Unmanned Surface Vehicles
deploy and forget sensor array. Also known as: USV
-
Product
Surface Analysis
Innova-IRIS
-
This provides researchers a perfect combination of chemical or crystallographic information at high spatial and spectral resolution with the most advanced atomic force microscopy characterization. The Innova-IRIS can be integrated with your choice of a leading Raman system to provide the best opaque sample TERS investigations available today. However you tailor your system, your application will benefit from Bruker exclusive, high-contrast IRIS TERS probes and the best tip preservation and lowest drift, guaranteeing that alignment is preserved even over the optical integration times necessary to interrogate weak Raman scatterers.
-
Product
Vehicle Network Simulator
OBD Simulator™
-
Simulate Vehicle Network Messaging for OBD CAN, J1939 CAN, J1850 VPW, J1850 PWM, ISO-9141 and KW2000.
-
Product
Inclined Surface Coefficient Of Friction
DRK138
-
Shandong Drick Instruments Co., Ltd.
DRK138 Inclined Surface Coefficient Of Friction Tester is applied to testing the COF of film, paper, card board, sheet and so on. By testing the material’s frictional properties, the open performance of packages, packaging speed of packers and other indexes could be controlled to meet the requirements for production
-
Product
19" Drawer with Writing Surface, Unshielded, 10.5"H x 30"D
DR-101930-S
-
Unshielded drawers with writing surface are constructed of 20 ga. CRS and are furnished with ball bearing chassis slides to provide smooth operation. Available for 19" and 24" rackmount in 20", 24" and 30" depths, with or without a keylock
-
Product
Sapphire/SIC Wafer Flatness and Surface Appearance System
FM200
-
Sapphire/SIC wafer flatness and surface appearance system provide a previous surface flatness testing solution, though non-contract lighting testing to record the whole information of the surface, rapid and fast measurement for various of surfaces, line and all kinds of surface information.
-
Product
Surface Mount-to-DIP JEDEC SOT-25, SOT-23A-6 Adaptor
1110748
-
Surface Mount to DIP Adapter for SOT-25, SOT-23A-6. Allows for breadboarding or substitution of microgate SOT-23A-6 and SOT-25 IC and transistor packages into .100 [2.54] pitch proto boards or PC boards. Solder masked top-side pads allow user to hand solder devices directly to topside of adapter with fewer problems of solder bridging. Longer male bottom pins are available at special request for easy use of probe clips. Large topside pads allow for soldering test pins, jumpers, etc. to top of adapter.
-
Product
Horizontal Field of View Vehicle Camera System
ThermoVision SS
-
The SS camera is a vehicle camera system for driver's vision has a horizontal field of view (FOV) of 55 or 90 degrees. The SS system is based on an uncooled thermal camera to provide good situational awareness day and night.
-
-
Product
CableEye Generic Surface Mount & TH Board | Cable & Harness Tester
CB51
-
CAMI Research Inc. (Acton, MA) announces another new board for its CableEye cable and harness testing systems. Populated with solder pads to accept both aligned and staggered, 1.25mm and 1.5mm pitch, surface mount and through hole (TH) connectors, the board addresses any market with a demand for board-to-board connections. Rated to 700Vdc/500Vac, the CB51 may be used on all CableEye models.
-
Product
Large Surface Defect Gauge
4D InSpec® XL Surface Defect Gauge
-
The 4D InSpec XL Surface Defect Gauge expands 4D Technology’s 4D InSpec product line—they’re the first handheld, precision instruments for 3D non-contact surface defect measurement.
-
Product
12V/24V Jump Start System for Service Vehicles
Super-Boost-All
-
The Super Boost•All® is designed to be mounted on your service vehicle with 2 or 4 auxiliary jump starting batteries to start 12 or 24 volt vehicles. The auxiliary batteries are charged from the service vehicles electrical system through the internally mounted battery separator.
-
Product
19" Drawer with Writing Surface, Unshielded, 8.75"H x 20"D
DR-081920-S
-
Unshielded drawers with writing surface are constructed of 20 ga. CRS and are furnished with ball bearing chassis slides to provide smooth operation. Available for 19" and 24" rackmount in 20", 24" and 30" depths, with or without a keylock
-
Product
PCIe-8510, 2- or 4-Port, PCIe Vehicle Multi-Protocol Interface Device
785324-01
Interface
2- or 4-Port, PCIe Vehicle Multi-Protocol Interface Device—The PCIe‑8510 is a hardware-selectable controller area network (CAN) and/or local interconnect network (LIN) interface for developing applications with the NI‑XNET driver. The PCIe‑8510 excels in applications requiring real-time, high-speed manipulation of hundreds of CAN frames and signals, such as hardware‑in‑the‑loop simulation, rapid control prototyping, bus monitoring, automation control, and more. The NI‑XNET device-driven DMA engine enables the onboard processor to move CAN frames and signals between the interface and the user program without CPU interrupts, minimizing message latency and freeing host processor time for processing complex models and applications.
-
Product
Surface Resistivity Meter
395
-
The ACL 395 handheld meter features sophisticated circuitry that allows for the same advantages as megohmmeters, but at an economical price. Utilizing color-coded zones, the LED scale is easy to read and evaluate. Half decades indicate where the measurement value falls within the decade giving a closer indication to actual value. Unlike other pocket-sized meters, the ACL 395 features rubber rails which provide the best possible contact.
-
Product
19" Drawer with Writing Surface, Unshielded, 7"H x 24"D
DR-071924-S
-
Unshielded drawers with writing surface are constructed of 20 ga. CRS and are furnished with ball bearing chassis slides to provide smooth operation. Available for 19" and 24" rackmount in 20", 24" and 30" depths, with or without a keylock
-
Product
Surface Profile
-
Surface profile: The degree of profile on the surface affects a coating’s overall performance and determines aspects such as adhesion, coverage and overall volume of coatings used. If the profile is too large the amount of coating required increases, otherwise there is a danger that the peaks remain uncoated - allowing rust spots to occur. If the profile is too small there may be an insufficient key for adequate adhesion.
-
Product
Surface Probes
-
Eddyfi offers a variety of mechanical designs to suit your ECA surface inspection requirements, ensuring high-quality results.
-
Product
In-fuse Vehicle Current Measurement System
Sens-X
-
Sens-X intelligent sensors offer a range of high dynamic range sensor hardware for the capture of specialist current measurements.
-
Product
0.50° Accuracy Roll & Pitch Surface Dynamic Motion Sensor
DMS-550RP
-
The DMS range of motion sensors is designed specifically for the motion measurement needs of the marine industry. Whether it is achieving IHO standard survey from any size of vessel, or providing safety critical monitoring of offshore platforms, large vessels, helicopter landing decks, cranes and positioning systems, the DMS provides accurate motion measurement in all sea conditions. Incorporating an enhanced external velocity and heading aiding algorithm for improved accuracy during dynamic manoeuvres, the solid state angular rate sensors offer reliability in the highest performing vertical reference units ever produced by TSS.
-
Product
Surface Paint Quality Scanner
-
Konica Minolta Sensing Americas, Inc
There is always a challenge to achieve a consistent high quality surface on a car body during production. The goal of the manufactures is to reduce defects and, quickly and accurately fix the ones that occur.
-
Product
Surface Roughness Measuring Machines
-
Portable Surface Roughness Measurement instruments whose analysis function and operability are dramatically evolved
-
Product
Hybrid Vehicle Battery Simulator and Test System
-
Winner of the SAE 2008 Technical Award for Hybrid Vehicle Testing Technology, SAKOR Technologies Hybrid Vehicle Battery Simulator and Test System is designed for simulating high-voltage batteries in an electric drivetrain testing environment as well as directly testing high-voltage batteries and charging systems.
-
Product
3D Sensor (Shiny Surfaces)
reflectCONTROL
-
reflectCONTROL is designed specifically to meet the high quality requirements that ensure high quality for shiny surfaces. The system based on deflectometry projects a striped pattern onto the measurement object. Defects on the surface cause deviations from the striped pattern which are recorded by cameras and evaluated by software.
-
Product
Vehicle Emissions Laboratory
-
Trialon’s Vehicle Emissions state of the art testing facility is located in the heart of the Detroit Metro area. Our facility is equipped with the essential emissions equipment to simulate real driving conditions to meet the needs of national regulations. The test facility is staffed with talented technicians and engineers with over 50 year of combined experience.
-
Product
Electric Vehicle Service Equipment Test System
T4350
-
With the growing demand for electric vehicles (EV), there needs to be a simple and accurate method to test EV charging systems. Test the accuracy of AC and DC voltages and currents with TESCO’s Electric Vehicle Service Equipment (EVSE) Test System TS400. The TS400 is a valuable set with complete testing capabilities and caters to every possible EVSE charging protocol in the world (AC and DC). EV charging stations are popping up all over as the sale of electric vehicles increase. Many states or counties are now mandating testing for these charging stations. TESCO’s TS400 makes testing these chargers easy! TESCO’s EVSE Test Systems test the accuracy of energy delivery using a transactional mode compatible with Handbook 44 provisions. The TS400 Test System includes a T4000 EVSE Tester and a PL4000 EV Load Emulator. Reach out to your TESCO Representative for more information!
-
Product
Flood Modeling for River, Surface Water, and Urban Drainage Systems
Digital OneWater Flood Modeller
-
Flood Modeller, a Digital OneWater solution, is an industry-leading software platform which enables engineers and scientists to deliver faster and more accurate results by simplifying the modeling of river, surface water, and urban drainage systems. It enables you to confidently understand flood risk and develop optimal solutions to manage the impacts of climate change.
-
Product
Non-contact Surface Texture And Contour Measuring Instruments
-
From sub-nano level surface roughness to milli level profile with 3D.Tokyo Seimitsu provides non-contact type surface roughness and contour measuring instruments with the confidence born out of many years cultivating know-how of surface roughness measurements.
-
Product
Vehicle Electromagnetic Field Exposure Test System
SEM-400
-
Beijing KeHuan Century EMC Technology Co,.LTD
Vehicles are our daily public transportation. Electromagnetic pollution in vehicles has attracted more and more public attention. The newly revised compulsory standard GB27630-201X "Passenger Car Air Quality Evaluation Standard" intends to require the electromagnetic field in the car as one of the indicators, according to GB/T37130-2018 "Measurement method of vehicle electromagnetic field relative to human exposure" The measurement method is to measure the intensity of the magnetic field in the car. In the frequency range of 10Hz-400kHz, the electromagnetic field measurement result should meet the public limit requirements of GB8702-2014 for electromagnetic exposure.
-
Product
Skin Surface Probe
SST-2
-
The SST-2 skin surface temperature probe for humans, with convenient plastic handle. Probe re-useable and has a fast response time.
-
Product
Installation of Visual Inspection of the Inner Surface of Hollow Cylindrical Parts
-
Create an installation that allows visual inspection of the inner surface of hollow cylindrical parts with the ability to display the resulting image on a personal computer monitor with its subsequent saving in the JPEG format.
