Backplanes
An interconnection structure allowing multiple printed circuit boards to coexist using a single bus.
-
product
VME Bus Tester
VBT100
The VBT100 has been designed to withstand and measure excessive voltages on both signal and power supply pins. This capability allows it to operate in faulty backplanes that could damage other boards. The tester also detects, measures and identifies which signals have excessive voltages so they can be repaired before boards are loaded into a backplane.
-
product
3U CompactPCI Serial 3-slot SSL w/o RTM w/ Ethernet
1CPCIS-303-L200
3U CompactPCI Serial Backplane with 3 CompactPCI S.0 slots, system slot left, without rear IO : 1x CompactPCI S.0 CPU slot, 2x CompactPCI S.0 peripheral slots, without connectors for RTMs (RearTransition Modules), Ethernet routed as full mesh.
-
product
CompactPCI Chassis 8 Slots
3U/84HP
Hartmann CompactPCI 3U system platform provides an intelligent, practical packaging solution for high-performance processors. The full width rack mount model provides an 8 slot 3.3V or 5V I/O 3U cPCI backplane for vertical mounting of boards.
-
product
PXI Prototyping Module, 1-Slot, 9-Pin D-Type
40-225A-701
The 40-225A PXI Prototyping Modules are stripped down versions of the 40-220A PXI Breadboard series. These are very basic, low cost prototype modules. They have no PXI interface but do have access to fused power supplies from the PXI backplane.
-
product
5-Slot 64-Bit 6U CompactPCI H.110 Bus Backplane
cBP-6405R
- PICMG:2.0 R3.0, 2.1 R2.0, 2.5 R1.0- Dimension (mm, WxH):120.9 x 262.05 (mm, WxH, vertical insertion view)- Segment:One- cPCI Bus:Up to 64-bit/66MHz- System Slot:Right-hand side (upper side for board's horizontal insertion)
-
product
Dual PCI 2.2 Hot-Swap Controllers
MAX5916
The MAX5915/MAX5915A/MAX5916/MAX5916A dual PCI 2.2 hot-swap controllers allow for safe insertion and removal of two PCI cards into live PCI slots or backplanes by limiting the inrush current at startup. After startup, these devices provide protection against short-circuit, overcurrent, and undervoltage conditions.
-
product
VME64X 7U 16 slot with P0
101V64XM16-0621R
7U VME64x Backplane 16-slot with P0, compliant with ANSI/VITA 1.1-1997, VME extension, and VITA 1.7 Increased Current. The extra 1U provides room for extra power bugs or busbars. Includes termination passive inboard and daisy chain automatic active.
-
product
CompactPCI 14+2 Slot
The CompactPCI® 14 CPCI slot + 2 PSU slot backplane uses CPCI bridging to enable 2 PCI segments.
-
product
3U / 6U PXIe Chassis
The GX7100e Series are 14-slot combination PXIe chassis that accommodate a 3U PXIe embedded controller or a MXI express controller as well as 3U & 6U PXI / PXIe insruments in 4U of rack space. The GX7100e’s unique format includes seven 6U slots and seven 3U slots arranged horizontally to reduce the overall size of the chassis, providing the versatility and high-density necessary to address many PXI / PXIe applications and requirements. The backplane architecture supports Gen 2, 4x4 PCI Express bus signaling and the use of both x1 or x4 system controllers. By offering a combination of PXI-1, Hybrid, and Express slots, the GX7100e offers users the ultimate in flexibility for general purpose as well as high bandwidth test needs.
-
product
PXIe-6672, TCXO PXI Synchronization Module
780063-01
PXIe, TCXO PXI Synchronization Module—The PXIe‑6672 is a system timing controller module. It can drive the PXI star trigger lines, import and export PXI backplane clocks and triggers, generate a high-resolution direct digital synthesis (DDS) clock, and generate a high-stability temperature-compensated crystal oscillator (TCXO) 10 MHz Reference Clock for instrumentation. The PXIe‑6672 allows you to synchronize multiple PXI Express systems, synchronize a PXI Express system with external instruments and equipment, and increase the accuracy of instruments within a PXI Express system.
-
product
CompactPCI Backplanes
Model types include 3U and 6U, 32bit and 64bit, 33 MHz and 66 MHz. We offer several variations including EasyCable, EasyPlug, Low Profile, 32-bit, PICMG 2.16, and the latest CompactPCI Serial.
-
product
VME J1 18 Slot with ADC Connectors
101VMEJ118-0590
VME J1 backplane 18 slot, compliant with ANSI/VITA 1-1994. 8-layer stripline design Includes passive termination inboard and automatic daisy chain connectors.
-
product
3U CompactPCI Serial 4-slot SSR w/ RTM w/ Ethernet
1CPCIS-304-R210
3U CompactPCI Serial Backplane with 4 CompactPCI S.0 slots, system slot right, with rear IO : 1x CompactPCI S.0 CPU slot, 3x CompactPCI S.0 peripheral slots, with connectors for Rear Transition Modules (RTMs) in slots 1 to 3, Ethernet full mesh.
-
product
Multifrequency Clock Synthesizer - 6U VPX
Model 5890
- Simultaneous synthesis of up to 10 different clocks- 16 SMC clock outputs- Typical phase noise: 105 dBc/Hz @ 1 kHz offset- All clocks are phase-locked to input reference signal- Input reference frequency of 5 to 100 MHz- Eight quad VCXOs allow selection from 16 different base frequencies- Output clocks of 1, 2, 4, 8, or 16 submultiples of VCXO base frequencies- Output clock frequencies between 50 and 700 MHz- Control and status over the VPX backplane
-
product
Backplanes
Beijing Rdekono Electronic Equipment Co.,Ltd.
We specialize in providing durable, customizable subrack kits that ensure seamless integration with backplanes. With our commitment to quality and innovation, we deliver solutions that meet the highest industry standards for performance and reliability.
-
product
PXI FlexRIO Coprocessor Module
PXI FlexRIO Coprocessor Modules feature high-performance FPGAs that add signal processing capability to PXI systems. These modules leverage the latest FPGAs from Xilinx, streaming technologies such as PCI Express, and NI Peer to Peer Streaming for high-bandwidth data communication with other modules over the backplane. When paired with another PXI device, such as a PXI Vector Signal Transceiver, PXI FlexRIO Coprocessor Modules provide the additional FPGA resources required to run complex algorithms in real-time.
-
product
PXI 8 Slot 3U
3U, 19” Rackmount system with integrated ATX Power Supply and PXI Backplane. The system support 3U 8 slots Front cards. The Backplane is compliant with PXI Rev.2.0/2.2 and PICMG 2.0 Rev 3.0 specifications. The system slot can be located at the left hand. The system is equipped with an ATX fixed power supply.
-
product
CompactPCI Instruments
Is a computer bus interconnect for industrial computers,combining a Eurocard-type connector and PCI signaling and protocols. Boards are standardized to 3U or 6U sizes, and are typically interconnected via a passive backplane. The connector pin assignments are standardized by the PICMG US and PICMG Europe organizations. The connectors and the electrical rules allow for eight boards in a PCI segment. Multiple bus segments are allowed with bridges.
-
product
3U VPX Development Kit
This development kit enables efficient 3U VPX backplane design and software verification.- 3U VPX architecture- One CPU blade, one GPU blade (optional), SOSA-aligned- 1TB NVMe pre-installed in CPU blade- Rear transition module(s) included- Test Frame with backplane pre-installed
-
product
PXIe-1083, 5-Slot (5 Hybrid Slots), Up to 2 GB/s PXI Chassis
787026-01
PXIe, 5-Slot (5 Hybrid Slots), Up to 2 GB/s PXI Chassis - The PXIe‑1083 features a high-bandwidth, all-hybrid backplane to meet high-performance test and measurement application needs. This PXI chassis features all hybrid connectors, 58 W power and cooling, and an integrated … Thunderbolt 3 MXI-Express controller.
-
product
13-Slot 64-bit 6U Compact PCI Backplanes
cBP-6413DR
- 2 Systems- cPCI Bus: up to 64-bit/66MHz- System A: 1 system + 7 Peripherals- System B: 1 system + 4 Peripherals- 1 CMM slot
-
product
PXI Prototyping Module, 1-Slot, 78-Pin D-Type
40-225A-401
The 40-225A PXI Prototyping Modules are stripped down versions of the 40-220A PXI Breadboard series. These are very basic, low cost prototype modules. They have no PXI interface but do have access to fused power supplies from the PXI backplane.
-
product
5-slot ATX-supported 2U Butterfly PICMG 1.3 Bus Passive Backplane
FAB205
The FAB205 features a PICMG 1.3 CPU card slot, five 32bit/33MHz PCI slots, and built in a 24-pin ATX power connector and 8-pin connector for thermal detected board. The FAB205 is optimized to support AXIOMTEK's PICMG 1.3 system host boards, the SHB100 and SHB110, which are built around the PICMG 1.3 form factor. The FAB205 is compatible with the AX61220/AX61222 chassis.
-
product
3U VME J1 Classic 2-slot With 12A Fastons
50510-202-3600
3U VMEbus J1 backplane 2-slot, VITA, termination passive inboard, daisy chain without power, power connection 12A fastons, I/O pins 13mm gold-plated, shroud (1P1) without latches.
-
product
3U VPX
VPX systems implement 3U and 6U board computing and offer enormous bandwidth potential on the backplane thanks to a new multigig connector.PCIe, GETH traffic on the VPX backplane can be found today. Soon VPX will also include 10GETH, RapidIO, and high speed inter FPGA I/Os.Kontron offers the essential building blocs to create efficient and economical VPX embedded computers.
-
product
VME J1 6 Slot with ADC Connectors
101VMEJ106-0590
VME J1 backplane 6 slot, compliant with ANSI/VITA 1-1994. 8-layer stripline design Includes passive termination inboard and automatic daisy chain connectors.
-
product
14-slot ATX-supported PICMG 1.3 Bus Passive Backplane
FAB100
The FAB100 features one CPU card slot, four ISA slots, four PCI-E x1 slots, one PCI-E x16 slot, and four 32bit/33MHz PCI slots. This PICMG 1.3 backplane also supports a built-in 24-pin ATX power connector. Furthermore, the FAB100 delivers outstanding system performance through high-bandwidth interfaces such as Serial ATA and USB 2.0 high speed peripheral (optional function). It is designed for all of PICMG 1.3 single board computers, and is a perfect fit for AXIOMTEK's SHB100 & SHB110, which are built around the PICMG 1.3 form factor. We also have various 4U-high enclosures, AX6156E, AX6156LE, AX6156LLE, AX6156LLES, AX61400, AX61491 and AX6145, to house the FAB100 and any customer's industrial integrations flexibly.
-
product
PXIe-1084, 18-Slot (17 Hybrid Slots), Up to 4 GB/s PXI Chassis
786397-01
PXIe, 18-Slot (17 Hybrid Slots), Up to 4 GB/s PXI Chassis - The PXIe-1084 features an all-hybrid backplane to meet a wide range of high-performance test and measurement application needs. It also offers a Timing and Synchronization option that includes external clock and trigger routing. The hybrid connector type in every peripheral slot enables the most flexibility in terms of instrumentation module placement.
-
product
OnyxFX FlexorSet 2-Ch. 3.0 GHz A/D, 2-Ch. 2.8 GHz D/A - 3U VPX
Model 5973-320
- Includes Xilinx Virtex-7 FPGAs- GateXpress supports dynamic FPGA reconfiguration across PCIe- Two 3.0 GHz A/Ds- Two 2.8 GHz D/As- Two digital downconverters- Two digital upconverters- 4 GB of DDR3 SDRAM- Sample clock synchronization to an external system reference- PCI Express (Gen. 1, 2 and 3) interface up to x8- User-configurable gigabit serial interface- Optional optical Interface for backplane gigabit serial interboard communication- LVDS connections to the Virtex-7 FPGA for custom I/O and synchronization- Compatible with several VITA standards including: VITA-46, VITA-48 AND VITA-66.4 and VITA-65 (OpenVPX™ System Specification)- Ruggedized and conduction-cooled versions available- Xilinx Sublicense FAQs - Pentek Sublicensing Agreement for Xilinx JESD204 IP Cores
-
product
General PXI Instrument
Platform features the industry- standard, 8-slot/14-slot/18-slot PXI/ CompactPCI backplane integrated into a 3U Eurorack enclosure with a bay for removable power supplies.
