Industrial Ethernet
ruggedized network for a plant environment.
-
Product
9th Gen Intel® Xeon®, Core™ i7/i3 and 8th Gen Intel® Core™ i5 Processor-Based Embedded Fanless Computer
MXE-5600 Series
Industrial Computer
- 9th Gen Intel® Xeon®, Core™ i7/i3 and 8th Gen Intel® Core™ i5 BGA processor and Mobile Intel® CM246 Chipset- Dual SODIMMs for up to 32GB DDR4 non-ECC/ ECC memory- Rich I/O: 2x DP++, HDMI, 2x GbE, 6x COM, 8-ch DI, 8-ch DO, TPM2.0- 2x USB 3.1 Gen2, 2x USB 3.1 Gen1. 4x USB 2.0- Rich storage: 2x 2.5" SATA 6 Gb/s, CFast, M.2 2280
-
Product
Plus Radio Ethernet Receiver
ACSRF-4040
-
The Plus Radio Ethernet receiver is required as part of the Tinytag Radio Data Logging System. It controls the transmission of data to and from the radio loggers: data received from the loggers is then sent to the computer for viewing with Tinytag Explorer radio software. If power to the computer running the system is lost, the receiver has a battery back-up which will maintain the mesh network until power is restored. This receiver plugs directly into a LAN removing the need for a computer in the area where monitoring is to take place. The receiver is powered using a plug-in Power over Ethernet adaptor (ACS-0041) which is supplied with the unit.
-
Product
Gigabit Ethernet XMC module
IC-GIGA-XMCb
-
The IC-GIGA-XMCb is an XMC module providing up to four 10/100/1000 Ethernet channels.
-
Product
Handheld Infrared Industrial Thermometers
-
These handheld infrared industrial thermometers are used for non-contact temperature measurement when many locations need to be measured or in areas where a fixed infrared sensor can't be installed.
-
Product
Cable Assy, Ethernet, Type E, Crossover, 8POS, CAT5, 1m
187375-01
Cable Assembly
8-Pin, Male Ethernet to 8-Pin, Male Ethernet, CAT-5E Crossover Ethernet Cable - The 8M-8M Crossover Cable directly connects two devices together, without the need for a router in the middle. The cable is available in different lengths.
-
Product
6U CompactPCI Rear Transition Module with Intel® Ethernet Controller I350-AM2
cPCI-R6100 Series
Controller
- Intel® Ethernet Controller I350-AM2- Up to four Ethernet GbE ports- Dual display, DVI and VGA- CompactFlash and SD card slots for onboard storage
-
Product
Ethernet Parallel Interface
Model 8003
-
* Provides 40 high-power TTL I/O lines.* Fully VXI-11 Compliant plus Raw Socket for easy programming with Visual Basic or C, Agilent VEE and LabVIEW.* Standard board has vertical Ethernet and Digital IO connector on the component side. * Optional Relay Driver board adds 4, 32 or 40 Relay Drivers. • Apply regulated 5 Vdc power through the Digital IO connector.
-
Product
GPIB to Ethernet to Instrument Interface
Model 4865B
-
* Adds a GPIB Interface to Instruments with a VXI-11 or Raw Socket Ethernet Interface.* Transparent data transfer handles ASCII and binary data.* Controllable with any IEEE-488.2 GPIB Controller* VXI-11 protocol supports control, abort and reverse channels.* Raw Socket protocol includes substitute command strings for GPIB Device Trigger, Device Clear and Interface Clear.* Auto-Find feature simplifies instrument linkage* Reuses existing test software with new Ethernet instruments.* Easy configuration with the 4865B's internal webserver.* Drop in replacement for the original Model 4865 with 2x to 5x speed increase.* 1 U high rack mount kit mounts one or two 4865Bs.* Includes universal 115/230 VAC Power Adapter.
-
Product
SONET / SDH, OTN, Ethernet and multiservice testers
-
At the core of EXFO’s expertise are next-gen SONET / SDH, OTN, Ethernet and multiservice testers that are designed to take testing to the next level. These instruments address the needs of field technicians seeking ultimate portability and ease-of-use, as well as network managers and systems vendors who require flexible and scalable, future-proof solutions.
-
Product
Ethernet Switch Module
VPX3-655
-
Curtiss-Wright Defense Solutions
The Curtiss-Wright VPX3-655 is a very versatile Ethernet switch supporting 1G, 10G and 40G ports, including 12x 10GBASE-T ports, providing high-speed connectivity for modular embedded computing applications.
-
Product
3U CompactPCI Serial 4-slot SSR w/o RTM w/ Ethernet
1CPCIS-304-R200
-
3U CompactPCI Serial Backplane with 4 CompactPCI S.0 slots, system slot right, without rear IO : 1x CompactPCI S.0 CPU slot, 3x CompactPCI S.0 peripheral slots, without connectors for RTMs (RearTransition Modules), Ethernet full mesh.
-
Product
Time-Triggered Ethernet / ARINC 664 Part 7 (AFDX®) / IEEE 802.3 Ethernet Deterministic Communications
TE2
-
Module TE2 is one of NAI's latest generation of advanced function Configurable Open Systems Architecture™ (COSA®) compatible modules. The TE2 is a certifiable, single-port, tri-redundant, deterministic Ethernet communications interface module that supports TTTech’s certifiable TTEthernet® End System product consisting of three traffic classes: SAE AS6802 (Time-Triggered Ethernet), ARINC 664 Part 7 (Avionics Full-Duplex Switched Ethernet (AFDX®), and/or IEEE 802.3 best-effort protocol. By supporting all three traffic classes, NAI's TE2 is the ideal solution for current users of IEEE 802.3 Ethernet, who plan to upgrade to Deterministic Ethernet (ARINC 664 Part 7 (AFDX®) or Time-Triggered Ethernet SAE AS6802) protocols in the future at any time without changing hardware.
-
Product
PXIe 10GBase-T1 Ethernet MEMS Fault Insertion Switch, 8 Channel
42-205-008
Fault Insertion Unit
The 42-205-008 (PXIe) is an 8-channel fault insertion switch designed to simulate common faults on high speed two wire communication interfaces such as xBaseT1 Ethernet. It is available with 4 or 8 channels of two wire serial connections and can be used for simulating faults on 10BaseT1, 100BaseT1, 1000BaseT1 and 10GBaseT1 Ethernet interfaces. Any wire can be set as open circuit and shorts can be applied across wire pairs. Fault connections can be made to one of four external signals via two fault buses, typically simulating connections to supply voltage or ground.
-
Product
Industrial Ovens
-
Curing, drying, ageing, annealing or any heat processing tests at higher temperatures Envisys has the oven to meet your needs Whether it is a standard conventional drying application using shelves or conveyor drying or drying through infrared bulbs Envisys provides all types of drying solutions with custom configured designs and sizes.
-
Product
Ethernet Gateway for Woodward Easygen Genset Controls and LS-5 And DTSC-200 Controls
ESENET
-
ESENET is an Ethernet gateway specifically designed to interfaceWoodward's Easygen series genset controls with Modbus/TCP networks. It interfaces via the load sharing CAN bus with the Woodward controls.
-
Product
Interface Card - 1-2 Channels of MIL-STD-1553 Networks on a PMC Form Factor with Ethernet Backplane Interface
PMCE-1553
Interface Card
PMCE-1553™ is an innovative product that provides 1553 operations via 10/100/1000 Ethernet IP/UDP local area networks (LAN) backplane. PMCE-1553 is a standard PMC form factor card, but instead of PCI backplane, PMCE-1553 uses the P4 connector for Ethernet based control and communications.
-
Product
Industrial AC and DC Systems
-
Meet your specific industrial power requirements using our configured or custom-made industrial-grade products.
-
Product
Gigabit Ethernet PCI Express Mini Card
mPCIe-LAN-GbE
-
The mPCIe-LAN-GbE is a type F1 PCI Express Mini Card (mPCIe) optimized for use in mobile and rugged environments, with latching connectors and protection on all signals. The onboard magnetics feature robust built in isolation via transformer coupling. In addition, extended operating temperature and RoHS compliance are standard.
-
Product
Power Over Ethernet For Commercial Solutions
-
Powerful Network Solutions for Commercial Applications
-
Product
PDA Software Simplifies Ethernet Powered Device Testing
-
All PDA-600 Powered Device Analyzers come with productivity software including the PDA Interactive graphical user interface and the PowerShell PDA script automation development environment. Also included is an Windows binary API library to provide programming extensions to a variety of programming languages.
-
Product
Industrial Logging Pocket Dosemeter
Castle GA257L
-
The SONUS Pocket Dosemeters are designed to be powerful and easy to use. These dosemeters are small and tough so measurements and data can be collected throughout the working period. Data can be reviewed on screen or downloaded to a PC for further analysis.
-
Product
cDAQ-9188 , 8‑Slot, Ethernet CompactDAQ Chassis
782824-01
Chassis
8‑Slot, Ethernet CompactDAQ Chassis - The cDAQ‑9188 is a CompactDAQ Ethernet chassis designed for small, distributed sensor measurement systems. The chassis controls the timing, synchronization, and data transfer between C Series I/O modules and an external host. You can use this … chassis with a combination of C Series I/O modules to create a mix of analog I/O, digital I/O, and counter/timer measurements. The chassis also has four 32‑bit general‑purpose counters/timers. You can access these counters through an installed, hardware‑timed digital C Series module for applications that involve quadrature encoders, PWM, event counting, pulse train generation, and period or frequency measurement.
-
Product
Intelligent CPCI Quad Industry Pack Carrier
CPCI-6713-4 IP
-
The board consists of private SDRAM and Flash memory attached to the 300 MHz TMS320C6713B DSP. An FPGA provides the timing and control. Peripherals include a serial port and connectors for IP mezzanine boards. Flash memory is availablefor downloading programs into a non-volatile memory. A PCIbus connector provides the interface to the host computer. A serial port is available for debugging.
-
Product
PXI-8231, 1-Port Gigabit PXI Ethernet Interface Module
781752-01
Interface
1-Port Gigabit PXI Ethernet Interface Module—The PXI‑8231 provides a Gigabit Ethernet interface with up to 1000 Mbit/s transfers. With 1000 Mbit/s Gigabit Ethernet, you achieve a substantial performance increase over 100 Mb/s Fast Ethernet while remaining completely compatible with 10BASE‑T and 100BASE‑TX Fast Ethernet networks. The PXI‑8231 also features automatic cable polarity detection.
-
Product
MTM-EtherStem: Ethernet Microcontroller Module
-
SIMPLIFY INTERFACING: The MTM-Ether-Stem allows communication between host-based applications and any MTM module on the BrainStem bus. Designed for test direction, control, data collection, or loading reflex programs.
-
Product
Industrial Plug-in Power Relays
-
The unique D-series power relay concept and the miniature C-series relays are specifically designed for heavy-duty applications, power-utilities, petrochemical industries, and mining. High DC breaking capacity and inductive load switching offer long electrical life and low life-cycle costs. The Solve-All™ relay application concept offers ultimate flexibility to design and supply tailor made D-series power relay products. Today the D-series power relays are used in its millions across the world.
-
Product
2.5” SATA3 (USB 3) RunCore Industrial “Glory Series”
-
RunCore Innovation Technology Co. Ltd.
2.5” SATA3 with USB3 SSD is designed with outstanding performance and a high level of reliability for a wide range of applications: enterprise server, workstation system, online storage, notebook, and desktop.
-
Product
Phase Angle Voltmeter, Industry Standard
2250A
Phase Angle Voltmeter
NAI's 2250A Phase Angle Voltmeter is the most accurate and versatile AC measurement tool in the Synchro/Resolver and LVDT/RVDT marketplace. Considered the industry standard and based on the latest DSP and FPGA technologies, the 2250A substantially extends and simplifies the capabilities of the legacy 2250 model.
-
Product
EN 50155 Ethernet Switch
-
Axiomtek's EN 50155 certified Ethernet switches (TEN series) are designed for rail and metro systems. The TEN series is designed with IP54 enclosure and M12 connectors for protection against dust and water and supports an extended operating temperature range from -40°C to 75°C.
-
Product
Gigabit Ethernet Tester Module for 1G and 10G Packet
GAO-ENET-103
-
GAOTek Gigabit Ethernet Tester Module for 1G and 10G Packet is designed for installation and maintenance of Metro/Carrier Ethernet and IP services. It supplies a compact test solution for 1G and 10G packet Ethernet, including ITU-T Y.1564 standard for SLA and OAM test features.
