cPCI Digitizer
-
Product
Digital Sensors
PMA-Series
-
Solar Light’s NIST-Traceable PMA-Series Digital Sensors represent the pinnacle of accuracy, durability, and selection on the market today. Our sensors measure discrete bands of the electromagnetic spectrum from the UVA, UVB, UVA+B, UVC, Visible Light, and Infrared regions. Both narrow and broad bands are available to fit any application, including germicidal requirements, environmental probes, and sensors for biologically weighted spectra (such as the erythema and CIE action spectra.) Over 135 different sensors are available in a variety of packages to fit any environment, from indoor clean rooms to harsh locations outdoors to 100 meters under water. Please note that Solar Light offers both Digital Sensors and Analog Sensors in the PMA-Series lineup. Select these Digital Sensors if you prefer to plug into our PMA-Series Radiometers to read the output of the sensor on the meter’s display. Digital models are typically used as discrete sensors that are portable and located to provide short term information. (By contrast, please select Analog Sensors if you don’t need a digital display output of the reading, if you will be connecting to your own datalogger, or if you plan to use a voltage source to provide excitation voltage to the sensor and a digital volt or amp meter to read and convert the results. Analog Sensors are typically used as process sensors that are permanently installed to provide ongoing information.)
-
Product
Digital Splitters
Digital splitters for transmitting 1080p and 4K UHD signals
-
Your product description goes here.
-
Product
3U cPCI Serial Dual-Port SFP+ 10Gbps Ethernet NIC
SN5-TOMBAK
-
The SN5-TOMBAK is a peripheral slot card for CompactPCI® Serial systems, with a dual port 10Gbps Ethernet controller. Both ports are available via SFP+ front bezel connectors for optical cables via SFP+ transceivers or SFP+ twinaxial copper cables.
-
Product
48 Channel Threshold Comparator FPGA PXI Card
GX3748
-
The GX3748 is a user configurable, FPGA-based, 3U PXI card which features 48 voltage comparator channels. The daughter board interfaces to the GX3700 FPGA baseboard which employs the Altera Stratix III FPGA. Each input channel can accept input voltage signals from 0 to 50 volts, with programmable threshold levels. Three of the 48 channels are supported by the board's timestamp event feature.
-
Product
Digital Port
ZET 7060
-
*Digital port ZET 7060/ logical analyzer with RS-485 interface.*Control of the connected devices. Used in control and automation systems.
-
Product
Digital Geophone
ZET 7155
-
Digital geophone ZET 7155 is a vibration sensor with an integrated sensing element enabling conversion of ground oscillations velocity into a proportional electric signal. Vibration speed value is calculated automatically by means of an integrated processor.
-
Product
Digital Accelerometer
ZET 7152-N Pro
-
Digital accelerometer ZET 7152-N Pro is intended for recording of vibrational acceleration and is used as a component of stationary vibration monitoring systems used in technological and industrial spheres of application.
-
Product
Digital I/O Device
-
The Digital I/O Device supports channel, current, and voltage options to help you automate applications. This module features programmable input filters to remove chatter, noise, glitches, and spikes on inputs, and these filters also provide debouncing for digital switches and relays. You can use the module to perform safe operation when connected to pumps, motors, and other industrial actuators or machinery using the included power-up states. The module also provides a fail-safe mechanism that monitors for computer or application crashes and place the system in a state to ensure safe recovery. Additionally, some models include high-voltage, high-current, and isolation options to ensure the product can work safely in many environments.The Digital I/O Device includes the NI-DAQmx driver and configuration utility that simplify configuration and measurements. NI-DAQmx supports NI programming environments as well as Python, ANSI C, C#.NET, and MathWorks MATLAB® software.
-
Product
Digital Microscopes
-
TAGARNO digital microscopes give you unique and easy to use magnification equipment to use in a variety of quality control processes as well as R&D efforts or in your repair and rework in an endless range of segments. The digital microscopy camera technology enables you to see any small object in ultra sharp magnification and to document your work with just a single click. It also allows multiple viewers at the same time and thereby greatly improves collaboration.
-
Product
Digitizers
2745 Family
-
The 2745 Digitizer is a 64-channel digital signal processor for radiation detectors available in VME64 (V2745), VME64X (VX2745), and Desktop (DT2745) form factor. It offers not only waveform digitization and recording but also Multi-Channel Analysis for nuclear spectroscopy using Silicon strip, segmented HPGe, Scintillation detector with PMTs, Wire Chambers, and others. The 2745 can perform pulse height measurements (PHA), constant fraction timing (CFD), charge integration (QDC) and pulse shape discrimination (PSD) independently for each of the 64 channels.
-
Product
3U cPCI PPC SBC
75SBC4
-
NAI’s 75SBC4 is a 3U cPCI NXP™ QorIQ® P2041, PowerPC-based, Single Board Computer (SBC) with dual, high-speed/high-performance function module slots for configurable multifunction I/O interface expansion. Ideally suited for rugged defense, industrial, and commercial applications, this low-power, cost-conscious, SBC delivers off-the-shelf solutions that accelerate deployment of SWaP-optimized systems.
-
-
Product
Digital Multimeter
VOAC7602
-
Using the high-resolution LCD screen, you can view the measured values while watching the average, the maximum and the minimum values. Moreover, VOAC7602 enables you to observe the statistical values while viewing the Trend and the Histogram charts. Other than those above, there are various kinds of combinations of displays available to be shown aside and these can be chosen from many functions, such as LIMIT function, and Analog meter display, which is effective for analog judgment.
-
Product
Digital Pressure Gauges
-
Transcat has your pressure measurement needs covered with our full range of digital pressure gauges that are used in the shop, field, factory, off-shore platform and calibration lab. A digital gauge numerically displays absolute, differential and gage pressure readings. The instruments incorporate a variety of sensor types to indicate pressure changes, including mechanical deflection, thin film, strain gauge or piston. Our microprocessor-controlled gauges feature sophisticated sensors and are chosen according to media compatibility and operational environment. Choose your ideal gauges built by top makers, such as Crystal Engineering, Fluke and Druck, from our selection that reflects innovation.
-
Product
Digital Inclinometer
ZET 7154
-
Digital inclinometer ZET 7154 is used in static systems for platforms positioning control (2-axial mode) with a tolerance below 0,1 %. Low power voltage and CAN protocol enable integration of ZET 7154 digital inclinometer into almost any industrial system. “Set to zero” option allows to calibrate the sensor to zero in every axis, thus preventing platform critical tilt in the set coordinate.
-
Product
Digitizer
724 Family
-
The 724 is a family of CAEN Waveform Digitizer able to perform basic waveform recording and run online advanced algorithms (DPP) of pulse height analysis and dynamic acquisition window. Data is read by a Flash ADC, 14-bit resolution and 100 MS/s sampling rate, which is well suited for high resolution detectors as Silicon, HPGe or inorganic scintillators like NaI or CsI coupled with Charge Sensitive Preamplifers. In the waveform recording mode, algorithms of zero suppression are also implemented to reduce the data throughput. The acquisition can be channel independent and it is possible to make coincidence/anticoincidence logic among diferent channels and external veto/gating. Multiple boards can be synchronized to build up complex systems.
-
Product
Digital Insulation Mult-Meter
8010 IN
-
Standard Electric Works Co., Ltd
● Microprocessor controlled.● Four insulation test voltages (DC) : 125V, 250V, 500V, 1000V● The maximum insulation measurement range is 200G ohm @1000V.● 1mA test current on insulation test at nominal voltage.● With a hand strap for easier holding.● Large LCD (78 × 67mm)● Auto-ranging.● Bar-graph indication.● Backlight function.● REL(Auto-null) function.● Auto AC/DC voltmeter.● Capacitor test.● Auto-test stop & smart hold.● Supplied with high quality test leads.● Safety standard : EN 61010-1 CAT III 600V IEC 61557-1 IEC 61557-2 EN 61326-1
-
Product
PXIe-5763, 16-Bit, 500 MS/s, 4-Channel PXI FlexRIO Digitizer
785165-01
-
The PXIe-5763 is a PXI FlexRIO Digitizer that simultaneously samples four channels at 500 MS/s with 16 bits of resolution and features 225 MHz of analog input bandwidth. With over 73 dB of SNR, the PXIe-5763 is ideal for applications that require a wide dynamic range with a wideband digitizer. The FlexRIO driver includes support for finite and continuous streaming modes, and you can implement custom algorithms and real-time signal processing on the LabVIEW-programmable Xilinx Kintex UltraScale FPGA. Available in AC and DC coupled variants, the PXIe-5763 is ideal for both time and frequency domain applications, including radar prototyping, LIDAR, communications, microscopy, OCT, event detection, and particle physics.
-
Product
Digital Clamp Tester
M-1800
-
MULTI MEASURING INSTRUMENTS Co., Ltd.
*80mmφCT window and wide AC current measurements from 0.1A to 1000A.*DCmV analog data output for recorder.
-
Product
Ultra-Slim Digital Signage
DS-085
-
Intel Tiger Lake UP3 Ultra-slim Digital Signage Player. Power by Intel Tiger Lake UP3 processor. Powerful graphic engine - Intel iRIS Xe graphics. 19mm-thin chassis ideal for space-limited installation.
-
Product
Digital Oscilloscope
OCTs4M
-
The module is intended for use as part of an automated control system of the VXI standard as a digital oscilloscope.
-
Product
cPCI Backplanes
-
CompactPCI bus is compatible, in terms of electrical specification, with the PC world’s PCI bus. The mechanical specifications were adapted to the commonly used Euro-board plug in systems for 19" racks.
-
Product
Giga-Sample Waveform Digitizer
ATS9870
-
ATS9870 is the world''s first Giga-sample waveform digitizer based on the 8-lane PCI Express interface. Boasting data throughput as fast as 1.6GB/s (1600 MB/s) and sample rate of 1 GS/s across 2 simultaneous inputs, ATS9870 is an ideal solution for many applications, including radar, ultrasonics, spectrometry and RF signal recording.
-
Product
PXI 32 Chan I/O Parallel I/P Prog Threshold
40-412-111
-
A 32-channel Digital I/O module with high output voltage and currentcapability and a dual variable threshold input. Each of the 32 channel outputs can be used to drive the output high or low usinga high current capacity drive capable of sourcing 0.4A from the high side or 0.5Asink on the low side for each channel. The module is available in two versions witheither serial or parallel capture of the input levels.
-
Product
PCIe-4065, PCI Express, 6½-Digit, ±300 V Digital Multimeter Device
779771-01
-
The PCIe‑4065 makes AC/DC voltage, AC/DC current, and 2‑ or 4‑wire resistance measurements, as well as diode tests. It is ideally suited for OEMs, educational laboratories, or other cost-conscious test and measurement applications.
-
Product
Digital Multimeters
-
Keysight's digital multimeter (DMM) family offers exceptional performance and reliability from 3.5 to 8.5 digits resolution with speeds up to 100,000 readings/sec, and available in handheld or bench applications. With a Keysight DMM you can:
-
Product
Digital Torque Screwdriver
NDID-150CN
-
Tightening of screws and bolts and final checks. Digital torque driver idling type. An idling type torque driver that can record the torque and the number of tightening by tightening until it makes a "click" sound. When the specified torque value is reached, the clutch automatically disengages and idles, so there is no need to worry about over -tightening.
-
Product
Digital frequency counters
-
The instrument is equipped, in addition to the 20 Hz-160 MHz input, a second input for measurement up to 2.4 GHz with an impedance of 50 Ohms.
-
Product
Digital Force Gauges
-
Digital force gauges are powerful yet user-friendly gauges, designed for either handheld use or test stand mounting. These digital force gauges and torque gauges offer the best price performance value of any digital force gauge available, along with a high precision and an easy to use force measurement solution.
-
Product
Digital Multimeter
6410 DM
-
Standard Electric Works Co., Ltd
● 3000 counts with a maximum display of 2999.● Angled display design helps the user to identify the reading of value easier.● Auto scanning function for AC/DC voltage, and current.● Auto ranging.● Range change function.● Continuity check.● Diode & Capacitance measurement.● Data hold function.● Low battery indication.● Over range indication.● Fuse protection.● Special hook design used to hang the meter for ease of use.
