VME Chassis
-
Product
VME J1 5 Slot with ADC Connectors
101VMEJ105-0590R
-
VME J1 backplane 5 slot, compliant with ANSI/VITA 1-1994. 8-layer stripline design Includes passive termination inboard and automatic daisy chain connectors.
-
Product
LXI Wideband Modular Chassis Baseboard
65-110-801
Matrix Switch Module
The 65-110-801 is the baseboard for the 65-110A chassis.
-
Product
10 Internal Tooth Lock Washers for Chassis Slides
HW-55
-
Package of 100 No. 10 internal tooth lock washers for chassis slides and support angles.
-
Product
Chassis - up to Twelve 8x1 or 4x2 Modules & up to Six 8k Modules
HXV/96-MF
Chassis
These Chassis controls up to 12 8x1 modules, 12 4x2 modules, or up to 6 of the 8K modules in almost any combination or configuration. LEDs on the front panel show switch and power status. Add Switch Modules, Driver Modules and a Control Module to complete the system.
-
Product
Chassis Mount / U Channel AC-DC Power Supplies
-
Chassis Mount / U Channel AC-DC Power Supplies
-
Product
SKYbolt II 9U VME
-
Delivering 64 GFLOPS of performance when fully populated, the SKYbolt II 9U VME motherboard is the foundation of SKY's VME solution, adding intelligent support for system services and high-performance data transfers to the carrier board for SKY's Merlin daughtercard containing compute processors, I/O interfaces, and global memory. A separate System Processor resident on the motherboard handles system overhead functions that would otherwise burden the compute processors.
-
Product
Rugged Deployable, Rackmountable Chassis For 3U Cards Aligned To SOSA Or CPCI Serial
20037765
-
This unit is a rack-mountable, rugged deployable chassis for use in harsh environments. The chassis has been designed to provide modularity and flexibility to support the full design life cycle of a system from initial concept and lab development through to qualification and full platform deployment.
-
Product
550 HP Water Brake Chassis Dynamometer
CM-51S
-
AC power, air and water required at one side wallas applicable.• Room length, and pit location within length,must be determined by user to fit maximumtruck length and rear overhang.• Provide at least one man door for fire escapenear rear of room, but not in rear wall becausesomeone entering during a test could be struckby a stone flung from a tire. Provide ample fireextinguishers at each door and near driver.• “Back-on, Drive-off” installation configurationpreferred.
-
Product
6U VME Carrier for PMCs and PrPMCs
Ti4400
-
The Ti4400 is a 6U PMC/PrPMC carrier for VME systems and forms the basis of a flexible I/O system. The user can integrate two single PMC modules or one double-wide PMC.
-
Product
VPX Chassis 4U/50HP 7 Slots
BKP3-CEN07-15.2.3-4
-
his 7 slot Hartmann Open VPX BKP3-CEN07-15.2.3-4 profile system chassis provides an intelligent, practical packaging solution for high-performance processors. The 50HP wide, rack-mountable enclosure for vertical mounting of boards is outfitted with a 600W plug-in power supply and a 1U removable, bottom mount fan tray.
-
Product
Type 12R1 Family of 19" Rackmount Chassis Platforms, Reduced Weight, Rugged
12R1
-
The Type 12R1 family is a 19" rackmount chassis platform that is rugged yet lighter weight than the sturdier Type 12R2 platform. The chemical conversion coating provides corrosion protection and electrical conductivity. The rear evacuation cooling system uses high CFM blowers to remove the heat generated by the board payloads.
-
Product
4U Rackmount Chassis For EATX/ATX/MicroATX Motherboard With 4 Hot Swap Drive Trays For General-Purpose Servers.
HPC-7442
Motherboard
Supports EATX/ATX/MicroATX motherboardShock-resistant disk drive bay provides four hot-swap 3.5" or 2.5" SAS/SATA disk trays, one slim optical disk drive, and one 3.5" internal driveWith optional storage upgrade kit installed, system equipped up to eight hot-swap HDD trays for higher storage capacity requirementSupports 80plus single and redundant power supplyFront-accessible system fan without opening top cover for easy maintenanceLED indicators and alarm notification for system fault detectionBuilt-in Intelligent system module enabling whole system fan control and remote manageability
-
-
Product
Desktop/Wallmount Chassis
IPC-7130L
Chassis
Desktop/Wallmount Chassis for ATX/MicroATX Motherboard with Dual Hot-Swap 3.5" Drive Bays. Shockproof drive bays - One 5.25", one internal 3.5", and two hot-swap 3.5" trays for IPC-7130 / two 3.5" HDD device trays for IPC-7130L. Lockable front door prevents unauthorized access, LED indicators for system fault detection.
-
Product
Chassis Platforms
-
Elma offers a comprehensive range of standard, modified standard and custom packaging solutions with integrated backplane, power and cooling for; 19" rack-mount, test/development, and field deployable applications. Supporting the full range of VITA, PICMG and Small Form Factor architectures Elma has configurations based on VME, VME64x, OpenVPX, AdvancedTCA, CompactPCI, CompactPCI-Serial and COM Express.
-
Product
550 HP Water Brake Chassis Dynamometer
TD-36S
-
Weight Capacity: 30,000 lb (13,608 kg) per axleRoll Brakes: Pneumatically-actuated discShipping Weight: 6,600 lb (2,994 kg)Capacity: 550 hp at 45 mph (410 kW at 72 kph)Rolls: 36 by 31 in. (914 by 787 mm)Pit Required Depth: 35 in. (889 mm)
-
Product
VME Form Factor Extender, 6U, 120mm
111FFE6012-012X
-
The VME form factor extender 6U 120 mm allows to adapt boards for use in the same VMEbus system. It maintain the correct depth dimensions and allow the front panel to be aligned.
-
Product
8-Channel VME Strain Gauge/Weighing Module
V380
-
The V380 is a VME/VXI compatible eight-channel strain-gauge signal conditioner which is optimized for load-cell weighing applications. The module includes tare (zero reference), DSP-based high-order filtering, averaging, triggered weighing, and other functions not commonly available in conventional strain-gauge signal conditioners.
-
Product
6U RL1 VME Thundervbolt V-600 for 4-slot
-
SKY Computers provides one-stop-shopping for Defense contractors and integrators who need the complete spectrum of benign to harsh-packaged multiprocessing systems for their high performance needs. SKY's commercial grade SKYbolt 6U VME products have been ruggedized to two levels in the Xtreme product family. No other high performance embedded systems vendor provides this level of lifecycle support under one roof.
-
Product
PCI Express® Bus to 3U PXI Express™ Chassis Expansion Kit
PCIe-PXIe-8565
PXI Express Module
Includes PCIe-8560 peripheral card, PXIe-8565 3U system module, and ACL-EXPRESS cable in 1, 3, or 7 meter lengthsCompliant with PXI-5 PXI Express hardware specification Rev.1.0 and PCI Express Base Specifications Rev. 1.0a250 MB/s maximum system throughput
-
Product
4-slot LXI Chassis
MezaBox-4 LXI
-
MezaBOX-4 LXI is a device that ensures the functioning of various mezzanine modules (up to 4) installed in it, under the control of a personal computer via USB2.0 or ETHERNET 10/100 Base T (local area network) interfaces of a personal computer. MezaBOX-4 LXI is intended for use as a mezzanine carrier in multichannel systems for collecting / issuing information, both digital and analog.
-
Product
18.5" Configurable Panel PC Chassis For Selectable Mini-ITX Motherboards
PPC-618W
Panel PC
18.5" true-flat panel PC with multi-touch projected capacitiveSupports certified mini-ITX motherboards (up to 65W TDP processor)PCI or PCIe expansion slotsFront-facing power status LED indicatorsIP66-rated front panelSupport dual HDD drawer
-
Product
Receiver, G20, 20 Module, with Mounting Flanges for Pickering Chassis
310120149
Receiver
Receiver, G20, 20 Module, with Mounting Flanges for Pickering Chassis, with 20" Platform, Slide Mount
-
Product
High Speed PXIe Digital IO Card - 32 Channels, Extendable up to 256 Channels in One Chassis
Model 33010
Digital I/O Module
Chroma 33010 is a high-density 100MHz PXIe digital IO card designed for characterizing, validating, and testing a variety of digital and mixed-signal ICs. Each IO Card consists of a Sequencer Pattern Generator (SQPG) and 32 Channels of fill ATE-like features. The 33010 IO card is expandable up to 356 channels. Some unique features of the 33010 include an on-board SQPG, per pin timing/levels/PMU/TFMU, multiple time domains, and multithreaded testing for complex IC testing. Each channel is also equipped with 64M vector memory, 16 timing sets with on-the-fly timing change, and per pin timing and frequency measurements up to 400 MHz.
-
Product
NI-9147, 4-Slot, Zynq-7020 FPGA, Ethernet CompactRIO Chassis
783496-01
Chassis
4-Slot, Zynq-7020 FPGA, Ethernet CompactRIO Chassis - The NI‑9147 is a rugged Ethernet chassis that you can use to add C Series I/O modules to any standard Ethernet network. You can program the chassis using Scan Mode for fast expansion of your real-time system or using the onboard FPGA for inline processing and high-speed I/O and control. With the NI‑9147, you can add high-performance I/O to your PC-based application or expand your CompactRIO, PXI, or industrial controller application.
-
Product
Mounting Flange Kit, Chassis, Agilent M9018A
310113589
Mounting Kit
Mounting Flange Kit, Chassis, Agilent M9018A.
-
Product
MIL-STD-1553 A / B Test And Simulation VME Module
VME-1553
-
*Dual redundant*1, 2, 4 or 8 channels*Simultaneous bus controller, 31 remote terminals, bus monitor*Error entry and detection*FPGA based hardware architecture*Multi-level trigger for data acquisition and filtering*10 programmable, discrete I / O*IRIG-B timecode encoder / decoder with free-running mode*Real-time recording and physical bus playback*Supports: C, C ++, C # and .net*VISA based VXI Plug & Play driver*Optional twinax front end
-
Product
Portable cPCI Chassis With 15" LCD Display
DP-cPCI-8100
-
DP-cPCI-8100 is a robust portable cPCI chassis with 15” LCD monitor. Complaint with the compactPCI specifications this model is the most pragmatic solution for any mobile application. The chassis features modular construction and integrated cooling. The DP-cPCI-8100 is available with high-performance 2 - 7 cPCI slot backplane with various power supply configurations.
-
Product
10-Bit VME Digitizer
SIS3305
-
8 channel 6U VME digitizer/transient recorder with a sampling rate of up to 5 GS/s (for the individual channel) and 10-bit resolution. The board has a width of one VME slot (4TE).
-
Product
Embedded Chassis With One Low Profile Expansion Slot For Mini-ITX Motherboards
EPC-B2000 Series
Embedded PC
Embedded chassis with one low profile expansion slot for Mini-ITX motherboards.
