWG) Silver Plated Copper Wire. Screwlocks are provided to secure the cable connector to associated products. The 78-Pin Female connector option of this cable assembly is suited for direct connection to Pickering Interfaces products.
-
Product
Cable 96-Pin Micro-D Female to Female, 1m
40-970C-096-1m-FF
-
96-Pin Micro-D Cable Assembly, Female to Female, 1m Long.
-
Product
20-Pin GMCT Cable, Female to Female, 10A, 1m
A020GFR-020GFR-0B100
-
The 20-Pin GMCT cable assembly is constructed from 19/0.254 (18AWG) Tinned Copper Wire with PFA insulation. Screwlocks are provided to secure the connectors to their associated products. The 20-Pin Female connector option of this cable assembly is suited for direct connection to Pickering Interfaces products.
-
Product
Cable Assembly, 160-Pin DIN41612, Male to Unterminated With Ferrules, 1m
40-972-160-1m-MU
-
This cable assembly is not suitable for direct connection to Pickering Interfaces switching products.
-
Product
Cable Assembly, 9-Pin D-Type Male to Unterminated With Cut Ends, 1m
A009DM5-C-0A100
-
A range of 9-Pin D-Type cable assemblies with unterminated connections at one end and constructed from PFA insulated wire. The connector assembly can be secured to the product by screwlocks. The unterminated connections are coded to match the connector pin designation.
-
Product
Cable Assembly, Receiver, QuadraPaddle, 36", 2 VHDCI, for PXIe-8431/16
540205040240
-
Cable Assembly, Receiver, QuadraPaddle, 36", 2 VHDCI, for PXIe-8431/16
-
Product
Cable Assembly, 2.4-mm (male) to 2.92-mm (male), 40 GHz, 36 inch
Y1740A-310
-
2.4-mm (male) to 2.92-mm (male), 40 GHz, 36 inch.
-
Product
Cable Assembly, 50-Pin D-Type, Female to Female, 2m, Exit Away From Pin 1
40-970-050-2m-FF
-
The 50-Pin Female connector option of this cable assembly is suited for direct connection to Pickering Interfaces products and is constructed from PFA insulated wire. The connector assembly can be secured to the product by screwlocks.
-
Product
Ethernet/AFDX/BroadR-Reach PXI Fault Insertion Switch - 4 Channel
40-201-004
-
This high bandwidth differential fault insertion module is designed to simulate common faults on high speed two wire communication interfaces such as Ethernet. This module supports 4 or 8-channels of two wire serial connections and can be used for simulating faults on Ethernet, AFDX, BroadR-Reach, 100BaseT and 1000BaseT interfaces. Any wire can be set to an open circuit, shorts can be applied across the wire pair, or to the adjacent pair. Fault connections can be made to one of four external signals via two fault buses, typically simulating connections to a supply voltage or ground. Each fault bus is capable of carrying 2A allowing multiple channels to be connected to the same fault condition. Additionally, each fault bus features a changeover relay to allow the user to connect alternative fault conditions to the fault buses.
-
Product
Cable Assembly, Receiver, 20", Micro Power to 41-Pin FML Power Connector, for VTI EX1200-2001 Switch Module
540249010147
-
CBA, RCV, MicroPWR to 41-Pin J1 PWR Conn f/VTI EX1200-2001 Switch Module.
-
Product
10-32 Coaxial Male to BNC Female, 50 Ohm, 3 ft. cable
786657-01
-
10-32 Male to 1-Pin BNC Female, 50 Ohm Coaxial Cable - The 1032CoaxialM-BNC Cable connects data acquisition (DAQ) and control devices such as C Series I/O modules.
-
Product
20-Pin Scorpion Cable Assembly, Male to Female, 30A, 0.5m
A020AMR-020AFR-3A050
-
This is a 0.5m long male to female 20-Pin Scorpion cable assembly constructed from 37/0.4 (10AWG) Silver Plated Copper Wire with PFA insulation. Screwlocks are provided to secure the connector to associated product.
-
Product
Cable Assembly, Receiver, TriPaddle, 36", 200 Pin Male LFH w/ 4-40 Jackscrews
540005010205
-
Cable Assembly, Receiver, TriPaddle, 36", 200 Pin Male LFH w/ 4-40 Jackscrews
-
Product
Cable Assembly, Receiver, TriPaddle & Mini Coax, 36", 68-Pin Male VHDCI, 4 SMB Plugs
540103010230
-
Cable Assembly, Receiver, TriPaddle & Mini Coax, 36", 68-Pin Male VHDCI and 4 SMB Plugs
-
Product
68-Pin SCSI Micro-D M to 2x34 2m
40-971-068-2m-MF
-
The 68-Pin SCSI Style Micro-D Cable Assembly is constructed from 2x34-Pin Twisted Pair cable with PVC insulation, terminating with 2x34-Pin polarised IDC connectors. Strain relief is provided via a metal spring latch on the 68-Pin connector.
-
Product
SH68-68R1-EP, Shielded Cable, Right Angle Connector, 1 m
187051-01
-
68-Pin Female SCSI to 68-Pin Right-Angle Female SCSI, Twisted Pair, Shielded, 1 m Multifunction Cable - The SH68F-68R1F-EP Cable, sometimes referred to as SH68-68R1-EP, connects NI DAQ 68-pin devices to 68-pin accessories. The right-angle connector is useful for small spaces where clearance is limited.
-
Product
Extended Length RTSI Bus Cables for 5 PCI or AT/ISA Devices
777562-05
-
34-Pin Female RTSI to 34-Pin Female RTSI Ribbon Cable - The RTSI Cable, sometimes referred to as RTSI, connects RTSI bus connectors on adjacent NI plug-in boards. The RTSI Cable is offered with different numbers of ribbon connections and in different lengths.
-
Product
Cable Assembly, Receiver, TriPaddle, 36", 64 Position Module To TB-4300, 10V Input
540355010201
-
Cable Assembly, Receiver, TriPaddle, 36", 64 position module to TB-4300
-
Product
Cable Assembly, CAT-5E Ethernet, Thin Profile, 10M
151733-10
-
8-Pin Male Ethernet to 8-Pin Male Ethernet, CAT-5E Ethernet Cable - The 8M-8M Ethernet Cable connects devices to network hubs or switches. The cable has straight-through wiring and is available in different lengths and thin profile options.
-
Product
MCX Male to SMB Female Cable, 50 Ohm, 1 m
188376-01
-
The MCX-SMB Coaxial Cable is used for modular instruments such as Switches. This cable is available in 1 m, 2.23 m, and 30 m lengths.
-
Product
Type X2 double-shielded GPIB cable, 10 m
763061-10
-
24-Pin Male/Female GPIB to 24-Pin Male/Female GPIB, Stackable, Double-Shielded GPIB Cable - The 24M/F-24M/F X2 Cable, sometimes referred to as an X2 cable, connects your system to GPIB devices or interfaces for instrument control. The 24M/F-24M/F X2 Cable has 24-pin IEEE 488 male and female connectors, and the cable is double shielded with shielded plug/receptacles. The 24M/F-24M/F X2 Cable is also offered in different lengths.
