Product

CANbus Module

DS-MPE-CAN2L

-

Diamond Systems Corp

DS-MPE-CAN2L - Diamond Systems Corp

The module implements a CAN protocol bus controller that performs serial communications according to the CAN 2.0A and CAN 2.0B specifications. The protocol uses a multi-master bus configuration for the transfer of frames between nodes of the network and manages error handling with no burden on the host processor. Error analysis features enabling diagnostics, system maintenance, and system optimization. A listen-only mode enables CAN bus traffic analysis and automatic bit-rate detection.

Product

Distributed Antenna Systems (DAS)

-

Morcom International, Inc.

Morcom International, Inc.

Morcom's DAS as a Service (DAaS) is a new offering in the Connectivity as a Service (CaaS) portfolio. Distributed Antenna Systems (DAS) are an appealing option for building owners and real estate venue operators. Why incur in the capital expense of purchasing a DAS when you can have the same cellular coverage in your venue and pay for it as a monthly expense (where it will be offset by the money you're saving through IoT innovation and productivity). Morcom’s CBRS Private LTE band and Neutral Host DAS solutions are available to all carriers.

Product

M.2 SATA SSD Carrier

SD4-SWEEP

-

ELMA Electronic, Inc.

SD4-SWEEP - ELMA Electronic, Inc.

SD4-SWEEP fits into any CompactPCI® Serial peripheral slot that is PCIe enabled. Hardware RAID operation is supported, running with an enhanced ARM-based processor to offload the host CPU.

Product

0.5-2.4GHz Instantaneous Frequency Measurement Unit

DR063-M2

-

Teledyne Defence & Space

DR063-M2 - Teledyne Defence & Space

Teledyne Defence & Space’s Instantaneous Frequency Measurement (IFM) module, also known as a Digital Frequency Discriminator (DFD), offers high speed frequency measurement across the full operating bandwidth.The IFM measures the frequency of RF signal present at its input and presents a result at its output as digital data. The RF input signal is conditioned by an RF amplifier that provides sufficient drive for the frequency resolving circuits. The raw video from the resolvers is digitised and processed into the required output format. There is additional timing and control circuitry which initiates the measurement process and provides handshake data to the host system processor.

Product

USB to I2C Adapter

Model JI-300

-

Jupiter Instruments

Model JI-300 - Jupiter Instruments

The JI-300 is a versatile, easy to use PC hosted adapter used to drive I2C communicationsto/from a target device. The desktop unit can be configured to interface a variety of I2Cnetworks. Bus parameters such as clock frequency, duty-cycle, setup and hold times, busvoltage, and pull-up resistor values can be varied. JI-300''s diagnostic features including"excessive clock-stretch", "bus-not-free", and "bus contention" monitoring, as well as statusreporting at the conclusion of each message transaction simplifies I2C trouble-shooting. AWindows software application manages the setup and control of the instrument.Communications and unit power is provided via a USB 2.0 connection.

Product

Multi-Interface Frame Grabber

Xtium2 CLHS PX8

-

Teledyne DALSA

Xtium2 CLHS PX8 - Teledyne DALSA

Building on the field proven Teledyne DALSA’s Xtium family of frame grabbers, the Xtium™ 2 CLHS PX8 features CameraLink HS standard on the PCI Express™ Gen 3.0 platform. The Xtium2-CLHS supports Active Optical Cable (AOC) and industry standard CX4 cables. This single cable, single slot solution supports up to 7-CLHS lanes, each operating at 10.3 Gbits/s, to acquire images at up to 8.4 GBytes/s and transfer them using PCIe x8 slots to the host memory.

Product

CompactPCI

cPCI4IP

-

Dynamic Engineering

cPCI4IP - Dynamic Engineering

The cPCI [CompactPCI] compatible cPCI4IP design adds 4 Industrypack compatible slots to your cPCI host. The cPCI4IP acts as an adapter, converter, carrier, or bridge between the cPCI bus and your IndustryPack hardware. The cPCI4IP is a 6U 4HP cPCI design with 4 IP slots.

Product

Bus Analyzer

FireSpy® 4430b(T)/4830b(T)

-

DapTechnology B.V.

FireSpy® 4430b(T)/4830b(T) - DapTechnology B.V.

The FireSpy4430bT and FireSpy4830bT as well as FireSpy4430b and FireSpy4830 bus analyzers are DapTechnology's latest 4-bus IEEE-1394 protocol analyzer. Based on the 4th generation FireSpy analyzer architecture the FireSpy4430b(T)/4830(bT) is the most advanced 1394 test equipment in the market. The FireSpy4430b(T)/4830(bT) in fact combine four FireSpy analyzers in one single instrument. They comprises a significantly more powerful on-board processor and improved connectivity to the host.

Product

Framegrabber

FastX1703

-

Alacron

FastX1703 - Alacron

The FastX1703 framegrabber series is for users who anticipate a demand for extreme I/O requirements and/or higher bandwidth, complex image processing and real-time high-speed storage in a cost effective platform. The base FastX1703, is a two thirds length raw form factor PCI board six basic 85 MHz Camera Link Channels or an extended Camera Link camera interface. An auxilliary I/O connector provides a header for adaptation of other high speed interfaces such as LVDS or high speed analog formats such as UXGA or DVI. The front-end data is formatted and preprocessed by a FPGA before being sent to the memory subsection, up to four PNX1702 500 MHz processors with 256MB memory each. Finally, the FastX1703 interfaces to the host computer through a 4xPCIe interface for state-of-the-art data acquisition.

Product

Flexible MiniPCI Express to PCI Express Adapter

SKU-035-XX

-

Amfeltec Corp.

SKU-035-XX - Amfeltec Corp.

The Flexible MiniPCI Express to x1, x4 or x16 PCI Express Adapter (Adapter) was designed to convert the MiniPCI Express bus into x1, x4 or x16Express bus and extend it. It allows you to connect a x1, x4 or x16 Express expansion add-in board to the motherboard’s MiniPCI Express connector.The Adapter includes an x1, x4 or x16 PCI Express adapter board, MiniPCI Express host board (full-size or half-size) and a PCI Express flat Cable.

Product

H/L Voltage Clamp Meters

-

MEWOI Electronics Co.,ltd

MEWOI Electronics Co.,ltd

High Voltage Current Transformation Ratio Tester breaks traditional structure, specially designed for high and low voltage first and secondary loop current, variable ratio, and current leakage test; apply the latest CT technology and mask digital integration technology, composed of special high-voltage clamp, low voltage clamp, host, high voltage insulation rod and monitoring software, etc; its wireless transmission test data can penetrate multiple building obstacles with a straight-line distance of 30 meters.

Product

Coaxlink Quad 3D-LLE

-

Euresys Inc.

Euresys Inc.

Laser line extraction with zero host CPU usageSingle and Dual Laser Line Extraction into a depth mapReal-time generation of 16-bit 3D height mapsChoice of algorithms: Maximum, Peak, Center of Gravity (COG)Precision: up to 1/256 pixel (with Peak and COG algorithms)Performance: 19,000 profiles/s from 1024 x 128 images. 38,000 profiles/s from 1024 x 64 imagesMemento Event Logging Tool

Product

PCI Express Board Retainer

SKU-038-0X

-

Amfeltec Corp.

SKU-038-0X - Amfeltec Corp.

The PCI Express Board Retainer prevents the host card from wiggling, and allows a PCI Express board to be held in place without a bracket.

Product

8 Port PCI Express

PEX 8609

-

Broadcom Limited

PEX 8609 - Broadcom Limited

The ExpressLane™ PEX 8609 offers 8 PCI Express Gen 2 (5.0 GT/s) lanes, capable of configuring up to 8 flexible ports and fully conforms to the PCI Express Base Specification, rev 2.0. PEX 8609 architecture supports a high-performance DMA engine with four DMA channels and internal buffer space for internal descriptor support. Up to 256 descriptors are supported internally or alternatively descriptors can also exist in host memory.

Product

Multi-Interface Frame Grabber

Xtium 2 CLHS PX8 LC

-

Teledyne DALSA

Xtium 2 CLHS PX8 LC - Teledyne DALSA

The Xtium™ 2 CLHS PX8 features CameraLink HS standard on the PCI Express™ Gen 3.0 platform. This single cable, single slot solution supports up to 4-CLHS lanes, each operating at 10.3 Gbits/s, to acquire images at up to 5.0 GBytes/s and transfer them using PCIe x8 slots to the host memory. The Xtium2-CLHS supports Active Optical Cable (AOC) to extend the cable length beyond 100 meters. Built-in data-forwarding and multi-board sync capabilities deliver a platform for distributed processing for high-speed, computational intensive machine vision applications.

Product

PCI Express Flat Cable

SKU-043-01

-

Amfeltec Corp.

SKU-043-01 - Amfeltec Corp.

12-inch PCI Express Flat Cable is used to connect a MiniPCI/MiniPCI Express/PCI Express host cards with PCI Express adapter boards.

Product

AdvintDAQ™ Data Acquistion

MAKO

-

ADVINT, LLC

MAKO - ADVINT, LLC

The Mako platform is based upon use of NI CompactDAQ (cDAQ) product line consisting of a chassis, NI C Series I/O modules, and a Windows host computer connected over USB, Ethernet, or Wi-Fi. Mako systems provide an easy, flexible, expandable platform to meet the needs of any electrical or sensor measurement system. They control the timing, synchronization, and data transfer between a host computer and up to eight (8) C Series I/O modules. A single Mako can manage multiple timing engines to run up to seven separate hardware-timed I/O tasks at different sample rates in the same system. Multiple units can also be daisy changed together for larger applications.