Cables
See Also: Cable Assemblies, Cable
-
product
Saluki S2107 Series Optical Cable Identifier (up to 36dB)
S2107 Series Optical Cable Identifier is an intelligent instrument designed for the construction and maintenance of optical cable lines in optical communication system. In view of the complex wiring environment and the difficulty of locating faults during the construction and long-term use of optical cables, S2107 series can provide fast, effective and accurate fault solutions. When the target optical cable is bent or shaken, the optical cable census instrument can quickly capture the vibration signal and display it through waveform and sound, so as to locate the target optical cable quickly.
-
product
Cable Assembly, 50-Pin D-Type, Male to Unterminated With Ferrules, 1m
A050DM5-F-0A100
The 50-Pin Connector to Unterminated Cable Assy is constructed from PFA insulated wire and can be secured to the product by screwlocks. The 50-Pin Female connector option of this cable assembly is suited for direct connection to Pickering Interfaces products.
-
product
Piezo Velocity Sensor
VE102
Piezo Velocity Sensor, Side Exit Connector / Cable, 100 mV/in/sec
-
product
SMD Tweezer
U1782B
The Keysight U1782B is a tweezer to be used with the U1700 Series handheld capacitor and handheld LCR meters. For better noise immunity, the tweezer has a guard end to be connected to the meter´s guard terminal. The tweezer is now redesigned with a new shielded rigid cable to improve both usability and measurement stability.
-
product
Extension Wires And Cables
Omega offers thermocouple, RTD and thermistor extension wire and cable. We offer a wide variety of calibration, gauges, sheath material, insulation, connector types and shapes.
-
product
Optical Power Meter
PM-202B
The all-in-one PM Series Optical Power Meter are designed for use with an Optical Source for performing optical loss measurements on fiber optic cables. The PM-202 series are designed for affordable budgest, but meet the basic demands for real world testing. With a smaller size and weight, it’s easy to take these units into any enviroment.
-
product
Ethernet Cable Emulator
Upon different commands, it can simulate different network cable lengths, including 3 Modes: Bypass, Short, 100M. It can be used independently or jointly with other devices.
-
product
Compact DMX Signal And Cable Diagnostic Tool
PROTESTER
Checks DMX512 signal and 5-pin data cables. Nine diagnostic indicator LEDs. Bright, white LED flashlight built in. Leather carrying pouch included. Small, lightweight, brushed aluminum finish.
-
product
Minimal Signal Noise
SCSI Quiet Cables
Paralan Corporation was one of the first companies to recognize that 90% of the problems with SCSI Bus installations lie with the cables. To address this problem, Paralan developed its own line of high-quality shielded Quiet Cables.
-
product
Portable Dew Point Monitor
1500
The Model 1500 is a self contained system; not only is there no field assembly required, there’s no need to carry around a myriad of individual components such as control boxes, sensors, cables, pumps, and power cords. Simply attach the sample line, adjust the flow (with the integral flow meter) and turn on the power. Within minutes you’ll be collecting field dew point data with the same chilled mirror accuracy of a lab standard hygrometer. And with a nominal battery life of 12 hours, you will be able to collect for the entire shift or spot check your processes for several days.
-
product
MPO Visual Cable Verifier Kit
KI-TK872
Kingfisher's unique and innovate MPO Visual Cable Verifier Kit is a quick, versatile and inexpensive way to visually check MPO cable installations and patch leads for polarity and continuity, and overall end face condition. Just connect the source, and view the far end with the microscope to observe the repeating color pattern at the far end.
-
product
Cable Assembly, Receiver, QuadraPaddle, 20", 200 Pin Male LFH w/ M3 Jackscrews
540105080140
Cable Assembly, Receiver, QuadraPaddle, 20", 200 Pin Male LFH w/ M3 Jackscrews.
-
product
Temperature Sensors
We offer a variety of models of type-K temperature sensors / thermocouples. There is a standard temperature sensor, such as: surface sensor, penetration sensor, immersion sensor or special sensor with an adhesive tape, a patch, a Temperature Sensor overview screw, or a flexible cable. Consider the different combinations of materials and measurement ranges of a temperature sensor. With the help of thermal elements, temperature measurement problems can be solved in industrial processes, in machines and installations, such as in the environmental sector, and reliable results obtained.
-
product
Xtium Frame Grabber Family
The Xtium series delivers higher bandwidth to sustain Camera Link 80-Bit modes over longer cable distances and supports a wide variety of area and line scan color and monochrome cameras, all in a compact, single slot solution.
-
product
ITA, ICon, With Protective Cover
410123101
The iCon ITAs small width and inboard handle allow for easy side-to-side stackability. The u-shaped cable clamp allows modules to be pre-wired before assembly and offers a maximum cable bundle diameter of 1.21". The slide-off cover allows easy access to wiring for maintenance and probing.
-
product
CO2 Concentration Transmitter
H5421
The device is supplied with CO2 probe with 1m cable. Cable lengths 2, 4 or 10 meters available optionally.
-
product
4-Pin Power D-Type Female Connector, 40A, With Backshell
40-960-004-F
This connector is designed to allow users to directly terminate a cable with soldered connections.
-
product
Audio Cable Testers
AudioJog Pro 5
ALL new Audio cable tester with SINGLE & DOUBLE ended testing. There are 2 rows of 6 LED's corresponding to each of the possible connector pins and one for the screen (or ground) connection. As each pin is activated, the LED's indicate all connections associated with that pin, so that short, open and crossed circuits can be easily found.
-
product
500-Pin SEARAY Cable Assembly, Male to Unterminated, Ferrules, 1 Amp, 2m, 500 Port
A500RMR-F-1B200
The 500-Pin SEARAY connector is used on switching products to provide a very high density 1A connector solution that is suitable for use to 200VDC.
-
product
BNC Coaxial Cable (1.5 M Or 3 M)
16493B
16493B is suitable for general and low noise applications for up to 40 V and 200 mA.
-
product
96-Pin SCSI Micro-D Straight PCB
40-963-096-SM
Ideal for user created termination schemes where the termination is to be on the front of the product or remotely connected to the module by cable. Suitable cables for this product are detailed in the data sheet. Interfacing PCBs should be designed with suitable clearances for the voltage the application requires.
-
product
50 Ohm MMCX to MMCX Cable Assembly
40-977-571-0.1m
This 0.1m long MMCX cable assembly is part of the range of RF cables. Pickering Interfaces offer a range of RF cable assemblies to complement our extensive range of PXI, LXI, PCI, VXI and GPIB switching products. All cable assemblies are made from high quality materials and use best practice assembly methods to ensure the cabling matches the performance of the switching modules they support.
-
product
HV BM Split Modules
The HV BM Split Modules use the proven technology of the HV Breakout Modules for fast and precise measurement of internal conductor current, voltage and power even in confined spaces. HV BM Split Modules can be used to perform measurements in HV power cables or also on busbars.
-
product
Three-Channel Version of Rapidox 3100
Rapidox 3100 OEM-3
The Rapidox 3100 OEM-3 is a three-channel version of our high-performance zirconia oxygen (O2) analyser. Supplied in a metal controller box, the Rapidox 3100 OEM-3 comprises three individual zirconia sensors on bespoke length cables with several options for gas fittings.
-
product
Cable Assembly, 37-Pin D-Type, Female to Unterminated With Ferrules, 0.5m
40-972-037-0.5m-FU
The 37-Pin Connector to Unterminated Cable Assy is constructed from PFA insulated 19/0.18 (21AWG) wire and can be secured to the product by screwlocks. The unterminated connections are coded to match the connector pin designation and include crimped on ferrules to ensure the wire strands cannot break when they are terminated. Please ensure appropriate electrical safety precautions are observed when using this product.
-
product
Volt Tester
PPTVM01
The DC Voltage Tester is an easy-to-use tool that can quickly test for voltage. Perfect for testing batteries, lighting systems, trailer connections, and more. This voltage tester is self-powered with a 210 cm cable. LCD displays voltage readings from 5 volts to 35 volts.
-
product
RF Connectors
FAKRA Connectors
The latest generation of FAKRA connectors, generation 4.0, features an upgraded SMB connector design with stamped and formed construction for fully automated cable termination. The connectors feature removable connector housings for field replacement, if necessary, and are mechanically keyed and color-coded to prevent mismating on the production line. This generation of USCAR and FAKRA 2 compatible connectors is compatible with all previous FAKRA products.
-
product
Cable Assembly 44-Pin D-Type Male to Unterminated With Tinned Ends, 2m
A044HM5-T-0A200
The 44-Pin Connector to Unterminated Cable Assy is constructed from PFA insulated 7/0.15 (26AWG) Silver Plated Copper Wire. The connector can be secured to the product by screwlocks.
-
product
LCR Meter, Hand Held, 20 H, 600 µF, 20 Mohm
72-8155
72-8155 is a 3-1/2 digit digital capacitance meter with steady operations. The meter measures resistance, capacitance and inductance. The meter has a broad capacitance measurement range and precise accuracy. It can be used in measuring the circuit designed capacitance of cable, switch and PCB layout.





























