RF-LAMBDA Inc.
A manufacturer of radio frequency (RF) and microwave components, systems, and amplifiers.
- (888) 976-8880
(972) 767-5998 - sales@rflambda.com
- 4300 Marsh Ridge Rd
STE 110
Carrollton, TX 75010
United States of America
Categories
-
product
Antenna
RF Lambda’s standard horn antennas come in a variety of frequency ranges. Various beam widths and gain can be used to configure any system. Radomes and waterproof connector options available upon request.
-
-
product
Voltage Control Attenuator
Voltage variable attenuator offering infinite attenuation precision and broadband performance
-
product
Digital Step Phase Shifter
RF Lambda’s digital step phase shifters are designed to actively change the phase of an RF signal using digital TTL control signals. They are available in a variety of frequencies, phase shift ranges, and step sizes. Hermetically sealed options are available upon request.
-
product
Signal Generator Synthesizer
A versatile and precise instrument used in the testing, design, and maintenance of radio frequency equipment and systems. It is capable of generating continuous wave (CW) signals at a set frequency.
-
product
RF Coaxial Load
RF Lambda’s coaxial loads are used to terminate RF signal chain to provide a good 50ohm match and dissipate any excess RF energy. They are available in a variety of power levels and offer low VSWR.
-
product
DC Block
DC block offering broadband performance used to protect equipement and components from DC voltages
-
product
Mixer
RF Lambda’s wide band mixers are used for frequency conversion. Both active and passive versions are available with high IP3 and low conversion loss. Hermetically sealed options are available upon request.
-
product
Multiplexer
RF Lambda’s multiplexer line is used to combine multiple frequencies or signals from different systems on to a common antenna. They offer high isolation and low insertion loss and come in a variety of different frequencies. Hermetically sealed options are available upon request.
-
product
Waveguide Duplexer
Waveguide Duplexers supporting commercial communication to combine transmit and receive on to one antenna
-
-
product
Manual Attenuator (Coaxial)
RF Lambda’s manual coaxial attenuators are used to control signal levels using a manual control knob or buttons. These are highly reliable and commonly used in test setups where the operator needs access to tune RF signals without the need for any digital or voltage control.
-
product
Flexible Waveguide
Flexible waveguide sections to connect waveguide comopoents and enable different mechancial placements
-
product
TX / RX Module
RF Lambda’s TX /RX modules include both a block upconverter and downconverter. They can include front end amplifiers for lower noise figure or power amplifiers for high output power of signal conditioning and image rejection as required.
-
product
Duplexer
RF Lambda’s duplexers are used to combine two frequencies or signals from different systems on to a common antenna. They offer high isolation and low insertion loss and come in a variety of different frequencies. Hermetically sealed options are available upon request.
