-
Product
PoE Module
-
PoE-PSE I/O boards comply with IEEE802.3af standard via an internal cable connected to LAN port on a SBC to power an external PoE device
-
Product
WebSensor with PoE
T0610
-
Ambient temperature t-line Web sensor with Power over Ethernet feature. Remote alarm.
-
-
Product
1GE PoE Splitter
EKI-2711PSI
-
Supports 10/100/1000Base-T(X) for Power over Ethernet (PoE) input and data output. Delivers up to 25 watts of power while separating power and data from PoE sources. Features power isolation and short-circuit protection for enhanced power output safety.
-
-
Product
Web Sensor with PoE
T7613D
-
Ambient temperature, relative humidity, atmospheric pressure t-line Web sensor with Power over Ethernet feature. Remote alarm. Duct mount.
-
Product
Thermometer with PoE
T4611
-
PoE Web Sensor for external Pt1000 temperature probe. Power over Ethernet feature according IEEE 802.3af is supported.
-
Product
Web Sensor with PoE
T3611-2
-
Ambient temperature, relative humidity t-line Web sensor with Power over Ethernet feature. Remote alarm.
-
Product
Web Sensor with PoE
T7611-2
-
Ambient temperature, relative humidity, atmospheric pressure t-line Web sensor with Power over Ethernet feature. Remote alarm.
-
Product
PoE Media Converters
-
Upgrade Ethernet networks with PoE powered IP devices in remote locations without replacing existing copper wire infrastructure.
-
Product
Web Sensor with PoE
T7611
-
PoE Web Sensor with relative humidity and temperature probe on the cable. Built-in atmospheric pressure sensor.
-
Product
PoE Voltage Monitor Detect & Verify
PE-400
-
PE-400 is specific to test and verify PSE or Ethernet outlet either a standard/active PoE or a NON-standard/passive PoE to avoid damaging Non-PoE device as well as monitor and display available Voltage simultaneously. It built-in PoE interface controller to trigger on 802.3 af, at and bt switch and verify standard PoE type either 802.3 af or 802.3 at, and power source either End or Mid or both, and power polarity as well as display voltage values. The operational voltage which should be measured when installing a new PoE system or when you troubleshooting an existing system.
-
Product
EN 50155 M12 8GE PoE + 2GE Managed Switch
EKI-9510G-MPW
-
M12 connector with IP67 rugged housing, Complies with EN50155 & EN50121-3-2, Complies with EN45545-2 & EN61373, Supports PoE IEEE802.3af/at, Wide nominal power input range: 24~110VDC; Operating power input range: 16.8~137.5VDC.
-
Product
Web Sensor with PoE
T3611
-
Ambient temperature, relative humidity t-line Web sensor with Power over Ethernet feature. Remote alarm.
-
Product
6GE Port Gigabit Unmanaged Industrial PoE Ethernet Switch
EKI-2706G-2GPI
Ethernet Switch Module
6 Gigabit RJ-45 Ethernet ports. Support 4 x IEEE 802.3at/af PoE ports for PD demands, Up to 30W output per PoE port. Supports jumbo frame transmission up to 9k bytes, 12 ~ 48 VDC redundant dual power input and 1 relay output, Wide operating temperature range of -40 ~ 75°C.
-
Product
2GE PoE, SFP Injector
EKI-2742FPI
-
Supports multi-rate for SFP slot, IEEE 802.3af/at compliant, Power input 48 VDC, supply 30W per port, Provides slim size and DIN-rail/Wall mount with IP31 metal mechanism.
-
Product
EN50155 Managed PoE Ethernet Switch
EKI-9528E-8GMPX
Ethernet Switch Module
M12 connector with ruggedized IP54 certified housing, Complies with EN50155 and EN50121-3-2 standards, 24 x PoE IEEE802.3af/at ports, Wide nominal power input range: 24 ~ 110VDC. Operating power input range: 16.8 ~ 137.5VDC, X-Ring Pro delivers rapid and predictable convergence.
-
Product
8GE PoE And 2G Combo Managed Ethernet Switch
EKI-7710G-2CP
-
8 x IEEE 802.3 af/at PoE Gigabit ports + 2 x Gigabit Copper/SFP combo ports, SFP socket for Easy and Flexible Fiber Expansion, Redundancy: Gigabit X-Ring Pro (ultra high-speed recovery time < 20 ms), RSTP/STP (802.1w/1D) IXM function enables fast deployment, Security: 802.1x (Port-Based, MD5/TLS/TTLS/PEAP Encryption), RADIUS.
-
Product
LAN (PoE) Expansion Kit (supporting Gbit Ethernet)
OP-SB89G
-
OP-SB89G is an expansion board for Ethernet LAN (supporting Gbit), inserting into a slot of portable communication analyzer (LE-8200A/LE-8200). It is a stand-alone LAN analyzer, exchanging the measurement board and line state sheet for LAN signals. The monitor function measures data at real time by simply connecting the LAN cables. The packet generation function transmits frames from the analyzer at wire rate.
-
Product
8GE+4 10G SFP L2 Managed PoE+ Switch
EKI-7412G-4XP
-
8 Gigabit Ethernet Ports and 4 10G SFP Ports, 0 to 60°C operating temperature range, Supports 8 IEEE802.3af/at PoE ports. 140W PoE Power Budget, Management: SNMP v1/v2c/v3, WEB, Telnet, Standard MIB, IXM Function Enables Fast Deployment.
-
Product
Reach Power-over-Ethernet (PoE) Testers
-
After assembly, electronic equipment manufacturers need to test functionally of their products. They want to provide the most test coverage, in the shortest time, for the least cost. When test engineers develop product test plans, they select the most appropriate off-the-shelf general purpose test equipment available. Reach designs and manufactures custom test equipment which is a better fit than general purpose equipment. It not only reduces test time but also reduces costs.
-
Product
Rugged Cisco IP Router With Firewall & PoE+
NetSys-5311
-
The rugged design of the NetSys-5311 brings Cisco’s ESR-6300 Embedded Services Router and its Cisco-certified mobile IP routing protocols to the network edge in a SWaP optimized chassis.
-
Product
1GE PoE, SFP Injector ,IEEE802.3af/at, 24~48VDC, -40~75℃
EKI-2741FPI
-
Supports multi-rate for SFP slotIEEE 802.3af/at compliantPower input 24-48 VDC, supply 30W per portProvides slim size and DIN-rail/Wall mount with IP31 metal mechanismSupports operating temperatures from -40 to 75°C
-
Product
Unmanaged PoE Switches
-
Advantech's PoE unmanaged switches provide power for devices via Ethernet cable, eliminating the need for additional wiring.
-
Product
4GE PoE+1GE, Unmanaged Ethernet Switch, IEEE802.3af/at, 24~48VDC, -40~75℃
EKI-2705G-1GPI
-
Supports 10/100/1000 Mbps Auto Negotiation, Supports jumbo frame transmission up to 9 kbytes, DIN-rail with IP30 metal mechanism, Redundant 24~48 VDC power input. 4 x IEEE 802.3 af/at PoE ports + 1 x Gigabit Copper.
-
Product
Robust DIN-rail Fanless Embedded System With Intel® Celeron® Processor N3350, COM Or CAN, PoE LAN And DIO
ICO320-83C
-
The ICO320-83C is a fanless DIN-rail embedded system with four RJ-45 Gigabit PoE ports for facility monitoring systems, IP video surveillance, Access Point and intercoms. This endurable industrial IoT gateway has an IP40-rated heavy-duty aluminum extrusion and steel enclosure for use in harsh environments. It can operate under wide temperature ranging from -40°C to 70°C and withstand vibration up to 2G. It is powered by the high-performance Intel® Celeron® processor N3350 or Pentium® processor N4200 and has one DDR4-2133 SO-DIMM for up to 8 GB of system memory. The ICO320-83C offers complete expandability and full-featured I/O, including four RJ-45 Gigabit PoE ports or four RJ-45 LAN ports, two RS-232/422/485 ports, two USB 3.0 port, one VGA port, one CANbus 2.0 A/B port, and one 8-bit programmable DIO. It also offers one full-size PCI Express Mini Card slot (USB/PCIe) and one half-size PCI Express Mini Card slot (mSATA/USB/PCIe) for wireless modules. It has a SATA drive and half-size mSATA shared with PCI Express Mini Card slot for storage. The industrial-grade embedded platform is compatible with Windows® 10 IoT and Linux operating systems. To fulfill the requirement of remote monitoring at factory, the ICO320-83C supports Axiomtek’s exclusive AMS.AXView software. This reliable DIN-rail embedded system is certified with EN60950, CE and FCC. It offers an RTC battery onboard. It also supports a wide range 12 to 24 VDC terminal block power input with various power protections, including OVP, UVP, OCP, and RVP.
-
Product
PoE Modbus TCP Based Dual Ethernet Port I/O Modules
-
The PET-7200 Series are communicable over Modbus TCP, can be Powered over Ethernet (PoE) and have 2 Ethernet ports for daisy chain configuration. The built-in two-port Ethernet switch is to implement daisy-chain topology. The cabling is much easier and total costs of cable and switch are significantly reduced. They are configurable over a built-in web server and have a Web HMI.
-
Product
EN50155 Managed PoE Ethernet Switch
EKI-9528E-8GMPW
Ethernet Switch Module
M12 connector with ruggedized IP54 certified housing, Complies with EN50155 and EN50121-3-2 standards, 24 x PoE IEEE802.3af/at ports. Wide nominal power input range: 24 ~ 110VDC, Operating power input range: 16.8 ~ 137.5VDC, X-Ring Pro delivers rapid and predictable convergence.
-
Product
Machine Vision SBC With AMD® Ryzen™ Embedded V1807B And V1605B APU, DisplayPort, HDMI, 2 GbE LAN, 2 IEEE 802.3at PoE GbE LAN And Vision-specific I/O
MIRU130
-
*AMD® Ryzen™ Embedded V1807B and V1605B APU*2 DDR4 SO-DIMM for up to 16GB of memory*2 GbE LAN and 2 IEEE 802.3at PoE GbE LAN*2-CH camera trigger outputs*2-CH LED lighting control*1-CH incremental quadrature encoder input*4 isolated DIO
-
Product
4FE PoE+1GE, Unmanaged Ethernet Switch
EKI-2705E-1GPI
-
4FE PoE+1GE, Unmanaged Ethernet Switch, IEEE802.3af/at, 24~48VDC, -40~75℃, Supports 10/100 Mbps Auto Negotiation, Supports jumbo frame transmission up to 9 kbytes, DIN-rail with IP30 metal mechanism.
