Industry Pack Carrier
-
Product
Industrial 4 Gas Combustion Analyzer
K905
-
UEi Test & Measurement Instruments
Hand-held indusrial Combustion analyzer with Wireles communication option
-
Product
9U Rackmount, 19" SXGA Industrial Monitor With Resistive Touch Control, Direct VGA, And DVI Ports
FPM-3191G
Industrial Monitor
19" SXGA TFT LCD with LED backlightRobust design with stainless steel chassis and aluminum front panelAnti-glare screen with tempered glass and IP65-certified front panelLockable OSD control pad on rear coverSupports 24 VDC power inputSupports panel, wall, desktop, rack, or VESA arm mountingSupports 9U pre-drilled rackmount mounting holes
-
Product
10.4" SVGA/XGA Industrial Display Kit
IDK-1110
-
10.4" LCD supports 800 x 600 / 1024 x 768 pixels and wide operating temperature, 4-wire resistive / projected capacitive touch solution, LVDS signal interface.
-
Product
PCI Express FMC Carrier
RFM-BSC5GT7H1
-
Sundance Multiprocessor Technology Ltd.
The RFM-BSC5GT7H1 is a PCI Express short sized FMC carrier board with Cyclon V FPGA (Altera), which is designed mostly for low cost, high-performance data acquisition.
-
Product
Carrier with System Management
EnsembleSeries™ CCM3012
-
*PCIe Gen-3 interfaces to OpenVPX data plane*Advanced system management built-in (VITA 46.11)*Air, conduction, Air and Liquid Flow-By packages*Interoperable with other Ensemble OpenVPX processing modules*Fully MultiCore Plus® compatible
-
Product
Industrial Gas Detector
OLCT 60
-
Teledyne Gas & Flame Detection
The OLCT 60AD version allows the sensor to be installed remotely up to 15 meters (standard), allowing detection in inaccessible locations, or in Zone 0 in the case of the intrinsically safe (IS) version. The detector units are made of 316L stainless steel, and are rugged and resistant to corrosion. Pre-calibrated sensors can be disconnected by turning the head of the unit. These “smart” sensors can be calibrated outside hazardous areas.The OLCT 60 is equipped with non-intrusive access to a safe menu. In hazardous areas, calibration can be done with an operating mode in accordance with safety rules.
-
Product
Industrial Dew-Point Transmitters, Dew-Point Sensors and Trace Moisture Sampling Systems
-
Our range of dew-point sensors are easy to install and maintain.
-
Product
High Voltage Industrial Resistors
HVI
-
The HVI series of high voltage industrial resistors feature zero inductance, an excellent range of tolerances, wide resistance values and unparalleled high voltage handling.
-
Product
Qseven V1.2 SoM Evaluation Kit With I.MX287 454 MHz (Industrial) SoC, 128MB Memory, 4GB EMMC, Gigabit Ethernet, Audio, CAN And BSP
Q7M100-100-EVK
-
*Ultra low power consumption ARM9*High flexibility Qseven v1.2 compliant design*5 UART*2 CAN*24-bit TTL LCD*10/100 Mbps Ethernet*Linux 2.6.35
-
Product
2450 MHz Industrial Microwave Generators
-
Alter® 2450 MHz Industrial Microwave Generators are built on MKS Alter® Product experience and designed with rugged and reliable switch mode power supplies for demanding industrial applications. They offer compact generators up to 3kW in a 19 inch standard rack with a remote head and integrated isolator.
-
Product
Industrial Flash & Memory Solutions
-
Advantech provides a full range of industrial storage module, memory module, and embedded I/O module.
-
Product
Industrial Mini-ITX Motherboard With Intel® N97 Processor
AmITX-ALN
Motherboard
- Intel Alder Lake N SoC processors, N97- Single channel DDR4 3200 MHz memory up to 32 GB- Triple independent display: HDMI 2.0b, DP 1.4a (from Type C), VGA, LVDS or eDP- Dual GbE ports: 2x 2.5GbE- Expansion slots: 1x PCIe Gen3 x1, 1x USB 3.2 Gen2 Type C, 4x USB 3.2 Gen1, 6x USB 2.0, 1x M.2 B-key, 1x M.2 E-key, 1x M.2 M-key- 12 to 28V DC-in
-
Product
PC/104 OneBank Carrier
EMC²-SoM
-
Sundance Multiprocessor Technology Ltd.
The EMC²-SoM is a PCIe/104 OneBank™ Carrier for a Trenz compatible FPGA and SoC Module and has expansion for a VITA57.1 FMC™ LPC I/O board. It also has I/O pins, using a 100-way Samtec RazorBeam connectors system, the “Sundance Expansion Interface Connector” (SEIC) can be customize for individual applications and bespoke connectors.
-
Product
Ultra Compact Industrial Computers, mini PCIe socket for WIFI / 4G module
Neousys NRU
-
Ultra-compact industrial computers based on NVIDIA® Jetson AGX Xavier ™ for mobile use (in transport, in surveillance systems, in industrial systems).- NVIDIA® Jetson AGX Xavier ™ SOM with JetPack 4.4- IEEE 802.3at Gigabit PoE + or 0GBASE-T 10G ports - M.2 2280 M key socket for NVMe SSD- mini PCIe socket for WIFI / 4G module - GPS PPS input
-
Product
19" SXGA Industrial Monitors With Resistive Touch Control, Direct HDMI, DP, And VGA Ports
FPM-719
-
19" SXGA TFT LED LCD with 70,000 backlight lifetimeDirect HDMI, DP and VGA input interfacesAnti-glare screen with tempered glassRobust system with Die-casting aluminum chassis and IP66-rated aluminum alloy front bezelLockable I/O connectorsSlim design enables easy installationOSD control buttons with 2 user-defined contrast/brightness controlsCombo RS-232 & USB interface for touchscreen functionalitySupports various mount options: panel, wall, desktop, rack or VESA arm mounting
-
Product
Industrial PoE and Gigabit Ethernet Switch
GL900
-
The GL900 is a manageable Gigabit Ethernet Switch with 9-port x 1000BASE-T (4 x PoE+), AVB/TSN Protocol Stack.
-
Product
PCIe Color Industrial Camera
CMOSIS CMV4000
-
2K camera Applications: In-situ optical inspection camera, fast process capturing, e.g. Golf club swings, Intelligent Transportation Systems (ITS), Open road tolling and Traffic monitoring, Industrial Automation, Machine Vision, Facial Recognition, Motion Capture, Automotive crash testing, OCR/ OCV, 3D scanning, Robotic Arms, Material and Life science Microscopy, Ophthalmology and Retinal imaging, Medical Imaging, Flat panel inspection, Dental, Kiosks, Security, Biometrics
-
Product
PCIe Carrier Board for SOM3
Solar Express 215 (SE215)
-
Sundance Multiprocessor Technology Ltd.
SE215 is a development board for Sundance SOM3 . It is a PCIe X1 Gen2 carrier card with one site for an SOM3. It offers USB JTAG and UART, through a micro USB connector, Display port and comes with a version of Display port IP core for SOM3 from Bitec DSP. The card provides Power GOOD and user LEDs for rapid debugging.
-
Product
PMC Carrier PCIe x1
-
Looking for a way to plug your PMC mezzanine card into a computing platform with a 1-lane PCIe slot?Well, the CC_PCIeG1x1_to_PMC is your answer! It is effective, field tested and compliant with all applicable standards.
-
Product
QuickLink Solder-In Starter Pack for use with Dx10 Amplifier
Dx10-QL-3SI
-
- Choice of 4 GHz or 6 GHz bandwidth models- Up to 5 Vpk-pk dynamic range with low noise- ±3 V offset range- Low loading and high impedance for minimal signal disturbance- Ideal for DDR2, DDR3, LPDDR2- Deluxe soft carrying case- Innovative QuickLink architecture- Wide variety of tips and leads-- Solder-In Lead-- Optional Positioner (Browser) Tip-- Quick Connect Lead-- Square Pin Lead-- HiTemp Solder-In Lead
-
Product
SparkFun MicroMod GNSS Carrier Board (ZED-F9P)
-
With GNSS you are able to know where you are, where you're going, and how to get there anywhere on Earth within 30 seconds. This means the higher the accuracy the better! GNSS Real Time Kinematics (RTK) has mastered dialing in the accuracy of their GNSS modules to just millimeters, and that's why we had to put it on this board! With the flexibility of the MicroMod's M.2 connector, you can easily test and swap out different MicroMod processor boards for your application. Simply match up the key on your board's beveled edge connector to the key on the M.2 connector and secure the boards with a screw. This means solderless access to the ZED-F9P modules features via UART1, UART2, SPI, and I2C ports!
-
Product
Qseven V2.0 SoM Evaluation Kit With Quad/DualLite 800 MHz (Industrial) SoC, 1GB Memory, 4GB EMMC, Gigabit Ethernet, Audio And CAN
Q7M120-120-EVK
-
*Ultra low power consumption Cortex™-A9*High flexibility Qseven v2.0 compliant design*2 CAN 2.0B*18/24-bit TTL LCD*LVDS/HDMI 1080P*10/100/1000 Mbps Ethernet*Linux3.0.35/Android4.3*Audio
-
Product
Industrial Ovens
-
Large, heated chambers for manufacturing processes like drying, curing, baking, and heat-treating materials or products.
-
Product
Interface for the Multimode, multiprotocol Excalibur 8000 Family of Carrier Boards, Providing a Complete Solution for Developing & Testing MIL-STD-1760 Interfaces
M8K1760Px(S)
-
The M8K1760Px(S) interface module for the multimode, multiprotocol, Excalibur 8000 family of carrier boards provide a complete solution for developing and testing MIL-STD-1760 interfaces and performing system simulation of the MIL-STD-1760 bus. The module handles all standard variations of the MIL-STD-1760 protocol.Each M8K1553Px-1760 multi function module contains 64K bytes of dual-port RAM for Data blocks, Control registers, and Look-up Tables. All Data blocks and Control registers are memory mapped, and may be accessed in real time. Each of the independent dual redundant M8K1760Px modules may be programmed to operate in one of three modes of operation: Remote Terminal, Bus Controller/Concurrent-RT, and Bus Monitor. In addition, modules 1 and 3 can be programmed to operate as Concurrent monitors, to modules 0 and 2 respectively.In addition, Checksum, SRQ bit and Header Words are supported on each channel, as well as, error injection (BC and RT modes) and error detection (all modes).Each M8K1760PxS single function module operates either as a Bus Controller, Remote Terminal, or Bus Monitor.The M8K1760Px(S) comes complete with Windows software, a C-driver software library including source code and may be used with Exalt, Excalibur’s Analysis and Laboratory Tools, a Windows monitoring application
-
Product
Industrial Shock Absorbers
-
ACE industrial shock absorbers work hard. Their application means moving loads are evenly decelerated over the full stroke. The result: the lowest braking force and shortest braking time. The MAGNUM series from ACE is viewed as the reference standard for medium-sized damping technology.
-
Product
Industrial Ethernet Switches
-
Rugged network devices built to operate reliably in harsh factory environments (extreme temps, shock, vibration) by connecting machinery like sensors, cameras, and PLCs, providing robust, high-speed data transfer.
-
Product
15" XGA Industrial Monitor With Resistive Touchscreen And VGA / HDMI Port
FPM-1150G
-
15" XGA TFT LED LCD with 70,000 backlight life timeRobust design with aluminum front panelSupports VGA or HDMI interface with USB touchscreenSupports panel, wall, desktop, or VESA arm mountingLockable HDMI port (optional)
-
Product
PCB IMIC01, 100 mV/g, 2-Pin, Accelerometer, Industrial Vibration Sensor
780985-01
-
The PCB IMIC01 is an industrial Vibration Sensor designed for permanent installations. This sensor helps you acquire sound and movement data with supported PXI Sound and Vibration Modules, C Series Sound and Vibration Input Modules, and USB-based Sound and Vibration Devices. The PCB IMIC01 features a sensitivity range of 100 mV/g and uses the Integrated Electronics Piezo-Electric (IEPE) current excitation. The sensor supports the IMI Industrial Accelerometer Cable as well as the MIL2M-Breakout Cable.
-
Product
Sensors For Automotive & Industrial Applications
-
Panasonic Industrial Devices Sales Company of America
Panasonic is a leading supplier of specialty Sensor technologies offering a wide array of Sensor types including the Grid-EYE® Infrared Array Sensor, Gas Flow, Particulate Matter, Acceleration, Angular, PIR Motion, Pressure, Temperature and the newest sensing technologies including the highly accurate and flexible 6in1 Sensor and the Ultrasonic Gas Flow Sensor.
-
Product
Industrial Grade SODIMM DDR5 4800/5600
SQR-SD5I
-
Data Transfer Rate: 4800/5600 MT/s, Capacity : 8GB/16GB/32GB. Original Samsung/Hynix IC adopted, Independent Power Management IC build-in.
