Near Field Communications
a set of protocols enabling <10 cm contactless communicaiton. Also known as: NFC
See Also: Communication Protocol, Modbus, Data Communications, NFC
-
Product
Field Measurement Sensors
-
High frequencyElectromagnetic field measurement sensorsLow a frequencyElectric field measurement sensorsMagnetic field measurement sensors
-
Product
Magnetic Field Meters
-
A scientific instrument used to measure the strength and direction of a magnetic field.
-
Product
Near Field Probes 30 MHz up to 3 GHz
RF2 set
-
The RF2 near field probe set consists of 4 passive near field probes for measurements in the development phase of the magnetic field in the range from 30 MHz to 3 GHz on electronic assemblies. The probe heads of the RF2 set allow the step by step localization of interference sources of the RF magnetic field on assemblies. From greater distances the electromagnetic interference can be detected by RF-R 400-1 and RF-R 50-1 probes. The RF-B 3-2 and RF-U 5-2 probes with their higher resolution can more precisely detect the interference sources. Field orientation and field distribution on an electronic assembly can be detected through a trained special use of the near field probe. The near field probes are small and handy. They have a sheath current attenuation and are electrically shielded. They can be connected to a spectrum analyzer or an oscilloscope with a 50 Ω input. They do not have an internal terminating resistance.
-
Product
C012 Communication Board
MS 1728/29
-
- Suitable for standard desktops- Four channel in single board- Up to 10 Mbits/sec operating speed- Low Cost solution- Standard INMOS link protocol- Communicates with transputers- Converts between serial link and parallel bus- Tristate bidirectional bus interface- Memory mapped registers- Interrupt capability- TTL compatibility
-
-
Product
Internal Communications Platform
Messenger
-
Using Messenger from Trilogy, you can build a cost effective intercom solution without the installation, operational and future expansion constraints of more traditional 2 and 4 wire systems. From the factory configured Base System, Messenger evolves to suit the emerging communication needs of your organisation.
-
Product
Ethernet Communications
-
Campbell Scientific offers complete Ethernet connectivity solutions for our data acquisition needs. Data loggers are available with integrated Ethernet, as well as stand-alone Ethernet modules.
-
Product
Field Installable Connectors
-
Factory terminated and polished to make fiber terminations fast, easy and reliable.
-
Product
Optical Communication Analysis
-
In lab and manufacturing environments, R&D engineers require scalable and optimized test solutions to enable them to properly characterize new advanced modulation scheme signals for next-generation, ultra-high-speed telecom networks. Through EXFO’s optical communication analyzers, R&D engineers and manufacturing operations involved in the development or production of transmitters or systems based on new high-speed technology will find the right tools for their advanced technology needs.
-
Product
WiFi Communication Module
WiFi-201
-
The WiFi module is without doubts one of the most advanced and innovating elements of NeuLog. Measurements with NeuLog sensors can be performed through any device which uses the Wi-Fi technology, such as iPads and Tablets with Android, PC computers with Windows / Linux or Macintosh with OS. These can all communicate with the Wi-Fi adaptor to begin a unique experience of data acquisition.
-
Product
Field Triage System™
-
Developed with our customer’s Remote Customer Quality Engineers, who support their customers with rapid in-field failure analysis.
-
Product
Field Testing Services
-
Power Monitoring and Diagnostic Technology Ltd.
PMDT offers three levels of testing services both domestically in the US and globally. With the best quality products, complete PD solutions, rich on-site testing experience, experienced partial discharge experts and field engineers, PMDT also provides PDExpert Services -- professional on-site partial discharge detection and location services to help the customers find the potential risks, evaluate the operating status of the electrical assets, and deliver complete and final problem solutions.
-
Product
Field Strength Meter
DIGI-FIELD
-
Measuring radio frequency and microwave radiation has never been easier! This unit covers the amazing range of DC - 12 GHz and will give you digital readout of the relative field strength of broadcast signals such as cellular phone, microwave oven leakage, TV station, CB radios using the (1MHz - 1GHz) telescoping antenna provided.
-
Product
Infrared, Near Infrared & Raman Spectroscopy
-
Our selection of near, mid and far infrared and Raman spectrometers is unrivalled across the industry. Our portfolio includes compact, portable routine as well as powerful research spectrometers. Our solutions cover the entire spectral range from near infrared, mid infrared, far infrared to THz applications.
-
Product
Communication Protocol Test Harness
-
Simulate Master or Outstation Devices.Monitor Communications.Create Custom Functional Tests with any .NET programming language, Python, or Tcl/Tk scripts.Exercise a device as it will be used on the utility SCADA network.Automatically Perform Conformance Test Procedures.
-
Product
Magnetic Field Scanner
-
MAGNET-PHYSIK Dr. Steingroever GmbH
Magnetic field scanners measure the magnetic field around permanent magnets or magnetic systems. The results can be output as a colored 2D, 3D representation or as a table.
-
Product
Field Balancing Software
DS-0227A
-
The trouble of rotation machinery is caused most frequently by unbalanced phenomenon of rotating shaft. However, balancing correction on-site is not easy because the conventional vector calculation method with drawing needs quite some time.
-
Product
Near Zero Footprint SMT Spring Pin Sockets
-
Ironwood Electronics socket is a device size or near device size footprint test socket incorporating industry standard high performance spring pins. Ironwood can design a socket to work with any type IC packages- BGA, LGA, QFN, DFN and even leaded devices where you need to fit a socket in place of your device to allow fast, easy testing and development.
-
Product
Field Ttesters
-
Our product range comprises from small handheld, battery fed testers to full featured service performance assurance tools and distributed monitoring systems. We have several product lines including:QoS / SLA verification system Ethernet, IP, Critical Data, VoIP, IPTV .Hand-held testers: Gigabit Ethernet, Synchronous Ethernet, E1, PDH, SDH, Ethernet, IP, Jitter, Wander, Datacom, Frame Relay, etc.
-
Product
Sample Conditioning Communications Interface
Pilot Pro Series
-
Parker's Pilot Pro™ package has been designed with a high level of flexibility to accommodate multiple configurations of local area communications networks.
-
Product
Magnetic Field Visualization
cmos-magview
-
The devices of the cmos-magview family are high-resolution and precise measuring and visualization systems for magnetic materials, assemblies and surfaces. Pole distances or other geometric information can be measured down to the µm range.
-
Product
4 Digit Field Indicator
CFIA-40 4
-
1. Using LED to display, and able to be used in dark environment2. No external power needed3. Able to display measured value like pressure , temperature and depth etc4. Display solution 1/99995. Isolated alarm open drain output6. Voltage drop will below 4 volt
-
Product
Field Sensor
TR_B
-
The terraTEM TR_B Field surface sensor has been fully integrated to work seamlessly with the terraTEM. Recording three components of the Earth’s magnetic field simultaneously, the TR_B Field sensor comes with solid state rotation elements to be used in conjunction with the terraTEM inbuilt rotation software. The sensor also has automatic nulling of the ambient B-field.
-
Product
cPCI Communication Module
DP-OBC-1011
-
DP-OBC-1011 is the latest rugged 3U cPCI based I/O module that offers generic communication I/Os required for on-board applications.
-
Product
Aeronautical Communications
-
Aeronautical communications systems must be reliable and efficient. Morcom is a leading supplier of communications systems for civil and military users. From long-haul SELCAL radio HF-SSB systems, to ATC radios for VHF and UHF communications we have supplied several military and civilian aviation users around the world with very effective and state-of-the art solutions.
-
Product
Field Meter
EFM-022
-
Accurate measurement of electrostatic charges with automatic distance conversion (among 5 preset distances).
-
Product
Broadband Wireless Communications
-
Rapid technological and regulatory advancements have made wireless broadband connectivity available at any time and anywhere. Morcom's approach to technology and equipment vendors allows us to provide the right solutions for each client.Morcom specializes in private LTE Networks, turn-key CBRS solutions, indoor and outdoor Wi-Fi coverage, point-to-point (PTP) and point-to-multipoint (PTMP) microwave links. We take pride in our capability to provide customized solutions for each client.
-
Product
Wideband Radio Communication Tester
CMW500
-
The R&S®CMW500 wideband radio communication tester is the universal test platform for RF integration and protocol development. It is available as the R&S®CMW500 callbox and the R&S®CMW500 protocol tester. The R&S®CMW500 includes a fully integrated end-to-end data solution that permits comprehensive IP throughput and quality measurements. Thanks to the internal fading simulator, it is easy to perform tests under realistic propagation conditions.
-
Product
Wireless Communication Sensor Platform
-
Delivering on both form and function, the wireless communication sensor product platform includes a battery-powered wireless sensor endpoint for easy installation, a sensor and communication board for easy integration, and a development kit for application specific customization.
-
Product
LTE RF Communication Subsystem
-
The Delaire USA LTE RF Communication Subsystem is designed to provide a versatile solution for the testing needs of the next generation wireless systems. With the LTE test subsystem developers can build an end-to-end test environment for complete system operation. From end user equipment and eNodeB base stations to full system functionality, the LTE RF Communication subsystem allows developers to test and evaluate equipment and system performance in a controlled laboratory environment.
